Instruction/ maintenance manual of the product 3370 Majestic Appliances
Go to page of 26
R A D I A N CE Radiance V ent Free Gas Heater Model RUVSOD: 3370 thru 3379 20004555 8/03 Rev . 8 Homeowner ’ s Installation and Operating Manual INST ALLER: DO NOT DISCARD THIS MANUAL - LEA VE FOR HOMEOWNER D E S I G N C E R T I F I E D 4555 This is an unvented gas-fired heater.
2 Vermont Castings Radiance Vent-Free Gas Heater 20004555 Installation and Operating Instructions ....................................................................................... 3 Stove Dimensions ..............................................
3 Vermont Castings Radiance Vent-Free Gas Heater 20004555 Installation & Operating Instructions In order to ensure safe and effective installation, this unit must be installed only by a qualified .
4 Vermont Castings Radiance Vent-Free Gas Heater 20004555 31" (787mm) 29 ³⁄₄ " (756mm) RADIANCE 18 ³⁄₈ " (465mm) 11 " (279mm) 28 ¹⁄₄ " (717mm) 6 ¹⁄₂ " (165mm) Drawing Not to Scale 4555 Supply Inlet Fig.
5 Vermont Castings Radiance Vent-Free Gas Heater 20004555 Clearance Requirements Minimum Clearances to Combustible Materials Maintain clearance, (empty space), between combus- tible materials and the heater as specified below. Hearth Requirements The Radiance Unvented heater must be installed on rigid flooring.
6 Vermont Castings Radiance Vent-Free Gas Heater 20004555 Firebox weight / shipping 175 lbs. The installation of your Vermont Castings stove must conform with local codes, or in the absence of local codes, with the National Fuel Gas Code ANSI Z223.1 - latest edition.
7 Vermont Castings Radiance Vent-Free Gas Heater 20004555 Vent Free Features The Radiance RUVSOD, Model Nos. 3370 thru 3379, is an unvented gas heating appliance tested and listed to the ANSI standard Z21.
8 Vermont Castings Radiance Vent-Free Gas Heater 20004555 W ARNING This heater shall not be installed in a confined space unless provisions are made for adequate combustion and ventilation air .
9 Vermont Castings Radiance Vent-Free Gas Heater 20004555 Read these instructions thoroughly before starting the assembly. Follow procedures in the order given. Inspect the stove for damage before starting the assembly. Do not install this stove if any damage is evident.
10 Vermont Castings Radiance Vent-Free Gas Heater 20004555 Install Optional Fan It is easiest to install the optional fan kit #2767/FK26, before the stove is moved to its final location or con- nected to the gas line. The fan consists of a blower assembly and a rheostat switch that are connected by a wire harness.
11 Vermont Castings Radiance Vent-Free Gas Heater 20004555 4. Attach the fan assembly to the fan bracket provided in the log box. Use #10 sheet metal screws provided with fan kit. Do not remove finger guard screws.(Fig. 10) 5. Connect snapstat leads. Disconnect the snapstat module from the leads inside the snapstat bracket.
12 Vermont Castings Radiance Vent-Free Gas Heater 20004555 MOT OR SNAPST A T ON/OFF RHEOST A T WHT WHT BLK BLK BLK GRN BLK POWER Fig. 15 #2767 / FK26 Fan Wiring Diagram Disconnect power before servicing.
13 Vermont Castings Radiance Vent-Free Gas Heater 20004555 Glass & Catalyst Installation CAUTION: Air shutter must be removed when installing glass and catalyst for proper operation. 1. Remove left and right log bracket assembly by unfastening the two screws which hold the burner in place.
14 Vermont Castings Radiance Vent-Free Gas Heater 20004555 Install Log Set 1. Remove the logs from their packaging, and inspect each piece for damage. DO NOT INST ALL DAM- AGED LOGS. 2. Install the rear left log by placing it on the sheet metal shelf at the back of the firebox.
