Instruction/ maintenance manual of the product 1030S Patton electronic
Go to page of 9
USER MANUAL MODEL 1030 and 1030S Synchronous, Carrier Controlled Short Range Modem SALES OFFICE (301) 975-1000 TECHNICAL SUPPORT (301) 975-1007 http://www .
1.0 W ARRANTY INFORMA TION Patton Electronics warrants all Model 1030 components to be free from defects, and will—at our option—repair or replace the product should it fail within one year from the first date of shipment.
2.0 GENERAL INFORMA TION Thank you for your purchase of this Patton Electronics product. This product has been thoroughly inspected and tested and is warranted for One Y ear parts and labor .
3.2 SWITCH SETTINGS All possible settings for the Model 1030’s configuration switches are presented in the summary table and descriptions below . If you have additional questions regarding configuration, contact Patton T echnical Support at (301) 975-1007.
When connecting two Model 1030s, it is necessary to use a “crossover” cable. The diagram below shows how a crossover cable should be constructed for an environment where both Model 1030s use a 6-wire RJ-1 1 connector . Similar logic should be followed when using RJ-45 connectors or a combination of the two.
1. Open the unit by gently inserting a screwdriver between the DB-25 connector and the lip of the plastic case (see below). Y ou don’t have to worry about breaking the plastic, but be careful not to bend the D-sub connector . Once the unit has been opened, you will be able to see the terminal blocks located at the rear of the PC board.
8. Place the 2 halves of the strain relief assembly on either side of the telephone wire and press together very lightly . Slide the assembly so that it is about 2 inches from the terminal posts and press together firmly . If your cable diameter is too small or too large for our strain relief, please contact our technical support.
4.2.2 CONNECTION TO A “DCE” DEVICE Since the Model 1030 is wired as a DCE, you cannot connect it directly to another DCE such as a modem, multiplexer or printer . If you need to connect the Model 1030 to another DCE device, you must use a null modem cable wired according to diagram below .
APPENDIX B P A TTON MODEL 1030/1030S RS-232 PIN CONFIGURA TIONS Copyright © 1998 Patton Electronics Company All Rights Reserved 1- (FG) Frame Ground 2- (TD) T ransmit Data T o Model 1030 3- (RD) Rece.
An important point after buying a device Patton electronic 1030S (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Patton electronic 1030S yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Patton electronic 1030S - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Patton electronic 1030S you will learn all the available features of the product, as well as information on its operation. The information that you get Patton electronic 1030S will certainly help you make a decision on the purchase.
If you already are a holder of Patton electronic 1030S, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Patton electronic 1030S.
However, one of the most important roles played by the user manual is to help in solving problems with Patton electronic 1030S. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Patton electronic 1030S along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
