Instruction/ maintenance manual of the product TOUCHTRONIC G 832 SC Miele
Go to page of 48
Oper ating instr uctions T ouchtronic G 832 SC T o prevent accidents and machine damage, read these instructions bef ore installation or use. UV M.-Nr .
IMPOR T ANT SAFETY INSTR UCTIONS CONSIGNES DE SÉCURITÉ IMPOR T ANTES Caring f or the en vir onment Energy saving washing . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10 Guide to the dishwasher W ash cabinet .
Operation Adding detergent . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 28 Running the dishwasher . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 29 Program sequence indicator (16) .
W ARNING – When using y our dishwasher , follow basic precautions, including the f ollowing: Read all instructions bef ore installation or use of the dishwasher to prevent injury and mac hine damage. The manufacturer cannot be held responsible for damage or injury caused by improper use of this appliance.
This equipment is not designed for maritime use or for use in mobile installations such as recr eational vehicles or aircraft. However , under certain conditions it may be possible for an installation in these applications. Please contact the nearest Miele dealer or the Miele T echnical Service Department with specific requirements.
When loading tableware, place sharp items away from the door seal to prevent damage to the seal. Load knives pointing downwards to prevent injuries. Only use detergents and rinse aids recommended for r esidential dishwashers. Keep all detergents and rinse aids out of the reach of childr en.
A VER TISSEMENT – Lorsque v ous utilisez votre lave-v aisselle, veuillez prendre des précautions essentielles, y compris ce qui suit. Lisez attentivement l’ensemble des consignes av ant d’installer ou d’utiliser le lave-v aisselle afin de prévenir les blessures et éviter d’endommager l’appareil.
Installation L ’installation et les réparations devraient être ef fectuées uniquement par un technicien de service autorisé Miele. Les travaux effectués par des personnes non qualifiées peuvent s’avérer danger eux et annuler la garantie.
Utilisation N’utilisez le lave-vaisselle que lorsque tous les panneaux sont bien en place. Ne jouez pas avec les commandes. Afin de diminuer le risque de blessures, ne laissez pas les enfants jouer près de l’appareil ni monter dedans ou dessus. Évitez de malmener la porte ou les paniers du lave-vaisselle ou de vous y appuyer ou asseoir .
Energy sa ving washing This dishwasher is exceptionally economical in the use of water and electricity . For best results follow these tips: ^ For lowest energy consumption and the gentlest washing of china and crystal, connect the dishwasher to a cold water source.
W ash cabinet 1 Upper spray arm (not visible) 2 Cutlery tray 3 Upper basket 4 W ater feed for middle spray arm 5 Middle spray arm 6 Lower spray arm 7 Four height adjustable feet 8 T riple Filter Syste.
Contr ol panel 13 "On/Off" button 14 Program list/indicators 15 Check/Refill indicators 16 Program sequence display 17 "Start/Stop" button 18 "T op solo" button 19 Program selection buttons 20 Child Safety Lock 21 Door release 22 Drying vent Every dishwasher is tested before leaving the factor y .
T o open the door ^ Press the r elease catch inside the door grip. If the door is opened during operation, the dishwasher will stop running. Once the door is closed the program will restart. T o close the door ^ Push the baskets in. ^ Lift the door and push until it clicks into position.
W ater softener T o achieve good cleaning results, the dishwasher needs soft water . Hard water results in calcium deposits on dishware and in the dishwasher . If your tap water hardness is above 8 gr/gal (values are in US gallons) (140 ppm), the water should be softened.
Programming the water softener If your water is over 8 gr/gal the salt reservoir must be filled with salt. Y our water hardness level must be programmed into the dishwasher using the buttons on the control panel. ^ Make sure the dishwasher is turned off.
25 - 70 gr/gal: ^ Press the pr ogram selection button % (19) until the "Rinse" (16) indicator begins to flash. This is the second program level. ^ Use the program selection buttons (19) to select the program which corresponds to the local water hardness in your ar ea.
Filling the salt reservoir If your water hardness level is gr eater than 8 gr/gal, the salt reservoir should be filled before the first use and when the "Salt" indicator lights. Only use water softener salt specially formulated for dishwashers.
