Instruction/ maintenance manual of the product SN20 Manitowoc Ice
Go to page of 2
Manitowoc SN12/SN20 Model Nugget Ice Machines Cutter Head Replacement Instructions 1. Disconnect water supply. 2. Remove front panel. 3. Move toggle switch to CLEAN position after the 5 mi nute delay expires. The evaporator and float chamber will drain.
7. Peel evaporator insulation down to expose 3 bolts securing top cutter head - remove 3 bolts. 7. Use puller to remove cutter head from auger shaft. NOTE: If the bearing is destroyed or the auger heavily damaged from bearing wear contact the Manitowoc service department @ 1-800-545-5720.
An important point after buying a device Manitowoc Ice SN20 (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Manitowoc Ice SN20 yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Manitowoc Ice SN20 - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Manitowoc Ice SN20 you will learn all the available features of the product, as well as information on its operation. The information that you get Manitowoc Ice SN20 will certainly help you make a decision on the purchase.
If you already are a holder of Manitowoc Ice SN20, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Manitowoc Ice SN20.
However, one of the most important roles played by the user manual is to help in solving problems with Manitowoc Ice SN20. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Manitowoc Ice SN20 along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
