Instruction/ maintenance manual of the product 1005S Patton electronic
Go to page of 8
USER MANUAL MODEL 1005 and 1005S Async. Carrier Sense Short Range Modem SALES OFFICE (301) 975-1000 TECHNICAL SUPPO R T (301) 975-1007 http://ww w .patton.
1.0 W ARRANTY INFORM A TION Patton Electronic s warrants all Model 1005 components to be free from defects, and will—at our optio n —repair or replace the product should it fail within one year from the first date of shipment.
3.0 CONFIGUR A TION The Model 1005 is designed to be easy to use. There are no internal jumpers or configuration switches to set, so there is no need to open the case to configure the unit (you may need to open the case for wire connection—refer to Section 4.
RJ-1 1 SIGNAL RJ-45 SIGNAL 1 ----------------GND † 1 --------------- - N/C 2 ----------------RC V - 2 ----------------GND † 3 --------------- - XMT+ 3 ----------------RC V - 4 ----------------XM T.
1. Open the unit by gently inserting a screwdriver between the DB-25 connector and the lip of the plastic case (see below). Y ou don't have to worry about breaking the plastic, but be careful not to bend the D-sub connector . Once the unit has been opened, you will be able to see the terminal blocks located at the rear of the PC board.
8 . Place the 2 halves of the strain relief assembly on either side of the telephone wire and press together very lightl y . Slide the assembly so that it is about 2 inches from the terminal posts and press together firml y . If your cable diameter is too small or too large for our strain relief, please contact our technical support.
APPENDIX B P A T T ON MODEL 1005 CABLE RECOMMEND A TIONS The Patton Model 1005 operates at frequencies of 20kHz or less and has been performance tested by Patton technicians using twisted- pair cable with the following characteristics: W ire Gauge Capacitance Resistance 19 A WG/.
APPENDIX C P A T T ON MODEL 1005 PIN/SIGNAL ASSIGNMENTS APPENDIX D P A T T ON MODEL 1005 BLOCK DIAGRAM Copyright © 1998 Patton Electronics Company All Rights Reserved 1- (FG) Frame Ground 2- (TD) T r.
An important point after buying a device Patton electronic 1005S (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Patton electronic 1005S yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Patton electronic 1005S - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Patton electronic 1005S you will learn all the available features of the product, as well as information on its operation. The information that you get Patton electronic 1005S will certainly help you make a decision on the purchase.
If you already are a holder of Patton electronic 1005S, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Patton electronic 1005S.
However, one of the most important roles played by the user manual is to help in solving problems with Patton electronic 1005S. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Patton electronic 1005S along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