Salt indicator When the salt reservoir is empty , the "Salt-PC" indicator will light, indicating that it should be refilled with reactivation salt. After the reservoir has been filled, the water softener is automatically reactivated the next time the dishwasher is started.
Rinse aid Rinse aid is recommended to pr event spotting on dishes and glassware. , Filling the rinse aid reservoir with detergent will damage the reservoir . Only pour rinse aid formulated fo r residential dishwashers into the reservoir . Adding rinse aid ^ Add rinse aid before the first use and whenever the "Rise aid" indicator lights.
Adjusting the dosage The dosage selector is preset to 3. This dispenses approximately 3 ml of rinse aid per program. It can be adjusted from 1 to 6. ^ Use a higher setting if spots appear on dry glassware. ^ Use a lower setting if streaking appears on dishes or glasses.
, Do not wash items soiled with ash, sand, wax, grease or paint in the dishwasher . Ash and sand do not dissolve and will be distributed throughout the inside of the dishwasher . W ax, gr ease and paint will cause permanent discoloration or damage to the dishwasher .
Items not recommended f or dishwashing – Cutlery with wooden handles. – Wooden cutting boar ds. – Glued items such as old knives with handles glued together around the shank of the blade. – Hand made craft items, antique, metal trimmed or decorative glassware.
Cutlery tray (SC units) The removable cutlery tray makes unloading flatware easy . Simply carr y the cutlery tray to where the flatware is stored and put the entir e basket away in one trip. For easier unloading cutler y should be grouped in zones, one for knives, one for forks, one for spoons, etc.
Upper basket Adjusting the upper basket On select models, the upper basket can be raised or lowered to accommodate tall items. ^ Slide out the upper basket. ^ Pull up the levers at the sides of the upper basket and adjust the basket height. ^ Release the levers and the basket will lock in place.
Adjustable cup rac ks Raise the rack to make room for tall glasses. Lower it to double stack smaller pieces. Coffee bar T o allow water to run off the bottom of coffee mugs, place them slanted on top of the coffee bar . The bar can also be used to separate two rows of glasses.
Lower basket For larger and heavier items such as plates, serving platters, sauce pans, bowls. Height limit The guide at the front of the upper basket determines the maximum height for items placed in the lower basket so that the middle spray arm is not blocked.
Additional inserts for the upper and lower baskets may be purchased from your Miele dealer or the Miele. V ase / Bottle holder T o wash milk or baby bottles, attaches to the lower basket. Upper Basket Glassware Insert T o wash long stemmed glassware, attaches to the upper basket.
Adding deter gent , Dishwasher detergents contain irritant and corrosive ingr edients. Keep children away fr om detergent. Do not fill the detergent dispenser until you are r eady to start the dishwasher . Only use powder detergents or tablets formulated for residential dishwashers.
Running the dishwasher ^ Make sure the spray arms are not blocked. ^ Close the door . ^ T urn on the dishwasher . The "Start/Stop" indicator (17) will flash and a program indicator (14) will light. ^ Select a wash program using the program selection buttons (19).
At the end of a pr ogram The "End" indicator will light when the program has finished. ^ T urn off the dishwasher . ^ Open the dishwasher door slightly to allow the dishes to cool before unloading. It is advisable to turn off the water supply if the dishwasher will not be used for a period of time (e.
Pr ogram guide Program When to use Program cycle Pre- wash 12 Main wash Interim rinse 12 Final rinse Dry- ing Pots & Pans For heavily soiled pots and pans with dried on food Main wash temperature .
Additional f eatures "T op Solo" (18) Using "T op Solo" will save water and energy . This program is r ecommended when there is only a small load to clean. "T op Solo" can be selected with all programs. With this feature, water is dir ected only to the top and middle spray ar ms in the dishwasher .
Extended drying If desired drying results ar e not consistently achieved, the turbother mic cooling fan can be programmed to run an extra 14 minutes at the end of each program. The "Extended drying" feature can also be activated to prevent condensation from collecting on the steam deflector .
