Instruction/ maintenance manual of the product NZ25 Napoleon
Go to page of 16
WS-415-71 / 09.07.00 1 INST ALLER: THESE INSTRUCTIONS MUST BE CONVEYED TO AND REMAIN WITH THE HOMEOWNER. THIS FIREPLACE HAS BEEN TESTED AND LISTED BY WARNOCK HERSEY L TD.
WS-415-71 / 09.07.00 2 PLEASE RET AIN THIS MANU AL FOR FUTURE REFERENCE Congratulations on the purchase of your Napoleon hi-tech, high efficient solid fuel burning fireplace! It has been extensively tested in Canadian and American laboratories .
WS-415-71 / 09.07.00 3 NAPOLEON wood fireplaces are manufactured under the strict Standard of the World Recognized ISO9002 Quality Assurance Certificate. NAPOLEON products are designed with superior components and materials, assembled by trained craftsmen who take great pride in their work.
WS-415-71 / 09.07.00 4 INTRODUCTION GENERAL INFORMA TION This is the most efficient, sim- ple and trouble free woodburning system we know of and works as follows: Primary combustion air enters through.
WS-415-71 / 09.07.00 5 CARE OF GLASS AND PLA TED PA R T S If the glass is not kept clean permanent discolouration and / or blemishes may result. Normally a hot fire will clean the glass.
WS-415-71 / 09.07.00 6 These options may be incorporated with one another . If the optional blowers are to be installed, make provision dur- ing framing to route a 1 10 volt power line to the fireplace. Detailed installation instructions are included with each venting kit.
WS-415-71 / 09.07.00 7 HEARTH EXTENSION An acceptable 16" x 50" non-combustible (ie: brick, stone or ceramic tile) hearth extension must be installed.
WS-415-71 / 09.07.00 8 FIGURE 10 - 4 ELBOWS FIGURE 9 - 2 ELBOWS FIGURE 8 - STRAIGHT UP No Off-Set. Minimum overall chim- ney height is 15 feet. Single off-set with two 15°, 30° or 45° elbows. Minimum overall chimney height is 15 feet. Double off-set with four 15°, 30° or 45° elbows.
WS-415-71 / 09.07.00 9 1. Move the fireplace into position. Try to center the ex- haust flue of the fireplace, midpoint between two joists to prevent having to cut them.
WS-415-71 / 09.07.00 10 FINISHING FIREBRICK REMO V AL: The fireplace is shipped with the firebricks in place, how- ever if you need to remove them (ease of installation, re- placement, etc), follow this sequence: Remove the ashwell grate.
WS-415-71 / 09.07.00 11 OPTIONAL BLOWER INST ALL A TION NST ALLA TION TO BE DONE BY A QUALIFIED INST ALLER and must be electrically connected and grounded in ac- cordance with local codes. In the absence of local codes, use the current CSA C22.1 CANADIAN ELECTRICAL CODE.
WS-415-71 / 09.07.00 12 NZ25 FEA TURES CONTROLLING COMBUSTION AIR: If the outside combustion air kit is not used, air may still be drawn directly into the fireplace through the lower louvres. Outside and inside air may be combined by pulling the outside air lever out as far as possible, and turning the lever 90° to its locking position.
WS-415-71 / 09.07.00 13 ASH REMO V AL PROCEDURES A bed of ashes approximately 1 inch deep should be left on the firebox bottom to help maintain a hot charcoal bed. When the fire has burned down and cooled, remove any excess ashes. T o use your ash pan, pull the ash dump handle forward to an open position.
WS-415-71 / 09.07.00 14 FIRE EXTINGUISHERS AND SMOKE DETECT ORS All homes with a solid fuel burning fireplace should have at least one fire extinguisher in a central location, known to all, and at least one smoke detector in the room containing the fireplace.
WS-415-71 / 09.07.00 15 REPLACEMENT P ARTS P ART N O. DESCRIPTION NZ-H333 BLACK DOOR C / W HANDLE & GASKET NZ-H333G GOLD PLA TED DOOR C / W HANDLE & GASKET WS-300-04 DOOR GLASS ONL Y EP-562.010 DOOR GASKET EP-562.016 GLASS GASKET WS-325-07 LARGE SPRING HANDLE WS-325-02 SMALL SPRING HANDLE GA GD-715.
WS-415-71 / 09.07.00 16 TROUBLE SHOOTING Build your fire on the floor of the firebox and be- hind the log retainer only . Do not block or restrict the hot air outlets or air inlets . This will cause the fir eplace to ov erheat. Keep fires away from the door .
An important point after buying a device Napoleon NZ25 (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Napoleon NZ25 yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Napoleon NZ25 - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Napoleon NZ25 you will learn all the available features of the product, as well as information on its operation. The information that you get Napoleon NZ25 will certainly help you make a decision on the purchase.
If you already are a holder of Napoleon NZ25, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Napoleon NZ25.
However, one of the most important roles played by the user manual is to help in solving problems with Napoleon NZ25. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Napoleon NZ25 along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
