Instruction/ maintenance manual of the product KWT 4154 UG-1 Miele
Go to page of 36
Operating and Installation Instructions Under Counter Wine Storage Unit KWT 4154 UG-1 To prevent accidents and machine damage read these instructions before installation or use.
IMPORTANT SAFETY INSTRUCTIONS .................................4 Guide to the Wine Storage Unit ......................................7 Before use .......................................................9 Turning off for longer periods of time ........
After sales service ................................................2 5 Caring for the environment .........................................2 8 Installation ......................................................2 9 Location ...........................
When using the appliance, follow basic safety precautions, including the following: Read all instructions before installation and use to prevent accidents and machine damage. This appliance is intended for residential use only. Use only as described in this Operating manual.
Installation This appliance is top-heavy and must be secured to prevent the possibility of tipping forward. Keep the door closed until the appliance is completely installed and secured per installation instructions. ~ This appliance must be installed and connected in compliance with the installation instructions.
Disposal of your old appliance ~ Before disposing of an old appliance, first make the door latch or lock unusable. ~ Take off the doors. ~ Leave the shelves in place so that children may not easily climb inside. ~ Consult with your municipal policy on recycling.
a Interior lighting b Insulation shelf for thermal separation c Wooden shelf with decorative strip for descriptive labels d Active charcoal filter e Condensate channel and drain hole Guide to the Wine.
Control panel a On/Off s button b Temperature display for upper zone c Temperature selector buttons for upper zone ( + for warmer; - for colder) d Constant humidity (Dynamic cooling) button and indica.
Before using for the first time ^ Clean the inside of the appliance and the accessories with a mild solution of warm water and liquid dish soap. Dry with a soft cloth. If the appliance was transported or laid horizontally for any reason, allow it to stand vertical for at least 8 hours before turning it on.
Wine will continue to mature depending on the surrounding conditions. The length of time which wine can be kept in good condition will therefore depend not only on the temperature but also on the air quality.
^ Press the temperature selector (+/-) buttons for the upper zone to select either Fahrenheit °F or Celsius °C : ^ To save the setting, press the constant humidity button. ^ To exit the settings mode, press the On/Off button. Otherwise, the electronics will automatically return to normal mode after approx.
Temperature display During normal operating, the temperature displays indicate the temperatures inside the unit. The temperature display will flash if: – a different temperature is being set, – the temperature in one section deviates from the set temperature by more than 5 °.
Humidity In a conventional refrigerator, the humidity levels are too low for storing wines. High humidity levels (60 - 70 %) are very important for the storage of wine, so that the corks remain moist. Under low humidity, the corks dry out from the outside and can no longer seal the bottles properly.
Air exchange through the active charcoal filter External air passes through the filter before entering the unit. The active charcoal filter ensures that only clean, odor-free air enters the unit, creating additional protection against odor contamination.
Do not remove the light covers for the display lighting. Should the lighting covers be damaged or need to be removed due to damage, do not look directly or with an optical instrument at the lighting. Turning on the interior lighting Generally, wine should be stored in dark conditions.
Storage tips – Always unpack bottles – do not store wine in crates or boxes. – Any vibration or movement of a wine bottle can interrupt the natural breathing process of the wine, which affects the taste. – Always lay bottles on their side for storage.
The appliance is equipped with an alarm system, to ensure that the temperature does not rise or fall unnoticed because of energy loss or an open door. The alarm system is always operational, it does not need to be turned on.
The safety lock can be activated to prevent the appliance from being turned off inadvertently. Activating / Deactivating the safety lock ^ Press and hold the constant humidity button for approx. 5 seconds. The constant humidity indicator light will flash, and ; will flash in the right-hand temperature display.
During normal operation, condensate and frost can form on the rear wall of the refrigerator and drawers. You do not need to remove this build-up, it will defrost and evaporate automatically with the heat generated by the appliance.
