Instruction/ maintenance manual of the product MIL-S500 MiLAN
Go to page of 12
MIL-S500 User ’ s Guide 5-Port 10/100 Switch.
© COPYRIGHT 2004 ALL RIGHTS RESER VED. First Edition. Printed in T a iwan. All trademarks are the properties of their re spective owners. No portion of this document may be reproduced, altered, adapted or transl ated without the prior written approval.
To Contact MiLAN Technology For prompt response when calling for service information, have the following inform ation ready: Product serial number and revision. Date of purchase and V endor or place of purchase. Y ou can reach MiLAN T echnology technical support at: E-mail: support@milan.
MIL-S500 Switch User’s Guide Introduction The MIL-S500 Switch provides wire-s peed, Fast Ethernet switching function that allows high-performance, low cost connections to full-duplex, half-duplex, 10Mbps and 100Mbp s Ethernet network.
MDI/MDIX Auto-recognition (No cross over cable required) Magnets provide easy inst allation in modular office Package Content s Y our p ackage contents should include the following: MIL-S500 Switch Four rubber feet with adhesive p ads T wo Magnets User’s Guide Figure 2.
If any of these pieces are found mi ssing or damaged, please contact your local dealer or reseller for replacement. Hardware Description The Front Panel The front p anel consists of LED Indicators.
Figure 4. Rear panel view of the MIL-S500 switch Auto-sensing ports for speed and Duplex Five Auto-sensing RJ-45 ports for 10Base-T or 100Base-TX connections. DC Power Connector Plug this connector female end into this device, and the male into a power outlet.
On Green The port is successfully connecting with the device. Blinking The port is receiving or transmitting dat a. LINK/ACT Off The port does not link successfully with the device. Inst allation Apply self-adherent ru bber feet to the bottom of the Switch near each of the four corners.
The Switch can be easily monitored through panel indicators that assist in the identification of problems. This section describes common problems you may encounter and where you can find possible solutions.
Performance Specification T ransmission Method S tore and forward MAC address table 1K-entry MAC address table Maximum Forwarding Rate(64byte packet s) 14,880 pps /10 BASE-T 148,800 pps /100BASE-TX Ma.
11.
P/N 90000200 Rev C 12.
An important point after buying a device MiLAN MIL-S500 (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought MiLAN MIL-S500 yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data MiLAN MIL-S500 - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, MiLAN MIL-S500 you will learn all the available features of the product, as well as information on its operation. The information that you get MiLAN MIL-S500 will certainly help you make a decision on the purchase.
If you already are a holder of MiLAN MIL-S500, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime MiLAN MIL-S500.
However, one of the most important roles played by the user manual is to help in solving problems with MiLAN MIL-S500. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device MiLAN MIL-S500 along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
