Instruction/ maintenance manual of the product mec-2-fl-d60-n105 Nikon
Go to page of 24
Use of Iris Camera MEC-2-FL-D60-N105 1 Use of Nikon D60 Miles Eye Camera (MEC-2-FL-D60-N105) Contents of the MC-2-F L Iris Camera System ......................................................2 Preparing the Iris Camera for Use – (Flex- Lighting) ...
Use of Iris Camera MEC-2-FL-D60-N105 2 Use of MEC-2-FL-D60 Iris Camera Contents of the Camera Carr y Case – MC-2- FL-D60-N105 Case Contents for MC-2-FL 1. Camera with Macro Lens 2. Hood-Mounted Illuminator 3. Camera Batteries 4. Camera Battery Charger Cord Compartment 5.
Use of Iris Camera MEC-2-FL-D60-N105 3 Macro Camera MEC-2-FL Kit Preparing the Iris Camera for Use – Flex-Lighting 1. Open Camera Carry Case by lifting up each latch.
Use of Iris Camera MEC-2-FL-D60-N105 4 4. Remove lens cap and turn the camera on. Mode dial is set to A =Aperture p riority 5. Pop up the built-in flash by pr essing button on left side 6.
Use of Iris Camera MEC-2-FL-D60-N105 5 7. Rotate Illuminator until it snaps into place a t 12:00 position: 8. Press focus light power switch: 9. Your camera is now ready to take iris pictures. When complete with the photography, reverse these steps to put the camera away.
Use of Iris Camera MEC-2-FL-D60-N105 6 11. For “flat” or uniform illumination, use the Both Channels Open position. This is setting is when the lever is all the way to the left or the right: Close-up detail of the lightguide channel shutter padd le switch: 12.
Use of Iris Camera MEC-2-FL-D60-N105 7 13. Note: for general photography, use the enclosed Zo om lens (18-55mm VR) instead (VR=Vibration Reduction). You may also use any Nikon AF-S or AF-I autofocus lens.
Use of Iris Camera MEC-2-FL-D60-N105 8 How To Take Perfect Iris Pictures 1. Be sure the client is comfortably seated and relaxed. 2. If a chinrest is not used, have the client open their own lids by p.
Use of Iris Camera MEC-2-FL-D60-N105 9 5. If a chinrest is used, adjust the height so th e center of the iris is about 1” (25mm) below the bottom of the forehead rest. When a chinrest is u sed, lid retractio n can be accomplished using two 6” cotton swabs in one hand to separa te lids.
Use of Iris Camera MEC-2-FL-D60-N105 10 10. Always take all the right eye pics first then all the left eye pics. If you take scleral pics, start with the iris of that eye, followed by the four quadrants of the sclera (normally Left, Right, Upper, Lower).
Use of Iris Camera MEC-2-FL-D60-N105 11 Sample iris images: Lef t, Blue iris at f/51; Right, Mi xed iris at f/45.
Use of Iris Camera MEC-2-FL-D60-N105 12 How To Transfer Iris Images Using The Card Reader 1. Start with the reader unplugged 2. Insert the SD Flash memory card into the card reader 3. Plug the card reader into the computer’s USB socket The blue light on the card reader will illum inate: 4.
Use of Iris Camera MEC-2-FL-D60-N105 13 Card Reader Disconnection In Deta il – Model S6 1-slot card reader 1. Close out all folders that refere nce the Flash Drive letter. When closing a folder in W indows, pressing the shift key at the same tim e will also close all parent windows.
Use of Iris Camera MEC-2-FL-D60-N105 14 7. After Clicking the Card Reader Device, The blue light on the Card Reader will go out, indicating that the power is no longer being supplied to the card reader and it is now safe to remove the card reader from the USB socket.
Use of Iris Camera MEC-2-FL-D60-N105 15 3. At this point I am currently recommending that you select the "Microsoft S canner and Camera Wizard" since it has the best behavior and options. I do not bother with Nikon Pict ure Project but it does work well with the Nikon Capture program.
Use of Iris Camera MEC-2-FL-D60-N105 16 11. Then open the image in a photo editor (such as Pain t Shop Pro or Photo Shop) and crop it down to the smallest rectangle that encloses the iris. This is saved with the same f ilenam e but a "c" at the end, prior to ".
Use of Iris Camera MEC-2-FL-D60-N105 17 How to use the enclosed universal 12-sector iris grids with chart If you do not use printouts, just place th e grids over the imag es on the m onitor.
Use of Iris Camera MEC-2-FL-D60-N105 18 Camera Maintenanc e – Focus Light Battery Change Focus Light Type 3 – FLV8F (LED focus light with flex end) 1. Remove the focus light from the illum inator. 2. Open the battery compartment by unscrewing the end cap.
Use of Iris Camera MEC-2-FL-D60-N105 19 5. Put in the new batteries with the button end (positive) first. The easy way to load the 4 button cells is to st ack them up (button end up) on a sheet of paper or card, slide the focus light over them, then tilt the light with paper upright.
Use of Iris Camera MEC-2-FL-D60-N105 20 Camera Settings Note: These steps are already done in manufacturing , but you may need to reset these setting if the camera is used in an automatic mode for other photography. A. Lens Settings – Nikkor 105mm VR Lens -- These steps are already done in manufacturing.
Use of Iris Camera MEC-2-FL-D60-N105 21 Reference for Nikon D-60 Settings Note: These steps are already done in manufacturing , but you may need to reset these setting if the camera is used in an au tomatic mode for other photography. Iris Camera Menu Settings: Shooting Menu White Balance change from A to Flash CSM Menu 14.
Use of Iris Camera MEC-2-FL-D60-N105 22 Menu Reference The Nikon D-60 has four menus (plus a retouch menu that is not norm ally used), each one signified by a different icon in the leftmost column. To access the menus, switch th e camera on and press the MENU button on the back of the camera.
Use of Iris Camera MEC-2-FL-D60-N105 23 8. Flash Compensation 0.0 0.0 0.0 9. AF-assist ON ON ON 10. ISO auto OFF OFF OFF 11. Fn Button ISO ISO ISO 12. AE-L/AF-L 2 locks 2 locks 2 locks 13. AE Lock OFF OFF OFF 14. Built-in Flash TTL-Fl ash Manual-Full Power TTL- Flash 15.
Use of Iris Camera MEC-2-FL-D60-N105 24 Aperture Guide Camera: D60 Illuminator: Flex-Lighting ISO: 200 EV: 1/3 Brown: 16---18---20---22---25 Tan: 20---22---25---29---32 Mixed: 22---25---29---32---36 Blue: 25---29---32---36---40---45 Sclera: 51---57 Do not use: 4.
An important point after buying a device Nikon mec-2-fl-d60-n105 (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Nikon mec-2-fl-d60-n105 yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Nikon mec-2-fl-d60-n105 - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Nikon mec-2-fl-d60-n105 you will learn all the available features of the product, as well as information on its operation. The information that you get Nikon mec-2-fl-d60-n105 will certainly help you make a decision on the purchase.
If you already are a holder of Nikon mec-2-fl-d60-n105, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Nikon mec-2-fl-d60-n105.
However, one of the most important roles played by the user manual is to help in solving problems with Nikon mec-2-fl-d60-n105. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Nikon mec-2-fl-d60-n105 along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