To reduce the risk of electrical shock, disconnect the appliance from the power supply by shutting off the power main, tripping the circuit breaker or unplugging the power cord before maintenance. Never use cleaning agents containing abrasive substances such as sand, soda, acids, chlorides or chemical solvents.
Door seal Do not use any oils or grease on the door seals as these will cause the seals to deteriorate and become porous over time. ^ Clean the door seal with water only and dry thoroughly. Active charcoal filters Replacement filters are available from Miele.
With the aid of the following guide minor problems can be corrected without a service call. Repairs should only be carried out by a qualified and trained person in strict accordance with local and national safety regulations. Unauthorized repairs could cause personal injury or machine damage and may void the warranty.
What if a bar is lit up or flashing in the temperature display? Only temperatures within the range of the appliance display can be shown. If the temperature is not within this range, a bar will be displayed instead. " F0 "o r" F1 " appears in the temperature display.
The appliance is making noises. Issue Possible fault Solution Brrrrr... Humming noise made by the compressor. This noise can get louder for brief periods when the motor is switching on. These noises are not a fault. The noise of the compressor and the coolant circulating in the system is unavoidable.
In the event of a fault which you cannot easily fix yourself, please contact the Miele Technical Service Department at the address on the back of this booklet. When contacting the Technical Service department, please quote the model and serial number of your appliance given on the data plate inside the appliance.
26.
Installation instructions To prevent accidents and machine damage read these instructions before installation or use..
Disposal of packing materials The cardboard box and packing materials are biodegradable and recyclable. Please recycle. Ensure that any plastic wrappings, bags, etc.
In areas with a tropical climate (over 100°F/38°C and more than 70% air humidity) the wine cooler must only be operated in air conditioned locations. Otherwise the function of the machine cannot be guaranteed. This appliance is top-heavy and must be secured to prevent the possibility of tipping forward.
The appliance is supplied right-hand hinged. If left-hand door hinging is required, follow the instructions below. ^ Close the door, and unscrew the top hinge pin from the door a . ^ Unscrew the bracket b from underneath the door. ^ Tip the door forward slightly c , and lift it up and off d .
^ Replace the plug h and the hinge pin guide i in the top of the opposite door. ^ Hang the door on the lower hinge pin j , and close the door k . ^ Refit the top hinge pin l through the hinge pin plate into the door.
Appliance dimensions * The overall height can be increased by 2" (50 mm) by adjusting the feet. Adjustments ^ Use the provided wrench to adjust the feet as needed. Preparing the appliance ^ Carefully tip the appliance backward. ^ Attach the toe-kick panel a , and loosely tighten the screws b .
Fitting the appliance into place ^ Slide the appliance into the installation niche. Ensure that the power cord does not get caught. Be sure the power outlet remains accessible.
, Avoid the risk of electrical shock - Plug into a grounded 3-prong outlet. - Do not move the ground plug. - Do not use an adapter. - Do not use an extension cord. Failure to follow these instructions can result in death, fire, or electrical shock. Improper connection of the equipment grounding conductor may result in electric shock.
35.
Alteration rights reserved / 4613 INFORMATION IS SUBJECT TO CHANGE. PLEASE REFER TO OUR WEBSITE TO OBTAIN THE MOST CURRENT PRODUCT SPECIFICATIONS, TECHNICAL & WARRANTY INFORMATION.
An important point after buying a device Miele KWT 4154 UG-1 (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Miele KWT 4154 UG-1 yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Miele KWT 4154 UG-1 - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Miele KWT 4154 UG-1 you will learn all the available features of the product, as well as information on its operation. The information that you get Miele KWT 4154 UG-1 will certainly help you make a decision on the purchase.
If you already are a holder of Miele KWT 4154 UG-1, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Miele KWT 4154 UG-1.
However, one of the most important roles played by the user manual is to help in solving problems with Miele KWT 4154 UG-1. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Miele KWT 4154 UG-1 along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
