Instruction/ maintenance manual of the product 6037 Monarch
Go to page of 8
TC6037QR Rev. AE 5/04 ©2002 Paxar Corporation. All Rights Reserved. MONARCH ® P A THFINDER ® UL TRA ® GOLD 6037 ™ PRINTER QUICK REFERENCE Getting Started 1. Charge the main battery. Use either the Monarch® 9462™ or 9464™ battery charger. See the docum entation for those chargers.
2 Quick Reference Replacing Batteries Important: Take the main battery out of the printer when storing the printer. 1. Turn the printer over and press the button on the battery compartment door (at the bottom of the printer’s handle) and slide it open (the door stays attached).
Quick Reference 3 Adjusting the Display Contrast You can lighten or darken the display us ing the LCD contrast buttons at the bottom of the keypad. ♦ Press the (left arrow) to lighten the display. ♦ Press the (right arrow) to darken the display. Loading Supplies 1.
4 Quick Reference Loading for Non-Peel Mode A. Feed the supply under the applicator roller and over the label deflector. B. Close the supply cover completely. C. Press ESC to exit. Loading for Peel Mode A. Peel and discard the first four inches of labels from the backing paper.
Quick Reference 5 Removing Supplies 1. Peel mode only. Tear the backing paper just above the pinch roller. 2. Open the supply cover completely. 3. Spread the supply holder tabs apart and remove the supply roll. 4. Peel mode only. Carefully pull out the supply backing paper still in place between the pinch and feed rollers.
6 Quick Reference Cleaning the Black Mark Sensor 1. Turn off the printer and open the supply cover. 2. Remove the supplies. 3. Clean the black mark sensor with a dry cotton swab. 4. Reload the supplies and close the supply cover. Cleaning the On-Demand Sensor 1.
Quick Reference 7 4. Use a dry, soft-bristle brush, such as a toothbrush, to clean either the standard (black) or linerless (red/orange textured) platen roller. 5. Turn the platen roller with your finger, and then continue cleaning. 6. Reload the supplies and close the label deflector and supply cover.
8 Quick Reference Problem Solution Display does not turn on. Switch batteries/Make sure power is on. CMOS Error Replace the backup battery. Print has voids or is too light. Load the supply correctly / Check for damage. Close the supply cover completely.
An important point after buying a device Monarch 6037 (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Monarch 6037 yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Monarch 6037 - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Monarch 6037 you will learn all the available features of the product, as well as information on its operation. The information that you get Monarch 6037 will certainly help you make a decision on the purchase.
If you already are a holder of Monarch 6037, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Monarch 6037.
However, one of the most important roles played by the user manual is to help in solving problems with Monarch 6037. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Monarch 6037 along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
