Instruction/ maintenance manual of the product MH85FAV Mr. Heater
Go to page of 20
70056 Rev. C 4/07 ENERCO GROUP, INC., 4560 W. 160TH ST., CLEVELAND, OHIO 44135 • 216-916-3000 — Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this or any other appliance. — An LP cylinder not connected for use shall not be stored in the vicinity of this or any other appli- ance.
SPECIFICATIONS Type of Gas: ............. For use with Propane Only Gas Supply Pressure to regulator ............. Max.: Bottle Pressure . to regulator ............. Min.: 5 psig (34.5 kPa) re gu la to r o ut .......... 28 " W .C . ( 6. 97 kPa) Electrical Input: .
OPERATING PRECAUTIONS This is a propane, direct-fired, forced air heater. It's intended use is primarily temporary heating of buildings under construction, alteration or repair.
Figure 2 MINIMUM CLEARANCE: From normal combustible material Clearance 55, 85, 125 Forced Air From floor .......................................... 0 ft From outlet ........................................ 6 ft From sides .............................
ODOR FADE WARNING WARNING Asphyxiation Hazard • Do not use this heater for heating human living quarters. • Do not use in unventilated areas. • The flow of combustion and ventilation air must not be obstructed. • Proper ventilation air must be provided to support the combustion air requirements of the heater being used.
MAINTENANCE AND STORAGE 1 . The heater should be inspected before each use, and at least annually by a qualified person. 2. Before each use, check the soft "O" ring seat at the bullnose of the POL fitting. If the "O" ring is cut, scuffed, or otherwise damaged, replace it with part number 73786.
SIZE AND CAPACITY OF PROPANE CYLINDERS REQUIRED The charts below show the approximate size of the cylinder required for these heaters. To use the chart: 1. Select the lowest air temperature expected (at the bottom of the chart). 2. Move straight up to time of operation desired (left side of chart).
Color Length From T o Yellow 18" (406mm) High Limit Ignition Control Temp. Terminal Yellow 18" (406mm) High Limit Ignition Control Temp Terminal 55FAV, 85FAV, 125FAV WIRING CHART (Wire: Type AWG 150 o C or equivalent (Type SF2-200, **SGI-250 o C)) WIRING DIAGRAMS 8 Operating Instructions and Owner’s Manual Enerco Group, Inc.
Forced Air Propane Construction Heater • Model #55FAV, 85FAV, 125FAV 9 Operating Instructions and Owner’s Manual Enerco Group, Inc.| Forced Air Propane Construction Heater REF.
WARNING: USE ONLY MANUFACTURER’S REPLACEMENT PARTS. USE OF ANY OTHER PARTS COULD CAUSE INJURY OR DEATH. REPLACEMENT PARTS ARE ONLY AVAILABLE DIRECT FROM THE FACTORY AND MUST BE INSTALLED BY A QUALIFIED SERVICE AGENCY. MR. HEATER HOSES F273701 AND F273702 ARE SPECIFICALLY DESIGNED FOR USE WITH THIS HEATER.
ENERCO GROUP, INC., 4560 W. 160TH ST., CLEVELAND, OHIO 44135 É.-U • (216) 916-3000 Mr. Heater est une marque de commerce déposée d'Enerco Group Inc. © 2003, Enerco/Mr. Heater. Tous droits réservés. ANSI Z83.7/CGA 2,14-2000 Enerco Group Inc.
Appareil de chauffage au propane à air pulsé pour chantier de construction - Modèle nº 55FAV 9 Guide d'utilisation et instructions de fonctionnement Enerco Group, Inc. | Appareil de chauffage à air pulsé au gaz propane pour chantier de construction RÉF.
55FAV, 85FAV, 125FAV SCHÉMA DE CÂBLAGE SCHÉMAS DE CÂBLAGE 8 Guide d'utilisation et instructions de fonctionnement Enerco Group, Inc. | Appareil de chauffage à air pulsé au gaz propane pour chantier de construction 70056 Rev.
TABLEAU DE DIMENSIONS ET CONTENANCES DES BONBONNES DE GAZ PROPANE REQUISES Les tableaux qui suivent indiquent la taille approximative de la bonbonne de gaz requise pour ces appareils de chauffage. Pour utiliser le tableau : 1. Sélectionnez la température de l'air la plus basse prévue (au bas du tableau).
3 . Débranchez le cordon d'alimentation. REDÉMARRAGE APRÈS UN ARRÊT D'URGENCE 1 . Fermez complètement le robinet sur la bonbonne de gaz propane. Débranchez l'appareil de chauffage. 2 . Attendez cinq minutes. 3 . Recommencez la procédure « DÉMARRAGE ».
AVERTISSEMENT LIÉ AUX SUBSTANCES ODORANTES AVERTISSEMENT Risque d'asphyxie • Cet appareil ne doit pas être utilisé pour le chauffage de locaux où demeurent des gens. • Ne l'utilisez pas dans des endroits non aérés. • Le débit de chaleur et d'air de ventilation ne doit pas être obstrué.
Figure 2 ÉCART MINIMUM : entre l'appareil et tout matériel combustible. Écart Air pulsé 55, 85, 125 Du plancher ....................................... 0 pi De la sortie ........................................ 6 pi Des côtés ..............
PRÉCAUTIONS LIÉES AU FONCTIONNEMENT Cet appareil de chauffage à air pulsé et à feu direct fonctionne au gaz propane. Il est destiné principalement à chauffer temporairement des édifices en construction, en rénovation ou en réparation. Le gaz propane est plus lourd que l'air.
SPÉCIFICATIONS Type de gaz : ............ Pour utilisation de gaz propane seulement Pression de l'alimentation en gaz au régulateur ........... Max. : Pression de la bonbonne à la sortie du régulateur : ..................................... 28" W.
Version 04/07 C nº 70056 ENERCO GROUP, INC., 4560 W. 160TH ST., CLEVELAND, OHIO 44135 É.-U. • (216) 916-3000 - N'entreposez ni n'utilisez d'essence ou autres liquides ou vapeurs inflammables à proximité de ce type d'appareil.
An important point after buying a device Mr. Heater MH85FAV (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Mr. Heater MH85FAV yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Mr. Heater MH85FAV - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Mr. Heater MH85FAV you will learn all the available features of the product, as well as information on its operation. The information that you get Mr. Heater MH85FAV will certainly help you make a decision on the purchase.
If you already are a holder of Mr. Heater MH85FAV, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Mr. Heater MH85FAV.
However, one of the most important roles played by the user manual is to help in solving problems with Mr. Heater MH85FAV. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Mr. Heater MH85FAV along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center