Instruction/ maintenance manual of the product 4280 Walk-a-bout Meco
Go to page of 16
Gas Grill MODEL 4280 WALK -A A -B B OUT ® O O W W N N E E R R ’ ’ S S M M A A N N U U A A L L LP cylinder not included FOR YOUR SAFETY If you smell gas: 1. Do not attempt to light appliance. 2. Extinguish any open flame. 3. Disconnect from fuel supply .
© Meco Corporation ® 2006 — NOTICE — MECO CORPORA TION STRIVES TO BE A QUALITY SUPPLIER OF CONSUMER PRODUCTS. IF WE OMITTED ANY P ARTS NEEDED FOR ASSEMBL Y , OR YOU NEED TROUBLESHOOTING INFORMA TION, PLEASE CONT ACT US USING OUR TOLL FREE NUMBER.
P ARTS LIST AND ILLUSTRA TIONS 2 3 5 1 4 PA RT S LIST ITEM DESCRIPT ION PA RT # QTY. 1 Owners Manual 03.6097.00 1 2 Cooking G rid 03.7000.00 1 3 Grid B racket 03.6103.00 4 4 Hood Handle 03.6102.00 1 5 Leg Insert 03.6114.00 2 6 Screw, T ap 6-20 x 3/8" Type AB 03.
4 SETTING UP YOUR GAS GRILL T o reduce the risk of a cut, pinching or other bodily injury: · Wear protective gloves when handling p arts that could have sharp edges. · Be careful while folding and unfolding the Grill legs. STEP 1) Lock Hood and Bowl with the Hood Latch.
5 NOTE: Y our Gas Grill uses a 1 lb. Disposable LP Cylinder but a 20 lb. cylinder can be used with a 4 ft adapter hose purchased separately from a local ret ailer .
A TT ACH LP CYLINDER TO GAS GRILL 1) Make sure the Control Knob is in the “LOCK/ OFF” position. 20 LB. LP CYLINDER 2) Remove the Cylinder Protective Cap from the LP cylinder gas nozzle. 3) Hold 1 lb. LP cylinder upright. Push the LP cylinder nozzle into regulator nipple and turn clockwise.
OPERA TING AND MAINT AINING YOUR GAS GRILL BEFORE USING YOUR LP GAS GRILL USING GAS CARBON MONOXIDE HAZARD · This appliance can produce carbon monoxide which has no odor . Using it in an enclosed sp ace can kill you. · Never use this appliance indoors, on recreational vehicles, or boat s.
LIGHTING THE GAS GRILL 8 6) If Grill burner fails to light, repeat S teps 2-4. If the burner fails to light after three or four attempt s following S teps 2-5, turn control knob to the “Off” position. W ait five minutes; then repeat the lighting procedure.
9 Y our burners have been preset by the manufacturer for optimal flame performance. A blue flame, possibly with a CHECK YOUR FLAME Check the flame before each cooking session and throughout the grilling season. Always check especially after long periods of storing the grill.
1) Make sure the Cooking Grid is clean. (See Cleaning the Grill.) 2) Open the top Hood vent, then open the Hood all the way . 3) Place the Cooking Grid in the bowl and light the grill. 4) T urn the control knob to “High” for 3-8 minutes and preheat the grill.
11 How to Clean the Burners: 1) Open the hood and remove the Cooking Grid. 3) Lift the burner up and move it toward the rear of the Grill. Repeat for the other Burner . 4) Use a pipe cleaner to clear obstructions or insect nests from the air inlet holes and V enturi end.
1) Wrap aluminum foil around the Burners to prevent insect s from entering the burner holes. Before next use, remove aluminum foil from Burners. 2) T o maintain the condition and extend the life of your grill, cover the unit when stored outside for any length of time, especially during the winter months.
Raises up while filling then stop s when full. IMPORT ANT NOTICE (Only if using a 20 lb. LP Cylinder and an adapter hose) The Gas Grill is can be setup to operate with a LP Gas Cylinder equipped with an OPD (Overfilling Prevention Device). This is a secondary device to prevent the overfilling of your LP Gas cylinder .
Problem: Possible Cause: Solution: Burner will not light with the Ignitor or match Not pausing long enough befor e click ing the Ignitor Button W hen lighting the Bur ner, push-in and turn Regulator knob counter-c lockwise to the high position. Pus h in Ignitor button several tim es so that it clic ks eac h time.
MECO CORPORA TION LIMITED W ARRANTY This product is warranted to the original consumer purchaser against defects in material and workman- ship under normal outdoor household use and correct assembly (if assembled by the consumer-purchas- er). All parts are warranted for a period of (90) days from the date of purchase.
P/N 03.6097.00 REL. 3/06 Aussie ® by Mec o ® 16.
An important point after buying a device Meco 4280 Walk-a-bout (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Meco 4280 Walk-a-bout yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Meco 4280 Walk-a-bout - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Meco 4280 Walk-a-bout you will learn all the available features of the product, as well as information on its operation. The information that you get Meco 4280 Walk-a-bout will certainly help you make a decision on the purchase.
If you already are a holder of Meco 4280 Walk-a-bout, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Meco 4280 Walk-a-bout.
However, one of the most important roles played by the user manual is to help in solving problems with Meco 4280 Walk-a-bout. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Meco 4280 Walk-a-bout along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
