Instruction/ maintenance manual of the product G27902 Orion
Go to page of 10
subw oofer 10.2 10.4 12.2 12.4 15.2 15.4 HCCA Cone Replacement kit 10.2 10.4 12.2 12.4 15.2 15.4 HCCA Cone Replacement Kit G27902.04.07.09.12.14_Cover_01-07.
T ABLE OF CONTENTS What’ s Included . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1 Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
RE-CONE KIT A re-cone kit is available for these speakers and can be obtained from your dealer . The part number for each model is listed below . RE-CONE STEPS Note: Step seven in the re-cone process must be altered when re-coning the 10" W oofers.
Note: Do not bend needles during this procedure. 5. T urn the speaker on its side and insert one steel needle (centering pin) into each alignment hole in the backplate of the woofer (total of 8—these are the small diameter holes, not the larger holes—see figure below), Ensure that the pins are inserted completely .
4 spider ring to touch their mounting locations. Do Not Force. If the fit is tight, start over and make sure there is no foreign object in the gap or alignment pin out of place. 8. Return the speaker to its back and thread the Spider Ring bolts through the basket and into the Spider Ring.
Note: It is easy to put too much pressure on one side of the cone and cause a rub, so be careful to apply even and centered pressure on the cone. If there is an obvious rub, then remove the re-cone assembly carefully and following the above procedure re-install.
AL TERNA TE STEP 7—FOR 10" WOOFERS Note: Only the step for the 10” W oofers is given. 7. CAREFULL Y lower the new re-cone assembly (moving parts) into the basket by tilting the voice coil (shown below) while making sure that all of the pins are inside the voice coil former (refer to the illustration at step 7 previously shown).
7 T erminal Blo c k Basket Openin g T erminal Blo c k Vo i c e C oi l Re- C one Assem b ly S pi d er Rin g Basket G27902.04.07.09.12.14 01-07.qxd 1/31/2007 11:23 AM Page 7.
8 HCCA WOOFER RE-CONE ASSEMBL Y Part Description Quantity 1 Allen head screw 8 pieces (12 pieces on 15” woofers) 2 Edge Clamping Ring 1 piece 3 Re-cone assembly 1 set 4 Motor & Basket Assembly 1 set 5 Allen head screw 8 pieces 6 Steel needle 8 pieces G27902.
For more information on Orion products please visit us at www .orioncaraudio.com © 2007 Directed Electronics, All rights reserved. G27902.04.07.09.12.
An important point after buying a device Orion G27902 (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Orion G27902 yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Orion G27902 - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Orion G27902 you will learn all the available features of the product, as well as information on its operation. The information that you get Orion G27902 will certainly help you make a decision on the purchase.
If you already are a holder of Orion G27902, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Orion G27902.
However, one of the most important roles played by the user manual is to help in solving problems with Orion G27902. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Orion G27902 along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
