Instruction/ maintenance manual of the product MI3005 Memorex
Go to page of 16
User’ s Guide iMove with AM/FM Radio Mi3005 Suffix A Before operating this product, please read these instructions completely ..
1 SAFETY PRECAUTIONS CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). NO USER- SERVICEABLE P ARTS INSIDE. REFER SER VICING T O QUALIFIED SERVICE PERSONNEL.
INFORMA TION: This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However , there is no guarantee that interference will not occur in a particular installation.
3 LOCA TION OF CONTROLS 1. FM Antenna 2. Left Speaker 3. iPod ® Dock with Connector & Interchangeable Holders 4. VOLUME Up/Down Buttons 5. Power Button 6. Display 7. MODE Button 8. Battery Compartment (Rear of Unit) 9. Carrying Handle 10. Right Speaker 1 1.
4 LOCA TION OF CONTROLS (CONTINUED) 1. Battery Compartment (Side of Unit) 2. TUNE Down/Skip o Button 3. VOLUME Down Button 4. MODE Button 5. VOLUME Up Button 6.
5 REMOTE CONTROL REMOTE BA TTER Y INST ALLA TION BA TTER Y PRECAUTIONS Follow these precautions when using a battery in this device: 1. Use only the size and type of battery specified. 2. Be sure to follow the correct polarity when installing the battery as indicated in the Battery Compartment.
6 POWER SOURCE AC CONNECTION Insert the small end of the AC adapter into the POWER IN jack (located on the rear of the unit). Connect the AC cord to the adapter and connect the other end to a wall outlet having 120V AC, 60 Hz.
7 INSERTING AN IPOD ® Plug the unit in or insert batteries as described on page 6. + – + – + – + – + – + – + – + – 1 Locate the correct iPod ® holder to use as shown on pages 1 1-12. Slide the holder downward as shown to insert. 2 If using the dock : With the iPod ® and the Mi3005 OFF , insert the iPod ® onto the holder .
8 OPERA TION With an iPod ® connected (see previous page), turn the Mi3005 on by pressing the Power button (if it is not on already). 1 1 Operate the iPod ® as per its owner ’ s manual and the sound will be heard through the Mi3005’s speakers. Adjust the volume as desired by pressing the V olume Up/Down buttons.
9 OPERA TION (CONTINUED) T urn the Mi3005 on by pressing the Power button; the display will light. 1 1 Press the MODE button to select the desired band (AM or FM). 1 2 Repeatedly press the TU NE Up/Down/Skip n / o buttons to manually advance the frequency in the display up or down until the desired frequency appears.
10 OPERA TION (CONTINUED) Follow Steps 1-3 on the previous page to tune a station. Press the SET button “P1” (if no presets have ever been set), will blink. 1 1 Press the TUNE Up/Down/Skip n / o buttons 1 (or you can also press the PRESET button) to select a desired Preset (P1-P5).
11 OPERA TION (CONTINUED) IPOD ® HOLDER Locate your iPod ® in the chart on the next two pages and select the respective holder (the Holder No. is engraved at the top of the holders) to match with your iPod ® . Insert the corresponding holder and your iPod ® into the unit as described on page 7.
12 OPERA TION (CONTINUED) iPod ® T ype Me m or y Holder No. 2 to 4GB iPod ® nano 30GB 60GB No. 8 Fifth Generation iPod ® (w/Video) No. 9 No. 10 NOTE: • The 8 holders provided with this unit are for use with this unit only; they are not Universal Docks.
13 TROUBLESHOOTING GUIDE If you experience a problem with this unit, check the chart below before calling for service. SYMPTOM CAUSE SOLUTION No sound. V olume is Increase volume. set to minimum. AM or F M, no so un d. Power is not on. Press the Power button, then the MODE button to select AM/FM.
14 SPECIFICA TIONS GENERAL: Power Source .............DC 12V (8 x 1.5V ‘D’ size batteries) ...............................Alkaline is recommended for longer life ...................................DC IN 12V Adapter (Center Positive) Speaker . ....
Memcorp, Inc. Weston, FL Printed in Hong Kong Visit our website at www .memorexelectronics.com.
An important point after buying a device Memorex MI3005 (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Memorex MI3005 yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Memorex MI3005 - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Memorex MI3005 you will learn all the available features of the product, as well as information on its operation. The information that you get Memorex MI3005 will certainly help you make a decision on the purchase.
If you already are a holder of Memorex MI3005, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Memorex MI3005.
However, one of the most important roles played by the user manual is to help in solving problems with Memorex MI3005. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Memorex MI3005 along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
