Instruction/ maintenance manual of the product 8672ATMM Nortel Networks
Go to page of 46
Nortel Ethernet Routing Switch 8600 Installation — Media Dependent Adapters for the 8672ATME and 8672ATMM Modules Release: 5.0 Document Revision: 01.
Nortel Ethernet Routing Switch 8600 Release: 5.0 Publication: NN46205-316 Document status: Standard Document release date: 30 May 2008 Copyright © 2008 Nortel Networks All Rights Reserved.
3 . Contents Regulatory Information and Safety Precautions 5 Software license 17 New in this release 21 Features 21 Other changes 21 Document changes 21 Introduction 23 MDA overview 25 Media Dependent.
4 Nortel Ethernet Routing Switch 8600 Installation — Media Dependent Adapters for the 8672ATME and 8672ATMM Modules NN46205-316 01.01 Standard 30 May 2008 Copyright © 2008 Nortel Networks .
5 . Regulatory Information and Saf ety Precautions Read the information in this section to learn about regulatory conformities and compliances. International Regulatory Statements of Conformity This i.
6 Regulatory Information and Safety Precautions ICES Statement (Canada only) Canadian Department of Communications Radio Interference Regulations This digital apparatus (8000 Series chassis and instal.
National Electromagnetic Compliance (EMC) Statements of Compliance 7 European Union and European Free Trade Association (EFTA) Notice All products labeled with the CE marking comply with R&TTE Dir.
8 Regulatory Information and Safety Precautions National Safety Statements of Compliance CE Marking Statement (Europe only) EN 60 950 Statement This is to certify that the Nortel 8000 Series chassis and components installed within the chassis are in compliance with the requirements of EN 60 950 in accordance with the Low Voltage Directive.
National Safety Statements of Compliance 9 México D.F. 03900 Tel: 52 5 480 2100 Fax: 52 5 480 2199 Input: Model 8003AC: 100-240 VAC, 50-60 Hz, 9 A maximum for each power supply Model 8004AC: 100-240 VAC, 50-60 Hz, 12-6 A maximum for each power supply Model 8005AC: 100-120 VAC, 50-60 Hz, 16 A maximum for each power supply 200-240 VAC, 50-60 Hz, 8.
10 Regulatory Information and Safety Precautions Col. San Jose Insurgentes Deleg-Benito Juarez México D.F. 03900 Tel: 52 5 480 2100 Fax: 52 5 480 2199 Embarcar a: Model 8003AC: 100-240 VCA, 50-60 Hz, 9 A max. por fuente de poder Model 8004AC: 100-240 VCA, 50-60 Hz, 12-6 A max.
Safety Messages 11 Safety Messa ges This section describes the different precautionary notices used in this document. This section also contains precautionary notices that you must read for safe operation of the Nortel Ethernet Routing Switch 8600. Notices Notice paragraphs alert you about issues that require your attention.
12 Regulatory Information and Safety Precautions CAUTION ATTENZIONE ESD Le indicazioni ESD forniscono informazioni per evitare scariche di elettricità statica e i danni correlati per i prodotti Nortel. Caution Notice CAUTION Caution notices provide information about how to avoid possible service disruption or damage to Nortel products.
Safety Messages 13 WARNING AVERTISSEMENT La mention Avertissement fournit des informations sur les moyens de prévenir les risques de blessure lors de la manipulation de produits Nortel. WARNING WARNUNG Warnhinweise bieten Informationen dazu, wie man Personenschäden bei der Arbeit mit Nortel-Produkten verhindert.
14 Regulatory Information and Safety Precautions DANGER PELIGRO Los avisos de Peligro-Alto voltaje brindan información acerca de cómo evitar una situación o condición que cause graves lesiones a personas o la muerte, a causa de una electrocución o de una descarga de alto voltaje.
Safety Messages 15 DANGER PERICOLO Le indicazioni di pericolo forniscono informazioni per evitare situazioni o condizioni che potrebbero causare gravi danni alle persone o il decesso. Nortel Ethernet Routing Switch 8600 Installation — Media Dependent Adapters for the 8672ATME and 8672ATMM Modules NN46205-316 01.
