Instruction/ maintenance manual of the product 100 WATT STEREO AMPLIFIER Manley
Go to page of 10
MANLEY LABORATORIES, INC. OWNER'S MANUAL MANLEY 100 W ATT STEREO AMPLIFIER MANLEY LABORATORIES, INC. 13880 MAGNOLIA AVE. CHINO, CA. 91710 TEL: (909) 627-4256 FAX: (909)628-2482.
CONTENTS INTRODUCTION 3 MAINS CONNECTIONS 4 CONNECTING YOUR AMPLIFIER 5 BIAS PROCEDURES 6 OPERATIONAL NOTES 7 SPECIFICATIONS 8 WARRANTY 9 WARRANTY REGISTRATION 10 SECTION PAGE.
INTRODUCTION ! THANK YOU!... for choosing the Manley Euro 100 Stereo Amplifier. Designed by David Manley, the Manley Euro 100 Stereo Amplifier uses only the best available components, with the shortes.
MAINS CONNECTIONS Your amplifier has been factory set to the correct mains voltage for your country. The voltage setting is marked on the serial badge, located on the rear panel. Check that this complies with your local supply. Export units for certain markets have a moulded mains plug fitted to comply with local require- ments.
CONNECTING YOUR AMPLIFIER Setting up your amplifier is rather easy. 1. Connect all source components (turntable, CD, Tuner, Tape DAT, etc.) to your preamplifier. 2. Connect the interconnects from the output of the preamplifier or switching center to the RCA input on the top rear of the amplifier.
BIAS PROCEDURES The Manley Euro Stereo 100 is a fixed bias system that requires very little attention. If you wish to adjust or check the bias, follow the following steps. 1. On diagram 2, which depicts the top panel of the amplifier, you can see 4 black tip jacks and 1 green tip jack.
OPERATIONAL NOTES SWITCHING ON The power switch is located on the lower left hand corner of the front panel. Push the top of the rocker switch (1) to turn on the amplifier and the bottom of the rocker to turn off the amplifier. The LED on the right side of the front panel will illuminate indicating that the amplifier is operating.
SPECIFICA TIONS Vacuum Tubes: 4 x Γ Y50 (Output), 2 x 6350 (Driver), 2 x 12AT7 (Input) Output Power 88 Watts @1Khz 1.5%THD, into 5 ohms Frequency Response, +/- .
W ARRANTY All Manley Laboratories equipment is covered by a limited warranty against defects in materials and workmanship for a period of 90 days from date of purchase to the original purchaser only.
WARRANTY REGISTRATION We ask that you please fill out this registration form and send the bottom half to: MANLEY LABORATORIES REGISTRATION DEPARTMENT 13880 MAGNOLIA AVE. CHINO CA, 91710 Registration entitles you to product support, full warranty benefits, and notice of product enhancements and upgrades.
An important point after buying a device Manley 100 WATT STEREO AMPLIFIER (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Manley 100 WATT STEREO AMPLIFIER yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Manley 100 WATT STEREO AMPLIFIER - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Manley 100 WATT STEREO AMPLIFIER you will learn all the available features of the product, as well as information on its operation. The information that you get Manley 100 WATT STEREO AMPLIFIER will certainly help you make a decision on the purchase.
If you already are a holder of Manley 100 WATT STEREO AMPLIFIER, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Manley 100 WATT STEREO AMPLIFIER.
However, one of the most important roles played by the user manual is to help in solving problems with Manley 100 WATT STEREO AMPLIFIER. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Manley 100 WATT STEREO AMPLIFIER along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