With the aid of the following guide, minor problems can be fixed without a service call. , Repairs should only be carried out by a qualified and trained technician in accordance with local and national safety r egulations. Unauthorized r epairs could cause personal injur y or machine damage.
What if … P ossible fault Fix the "Intake/Drain" indicator flashes and the program stops? The triple filter in the wash cabinet is clogged. Clean the filter , see maintenance instructions. The drain pump or the non-return valve may be blocked.
What if … P ossible fault Fix there is a knocking noise in the wash cabinet? The spray arm is hitting an item in the basket. Interrupt the program, rearrange items blocking the spray arms. there is a rattling noise? Items are not secur e in the wash cabinet.
What if … P ossible fault Fix tea or lipstick stains have not been completely remo ved? The wash temperature of the selected program was too low . Select a program with a higher temperature.
What if … P ossible fault Fix plastic items are discolored? Natural dyes e.g. from vegetables may be the cause. Not enough detergent was used to break down natural dyes. Use more detergent, see "Adding detergent". Discoloration is permanent.
In the event of a fault which you cannot correct yourself please contact the Miele T echnical Service Depar tment. U 1-800-999-1360 techserv@mieleusa.com V 1-800-565-6435 service@miele.ca When contacting the Miele T echnical Service Department, please quote the model and serial number of your appliance.
T o transport the dishwasher , e.g. when moving to a new home, note the following: – Empty the dishwasher . – Secure any loose parts, e.g. hoses, cables, cutlery baskets. – T ransport the dishwasher in the upright position. If unavoidable it may be transported on its back.
User Maintenance Instr uctions T o prevent accidents and machine damage, read these instructions bef ore installation or use. 41.
T riple filter system The triple filter system in the base of the wash cabinet prevents food fr om being redeposited on dishes. It also pr otects the circulation pump fr om damage caused by foreign objects (e.g. br oken glass, bones). The filter system should be cleaned every 4 - 6 months or whenever a foreign object is trapped.
T o clean the underside of the filter , the flap must be opened: ^ Pull back the yellow clip. ^ Rinse all parts under running water . Scrub with a nylon brush if necessary . ^ Close the flap so that the clip engages. ^ Return the filter so it lies flat in the base of the wash cabinet.
Cleaning the spra y arms Sometimes particles of food get stuck in the spray arm jets. The spray ar ms should be inspected and cleaned ever y 4 - 6 months. ^ T urn off the dishwasher before cleaning. Remove the spray arms as follows: ^ Remove the cutlery tray (if present).
Cleaning the wash cabinet Generally , the wash cabinet is self cleaning if the correct amount of dishwasher detergent is used. The wash cabinet can be cleaned with a dishwasher cleaner such as Dis Cleaner available from your Miele dealer or the Miele T echnical Service Department.
Cleaning the water inlet filter A filter is incorporated in the intake hose attached to the dishwasher’ s shut off valve. If your water is har d, or the pipes contain sediment, this filter may clog and prevent enough water fr om entering the wash cabinet.
Cleaning the drain pump and non-return v alve If the dishwasher is not completely drained at the end of a program, the drain pump or non-return valve may be blocked. ^ T urn off the dishwasher . ^ Remove the triple filter (see "Cleaning the filter in the wash cabinet").
M.-Nr . 05 620 641 / 02 e n-U S Alterations rights reserved / G 832 Plus 1906.
An important point after buying a device Miele TOUCHTRONIC G 832 SC (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Miele TOUCHTRONIC G 832 SC yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Miele TOUCHTRONIC G 832 SC - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Miele TOUCHTRONIC G 832 SC you will learn all the available features of the product, as well as information on its operation. The information that you get Miele TOUCHTRONIC G 832 SC will certainly help you make a decision on the purchase.
If you already are a holder of Miele TOUCHTRONIC G 832 SC, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Miele TOUCHTRONIC G 832 SC.
However, one of the most important roles played by the user manual is to help in solving problems with Miele TOUCHTRONIC G 832 SC. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Miele TOUCHTRONIC G 832 SC along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
