Instruction/ maintenance manual of the product Entrust Minute Man
Go to page of 25
User's Manual Entrust Series UPS.
1 © Copyright 2007 1 . Introduction 2 2 . Controls and Indicators 6 3. Installation 7 4. Operation 10 5 . T roubleshooting 12 6 . Replacing the Battery 13 7 .
2 IMPORT ANT SAFETY INSTRUCTIONS SA VE THESE INSTRUCTIONS ! English Thank you for purchasing this power protection product. It has been designed and manufactured to provide many years of trouble free service.
3 W ARNING: Risk of Electrical Shock. Hazardous live p arts inside these power supplies are energized from the battery even when the AC input is disconnected. CAUTION! T o de-energize the outputs of the UPS: 1. If the UPS is on press and release the On/Off Button.
4 English After removing your UPS from its carton, it should be inspected for damage that may have occurred in shipping. Immediately notify the carrier and place of purchase if any damage is found. Warranty claims for damage caused by the carrier will not be honored.
5 English Life Support Policy As a general policy , we do not recommend the use of any of our products in life support applications where failure or malfunction of the product can be reason- ably expected to cause failure of the life support device or to significantly affect its safety or effectiveness.
6 English 1. On/Off Button. 2. AC Mode (Green) LED. 3. On Battery (Y ellow) LED. 4. Bad Battery/Overload/Fault (Red) LED. 5. Input power cord. 6. Surge Only output power receptacles. 7. The USB communications port is for UPS monitoring and control. 8.
7 English INST ALLA TION PLACEMENT This UPS series is intended to be install in a temperature controlled environment that is free of conductive contaminants. Avoid locations near heating devices, water or excessive humidity , or where the UPS is exposed to direct sunlight.
8 English CONNECTING THE BA TTERIES (QUALIFIED SERVICE PERSONNEL ONL Y) Please read all of the W ARNINGS and CAUTIONS before attempting to connect the batteries. 1. Remove the UPS from the shipping box and set on a table or a bench top. 2. Remove the retaining screws from the bottom of the front panel of the UPS.
9 English CHARGING THE BA TTER Y The UPS will charge the internal batteries whenever the UPS is connected to an AC source and there is an acceptable AC voltage present (90 - 150V AC). It is recommended that the UPS's batteries be charged for a minimum of 4 hours before use.
10 English SYSTEM OVERVIEW This Line-Interactive UPS protects computers, internetworking, and telecom- munications equipment from blackouts, brownouts, overvoltages, and surges. The A VR function continuously corrects the volt ages, in-between the brownout and overvoltage transfer point s (90 - 150V AC), to a safe usable level.
11 English USB COMMUNICA TIONS PORT The USB communications protocol is HID. The HID USB driver comes stan- dard in the Windows OS. Simply plug the USB cable into the UPS and the computer then follow the prompts on the screen.
12 English Possible Cause Symptom What T o Do Press and release the On/Off button to start UPS On/Off/ button not pressed UPS will not turn on Reset circuit breaker by pressing the plunger back in.
13 English REPLACING THE BA TTER Y W ARNING! This UPS contains potentially hazardous voltages. Do not at- tempt to disassemble the UPS beyond the battery replacement procedure. This UPS contains no user serviceable parts. Re- pairs and battery replacement must be performed by QUALIFIED SERVICE PERSONNEL ONL Y .
14 English BA TTER Y REPLACEMENT PROCEDURE PLEASE READ THE CAUTIONS AND W ARNINGS BEFORE A TTEMPTING TO REPLACE THE BA TTERIES Hot-swappable batteries mean that the batteries can be replaced without powering down the whole UPS system.
15 English FIG . 1 FIG . 2 FIG . 3: ETR500 FIG . 3: ETR700 FIG . 3: ETR1000/1500.
16 English IF THE UPS REQUIRES SERVICE 1. Use the TROUBLESHOOTING section to eliminate obvious causes. 2. V erify there are no circuit breakers tripped.
17 English 120V A C 500V A 300W 1000V A 600W 700V A 420W Protection W aveform Type Over-Current, Short-Circuit Protected and Latching Shutdown Simulated Sine Wave (S tep Wave) Frequency 50/60Hz, +/-0.
18 English BA TTER Y SYSTEM T ypical Recharge T ime T ypical Battery Life Battery: Quantity/Rating 3-5 years, depending on discharge cycles and ambient temp 1-12V5Ah 2-12V7Ah 8-hours from total discha.
19 English Para Systems, Inc. (Para Systems) warrants this equipment, when properly applied and operated within specified conditions, against faulty materials (excluding the batteries) or workmanship for a period of three years from the date of purchase.
20 English A1. DECLARA TION OF CONFORMITY Application of Council Directive(s): 89/336/EEC, 73/23/EEC S tandard(s) to which Conformity is declared: Manufacturer’s Name: Para Systems, Inc.
21 English Notes:.
22 English Notes:.
.
Para Systems, Inc. 1455 Lemay Dr . Carrollton, TX 75007 Phone: 1-972-446-7363 Fax: 1-972-446-901 1 Internet: minutemanups.com UPS Sizing: sizemyups.com PN - 34000295 R1.
An important point after buying a device Minute Man Entrust (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Minute Man Entrust yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Minute Man Entrust - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Minute Man Entrust you will learn all the available features of the product, as well as information on its operation. The information that you get Minute Man Entrust will certainly help you make a decision on the purchase.
If you already are a holder of Minute Man Entrust, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Minute Man Entrust.
However, one of the most important roles played by the user manual is to help in solving problems with Minute Man Entrust. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Minute Man Entrust along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
