Instruction/ maintenance manual of the product PS-S03 Oregon Scientific
Go to page of 18
EN Radio Controlled Clock with Barometer and AM/FM Radio (Model #: PS-S03/PS-S03U) User Manual.
1 EN TABLE OF CONTENTS About this guide ................................................ 2 Product overview ............................................... 3 Getting started .................................................. 6 Batteries ..............
2 EN ABOUT THIS GUIDE Congratulations on your selection of the Philippe Starck / Oregon Scientific Radio-Controlled Clock with Barometer and Digital AM/FM Radio (PS-S03/PS-S03U).
3 EN 1 2 3 4 5 6 PRODUCT OVERVIEW TOP, BATTERY COMPARTMENT, AND SIDE VIEW DESCRIPTIONS 1. Snooze/Light button ( 9, 12) 2. Reset button ( 6, 12) 3. Battery compartment ( 6) 4.
4 EN LCD DISPLAY DESCRIPTIONS 1. Low battery icon ( 6) 2. Clock ( 7) 3. Weather forecast and barometric trend ( 11) 4. Calendar ( 9) 5. Radio signal icon ( 7) 6.
5 EN BUTTON DESCRIPTIONS 1. Alarm – activate / deactivate alarm ( 8) 2. Select – switch modes / change settings ( 6) 3. Up – increase setting / activate auto-synch ( 7) 4. Down – decrease setting / deactivate auto synch ( 7) 5. Radio –turn radio or radio alarm on/off ( 9, 11) 6.
6 EN GETTING STARTED BATTERIES Batteries are supplied with this product. Replace them whenever the low battery signal ( ) displays. Remove the battery compartment lid on the back of the speakers, and insert the batteries. Be sure to match the correct polarity, as shown in the battery compartment.
7 EN CLOCK This product can automatically synchronize the date and time with official time-keeping organizations in Frankfurt, Germany (PS-S03) or Rugby, England (PS-S03U). When the unit is within 1500 km (932 miles) of a RF signal, the reception icon will blink.
8 EN SET OR CHANGE THE CLOCK 1. Press SELECT to switch to the Clock Mode. The time will flash. 2. Press and hold SELECT for 2 seconds to enter the setting mode. 3. Select the 12/24-hour format, hour, and minute. Press UP or DOWN to change the setting.
9 EN SNOOZE Press the SNOOZE/ LIGHT button the top of the unit to temporarily disable the alarm for 8 minutes. The alarm icon will blink while Snooze is activated. TO TURN THE ALARM OFF OR ON Press RADIO to turn the Radio Alarm off. Press any other button to turn the Beep Alarm off.
10 EN BAROMETER This product tracks barometric pressure changes over the past 24 hours to provide the weather forecast ( 11) and a trend line showing the direction of barometric change. BAROMETRIC PRESSURE TREND The barometric pressure trend arrow for the last 30 minutes is always displayed.
11 EN WEATHER FORECAST This product forecasts the next 12 to 24 hours of weather within a 30 to 50 km (19 - 31 mile) radius with 70 to 75 percent accuracy. The weather forecast is always displayed. RADIO You can listen to PLL digital radio broadcasts with this product.
12 EN TUNING Press TUNING . Then, press UP or DOWN to scan the available frequencies. Press and hold UP or DOWN for 2 seconds to auto-scan. The scanning will stop when an available frequency is found. STORE STATION TO MEMORY Press STATION for 2 seconds.
13 EN SAFETY AND CARE Wash the unit with a slightly damp cloth and mild detergent. Avoid dropping the unit or placing it in a high-traffic location. WARNINGS This product is designed to give you years of service if handled properly. Observe the following guidelines: • Never immerse the unit in water.
14 EN Strange date / month Problem Symptom Calendar Cannot auto- synchronize Clock 1. Remove batteries. 2. Press R ES ET . All memory items will return to default.
15 EN Problem Symptom Remedy Adjust the antenna ( 11) Barometer Display Rainy, cloudy, partly cloudy, sunny Trend 1 mb change in 1 hour or 3 mb change in 6 hours Radio-controlled clock Synchronization.
16 EN Radio Type Digital tuning PLL (Phase Lock Loop) stereo Band 531 to 1602 kHz (AM) 87.5 to 108.0 MHz (FM) Stations 8 AM / 8 FM Volume 8 levels (0 – 7) Sleep timer 120 minutes in increments of 10 Antenna Wire Power 5 x UM-4 (AAA) 1.5V alkaline batteries AC/DC 6V power adapter (for radio operation) ADDITIONAL RESOURCES Visit our website (www.
17 EN RTTE Compliant Countries : All EU countries, Switzerland CH . And Norway N . EC-DECLARATION OF CONFORMITY This product complies with the essential requirements of Article 3 of the R&TTE 1999.
An important point after buying a device Oregon Scientific PS-S03 (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Oregon Scientific PS-S03 yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Oregon Scientific PS-S03 - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Oregon Scientific PS-S03 you will learn all the available features of the product, as well as information on its operation. The information that you get Oregon Scientific PS-S03 will certainly help you make a decision on the purchase.
If you already are a holder of Oregon Scientific PS-S03, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Oregon Scientific PS-S03.
However, one of the most important roles played by the user manual is to help in solving problems with Oregon Scientific PS-S03. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Oregon Scientific PS-S03 along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