16 Regulatory Information and Safety Precautions Nortel Ethernet Routing Switch 8600 Installation — Media Dependent Adapters for the 8672ATME and 8672ATMM Modules NN46205-316 01.
17 . Software license This section contains the Nortel Networks software license. Nortel Networks Inc. software license agreement This Software License Agreement ("License Agreement") is between you, the end-user ("Customer") and Nortel Networks Corporation and its subsidiaries and affiliates ("Nortel Networks").
18 Software license of this Agreement. Customer shall not a) use, copy, modify, transfer or distribute the Software except as expressly authorized; b) reverse assemble, reverse compile, reverse engine.
Nortel Networks Inc. software license agreement 19 software documentation and, in the event Software is licensed for or on behalf of the United States Government, the respective rights to the software and software documentation are governed by Nortel Networks standard commercial license in accordance with U.
20 Software license Nortel Ethernet Routing Switch 8600 Installation — Media Dependent Adapters for the 8672ATME and 8672ATMM Modules NN46205-316 01.
21 . Ne w in this release The following sections detail what’s new in Nortel Ethernet Routing Switch 8600 Installation — Media Dependent Adapters for the 8672ATME and 8672ATMM Modules, NN46205-316 for release 5.0. • “Features” (page 21) • “Other changes” (page 21) Features This document contains no feature updates in release 5.
22 New in this release Nortel Ethernet Routing Switch 8600 Installation — Media Dependent Adapters for the 8672ATME and 8672ATMM Modules NN46205-316 01.
23 . Intr oduction This guide describes how to install the Media Dependent Adapters (MDAs) for the 8672ATME and 8672ATMM Modules on Ethernet Routing Switch 8600.
24 Introduction Nortel Ethernet Routing Switch 8600 Installation — Media Dependent Adapters for the 8672ATME and 8672ATMM Modules NN46205-316 01.01 Standard 30 May 2008 Copyright © 2008 Nortel Networks .
25 . MD A o vervie w The MDAs for the Nortel 8672ATME and 8672ATMM modules are modular port adapters that are installed on the Ethernet Routing Switch 8600.
26 MDA overview Figure 3 DS-3 MDA: 8672ATME and 8672ATMM modules Each MDA has ports for connection to an ATM network. OC-3c/STM-1 and OC-12c/STM-4 MDAs support concatenated transmission. The flexibility of connectivity is achieved by mixing different types of MDAs.
27 . Media Dependent Adapter installation f or the 8672A TME and 8672A TMM modules This section provides procedures for installing MDA for the 8672ATME and 8672ATMM modules.
28 Media Dependent Adapter installation for the 8672ATME and 8672ATMM modules Table 2 Task and estimated time (cont’d.) Task Estimated time Aligning the MDA with the front portion of the module and .
Installing an MDA 29 3 Line up the MDA with the front of the 8672ATME or the 8672ATMM module, positioning the MDA so that the front aligns with the front of the 8672ATME or the 8672ATMM module. 4 Align the four holes on the MDA with the mounting posts on the 8672ATME or the 8672ATMM module.
30 Media Dependent Adapter installation for the 8672ATME and 8672ATMM modules 7 Attach the supplied laser product label to the front panel of the host module immediately below the MDA. Use the label that is printed in the appropriate language for the country where you are installing the equipment.
Replacing an MDA 31 Replacing an MD A This procedure describes how to replace an MDA. CAUTION Risk of service loss You cannot hot-swap an MDA. You must remove the 8672ATME or 8672ATMM module, install the MDA, and then reinstall the module.
32 Media Dependent Adapter installation for the 8672ATME and 8672ATMM modules 5 If you do not plan to install a replacement MDA, place the slot cover on the MDA slot and tighten the two screws. --End-- Connecting fiber cables This procedure describes how to connect fiber cables to the installed MDA.
