Instruction/ maintenance manual of the product NVS 4 Newcon Optik
Go to page of 20
Operation Manual NIGHT VISION WEAP ON SCOPE NVS 4 105 Sparks Ave., Toronto, ON, M2H 2S5, Canada.
IMPORTANT INFORMATION Read prior to activation You have just purchased a complicated electronic device. To operate it properly, please read this manual carefully.
Table of contents 1. OVERVIE W.................................................... 1 2. DELIVERY S ET ............................................. 3 3. SPECIFICATION S ......................................... 4 4. DESIGN ............................
1 1. OVERVIEW The night vision NV S 4 is aiming optical-electronic weapon scope, intende d for shooting g un with the side mount at night time or dark co nditions. The unit utilizes a generation 2+ or better image intensifier tube, which amplifies available moonlight, starlight or man- made light.
2 Precautions NVS 4 is a sophisticated pr ecise optical instrum ent equipped wit h electronics. Therefore, it shoul d be handled with due care. • Keep your device away from direct sunli ght, impacts, dust, m oisture, and sudden change s of temperatures.
3 2. DELIVERY SET NVS 4 is supplied with the following components: Quantity NVS 4 unit 1 Wrench 1 Soft case 1 Napkin 1 Manual 1 Warranty regist ration card 1 *Exact delivery set and accessories included are subject to the terms of s pecific contract.
4 3. SPECIFICATIONS NVS4 NVS4 / 5x Typical range at starlight, m 350 500 Image Intensifier tube 2+ 2+ Magnification, x 4 5 Field of view under eye relief 40 mm, deg 6.
5 4. DESIGN Figure 1. 2 – Lens 3 – Fitting part 4 – Scope housi ng 5 – Clip 6 – Eye-shield 8 – Battery compartment cover 9 – Lead 10 – Scope housing co ver 11 – Washer 12 – Stop sc.
6 Figure 2. 1 – Lens cu p with brightness filter 7 – Switch 18 – Vertical adjustment screw 19 – Cover of blow-out fitting 20 – Rubber gasket 21 – Horizo ntal adjustm ent screw.
7 5. OPERATION INSTRUCTIONS The scope is mounted on a weap on by means of clamp, which consists of bracket 16 (Fig.1, 2), lock screw 2, latch 13, lock lever 14, ha ndle 15 and washer 11.
8 - remove the co ver 8 and insert the battery as sho wn on the cover of scope; - screw up the cove r 8; - turn on the switch 7. In 3-4 seconds the eyepiece fiel d of view should begin to gleam with y.
9 Note: If zeroi ng range is different, the value of clic k changes proportionall y, for exam ple: - at range 50 m - 1.5 cm ; - at range 200 m - 6.0 cm. Example: O n the Fig.3 t he mean poi nt of impact is located above the aiming point by 15 cm and at the left by 20 cm.
10 6. MAINTENANCE The device should be ke pt clean avoidin g dust and dirt. The outer surfaces of the optical parts should be clean always. WARNING: It is prohibited: - to disassembl e the scope; - to.
11 7. STORAGE The scope must be pre vented against mechanical dam ages. The scope is to be stored in a heated room . Ambient temperature must be within the limits from 5 to 35°C. Relative humidity must not exceed 85%. It is recommended to keep the scope in its caring case without a battery inserted.
12 8. TROUBLESHOOTING The device does not work . Check that the battery is installed properly. Check the charge of the batteries. Replace if it is weak. The image is degraded and blurred. Clean the lens with napkin. If the inner optics suffe rs from exte nded humi dity send the sc ope to the manufacture r for drying and sealing.
13 Condensation accumulate s on the parts. It is O.K. to use the unit in cold. However, when the unit is brought from the cold into a warm environment, it has to warm up for up to 2 hours (not minutes!). Only then it is allowed to turn it ON again. Visibility decreases and / or disa ppears.
14 9. WARRANTY NEWCON warrants this product against defects in material and workmanship for one year from the date of the original purchase, but no more than 18 months f rom the date of manufacturi ng. Longer wa rranty is available , subject to the terms of the specific sales c ontract.
15 10. CUSTOMER SUPPORT Should you experience an y difficulties with your NEWCON OPTIK product, consult the enclo sed manual. If the problem remains unresol ved, contact our customer supp ort departm ent at (416) 663-6963 or toll free at 1-877-368-6 666.
16 11. ACCEPTANCE CERTIFICATE NIGHT VISION DEVICE NVS 4 Serial number: ________ _____________ ____________ Complies wit h all technical specifications a nd has passe d the inspection.
NEWCON OPTIK ™ 2010 Printed in Canada.
An important point after buying a device Newcon Optik NVS 4 (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Newcon Optik NVS 4 yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Newcon Optik NVS 4 - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Newcon Optik NVS 4 you will learn all the available features of the product, as well as information on its operation. The information that you get Newcon Optik NVS 4 will certainly help you make a decision on the purchase.
If you already are a holder of Newcon Optik NVS 4, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Newcon Optik NVS 4.
However, one of the most important roles played by the user manual is to help in solving problems with Newcon Optik NVS 4. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Newcon Optik NVS 4 along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