15 Vermont Castings Radiance Vent-Free Gas Heater 20004555 5. Loosely sprinkle the lava rocks directly on top of the burner just behind decorative grate. (Fig. 25) Use the lava rock to cover brackets on the burner . Do not place lava rocks toward back of burner .
16 Vermont Castings Radiance Vent-Free Gas Heater 20004555 Operation The Radiance is shipped with the operable door front plate. The stove may be operated with the doors either open or closed. To open the front doors, insert the handle provided into the door latch stub and turn it to the right and up.
17 Vermont Castings Radiance Vent-Free Gas Heater 20004555 3. Open control access panel. 4. Push in gas control knob slightly and turn clockwise to "OFF". Do not force. 5. Close control access panel. 1. STOP! Read the safety information above.
18 Vermont Castings Radiance Vent-Free Gas Heater 20004555 T roubleshooting Follow these procedures in the order presented. W ARNING TURN OFF HEA TER AND ALLOW TO COOL COMPLETEL Y BEFORE SER VICING. CONDITION POSSIBLE CAUSE SOLUTION No spark at pilot when Ignitor is operated.
19 Vermont Castings Radiance Vent-Free Gas Heater 20004555 T roubleshooting cont’d. CONDITION POSSIBLE CAUSE SOLUTION Pilot lights but flame goes out when Control Knob is released. 1. Control Knob not fully depressed or held in long enough. 2. Gas supply line shut-of f valve is not fully open.
20 Vermont Castings Radiance Vent-Free Gas Heater 20004555 The following procedures will help ensure that your heater continues to perform safely and efficiently. Firebox Cleaning and Inspection Cleanliness is critical to correct operation of the heater.
21 Vermont Castings Radiance Vent-Free Gas Heater 20004555 Catalytic Combustor The combustor should be cleaned annually to ensure optimal performance. Follow the procedure below. Remove the Combustor Module 1. Be sure the heater is COLD. 2. Remove the front plate, top grille and screen.
22 Vermont Castings Radiance Vent-Free Gas Heater 20004555 P ILO T O N O F F PILOT ADJ L O H I TPTH TH TP 1a 1b 1c 2 4 6 7 13 3 23 8 16 17 18 5 10a,b 21 19 9 20 24a,b, c,d 11 a 11 b 15 25 27 28 29 22 .
23 Vermont Castings Radiance Vent-Free Gas Heater 20004555 Radiance V ent Free Gas Heater (RUVSOD) Models 3370 thru 3379 (continued) Ref. Description RUVSOD 7. Trim ON/OFF Switch 53606 8. Handle Package, Ceramic w/Screw 0004342 9. Damper Steel Handle/Screw 5004265 10a.
24 Vermont Castings Radiance Vent-Free Gas Heater 20004555 Optional Accessories Fan Kits FK26 Fan The FK26 fan helps distribute heated air from within the firebox out into the room. The fan is controlled by a snapstat that turns power on and off as the firebox temperature rises above and falls below a preset temperature.
25 Vermont Castings Radiance Vent-Free Gas Heater 20004555 BASIC WARRANTY Vermont Castings , Majestic Products (hereinafter referred to collectively as the Company) warrants that your new Vermont Cast.
410 Admiral Blvd. • Mississauga, Ontario, Canada L5T 2N6 • 905-670-7777 www .majesticproducts.com • www.vermontcastings.com Ve r mont Castings, Majestic Products.
An important point after buying a device Majestic Appliances 3370 (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Majestic Appliances 3370 yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Majestic Appliances 3370 - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Majestic Appliances 3370 you will learn all the available features of the product, as well as information on its operation. The information that you get Majestic Appliances 3370 will certainly help you make a decision on the purchase.
If you already are a holder of Majestic Appliances 3370, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Majestic Appliances 3370.
However, one of the most important roles played by the user manual is to help in solving problems with Majestic Appliances 3370. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Majestic Appliances 3370 along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