Connecting fiber cables 33 2 Remove the protective dust caps from the connector on the fiber cable. Store the dust caps for later use. 3 Hold the fiber cable connector so the keyed surface will insert easily into the MDA connector. Carefully insert the cable connector into the MDA connector and push gently.
34 Media Dependent Adapter installation for the 8672ATME and 8672ATMM modules --End-- Connecting coaxial cables This procedure describes how to connect coaxial cables to the MDA. ATTENTION The DS-3 MDA uses bayonet Neill-Concelman (BNC) connectors. Procedure steps Step Action 1 Push the coaxial cable onto the DS-3 connector.
Connecting coaxial cables 35 2 Turn the coaxial cable to the right until the key on the DS-3 connector clicks into the notch on the coaxial cable. --End-- Nortel Ethernet Routing Switch 8600 Installation — Media Dependent Adapters for the 8672ATME and 8672ATMM Modules NN46205-316 01.
36 Media Dependent Adapter installation for the 8672ATME and 8672ATMM modules Nortel Ethernet Routing Switch 8600 Installation — Media Dependent Adapters for the 8672ATME and 8672ATMM Modules NN46205-316 01.01 Standard 30 May 2008 Copyright © 2008 Nortel Networks .
37 . T ranslation of Safety messa g es Class A product caution statement CAUTION This device is a Class A product. Operation of this equipment in a residential area is likely to cause harmful interference, in which case users are required to take appropriate measures necessary to correct the interference at their own expense.
38 Translation of Safety messages CAUTION CUIDADO Este dispositivo é um produto Classe A. Operar este equipamento em uma área residencial provavelmente causará interferência prejudicial; neste caso, espera-se que os usuários tomem as medidas necessárias para corrigir a interferência por sua própria conta.
39 CAUTION CAUTION CUIDADO ESD Para evitar danos com descarga eletrostática, sempre use uma pulseira antiestática que esteja conectada a uma tomada de descarga eletrostática (ESD) quando estiver realizando a manutenção deste produto. Certifique-se de que a pulseira esteja em contato com sua pele.
40 Translation of Safety messages Nortel Ethernet Routing Switch 8600 Installation — Media Dependent Adapters for the 8672ATME and 8672ATMM Modules NN46205-316 01.
41 . Appendix MD A and LED specifications See the following sections for Media Dependent Adapters (MDAs) and Light Emitting Diode (LED) specifications.
42 MDA and LED specifications Table 4 OC-3c/STM-1 MDA specifications: 8672ATME and 8672ATMM modules (cont’d.) Parameter SMF description MMF description Distance 15 km 2 km Input power 40 W 40 W Ther.
LEDs 43 Table 7 MDA LED indications Label Color State Meaning Green Steady Indicates network activity for the corresponding port. A very low level of network activity (approximately 1–5 pps) can cause the LED to blink. — Off The port is not transmitting data (no network activity).
44 MDA and LED specifications Nortel Ethernet Routing Switch 8600 Installation — Media Dependent Adapters for the 8672ATME and 8672ATMM Modules NN46205-316 01.
.
Nortel Ethernet Routing Switch 8600 Installation — Media Dependent Adapters for the 8672ATME and 8672ATMM Modules Copyright © 2008 Nortel Networks All Rights Reserved. Printed in Canada, India and the United States of America Release: 5.0 Publication: NN46205-316 Document status: Standard Document revision: 01.
An important point after buying a device Nortel Networks 8672ATMM (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Nortel Networks 8672ATMM yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Nortel Networks 8672ATMM - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Nortel Networks 8672ATMM you will learn all the available features of the product, as well as information on its operation. The information that you get Nortel Networks 8672ATMM will certainly help you make a decision on the purchase.
If you already are a holder of Nortel Networks 8672ATMM, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Nortel Networks 8672ATMM.
However, one of the most important roles played by the user manual is to help in solving problems with Nortel Networks 8672ATMM. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Nortel Networks 8672ATMM along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
