Instruction/ maintenance manual of the product 4900 Series Magnadyne
Go to page of 8
OWNER’S MANUAL Models: 4900 Series 4960 Series V ehicle Immobilizers This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference; and (2) This device must accept any interference received, including inter ference that may cause undesired operation.
Silencer products have been designed to provide the consumer with years of trouble-free operation. This manual will provide reference for the operation and maintenance of your new Silencer vehicle immobilizer system. Please, take a moment to read this manual so you will be familiar with the opera- tion of your new system.
3 Each time the system is disarmed using the transmitter the device will begin a protection mode countdown. This is a timed secondary protection mode. If you do not start your vehicle within 60 seconds, your Silencer system will become rearmed and your engine will become disabled again.
4 The Valet Mode allows you to temporarily turn off the passive arming function, eliminating the need to give your transmitter to a parking attendant or garage mechanic. T o enter the Valet Mode, follow these steps: 1. Press the “Disarm” button on your transmitter to insure the device is disarmed (you will hear 2 beeps).
When this Silencer model is armed, the engine will not crank over . This is how to identify a 4900 sys- tem. Perform the following procedure to activate the override function: 1. T urn the ignition key all the way to the “Start” position and hold it there for 10 seconds, then turn it “Off”.
Emergency Override 1. T urn the ignition key to the "Crank" position, then turn the key off. Repeat this procedure 1 more time. 2. Wait for 10 seconds 3. T urn the ignition key to the "Crank" position, then turn the key off. Repeat this procedure 1 more time.
T o replace or remove the batteries for storage in your transmitter follow these steps: 1. T urn the transmitter over and locate the slot at the edge of the transmitter case. 2. Use a small flathead screwdriver to pry apart the top and bottom case of the transmitter while keeping the button side facing downward.
4900-UM Rev . G 5-11-06 © Copyright 2006 Magnadyne Corporation 3 Y ear W arranty Y our new Silencer ® Security Systems is warranted to be free of defects for 3 years.
An important point after buying a device Magnadyne 4900 Series (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Magnadyne 4900 Series yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Magnadyne 4900 Series - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Magnadyne 4900 Series you will learn all the available features of the product, as well as information on its operation. The information that you get Magnadyne 4900 Series will certainly help you make a decision on the purchase.
If you already are a holder of Magnadyne 4900 Series, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Magnadyne 4900 Series.
However, one of the most important roles played by the user manual is to help in solving problems with Magnadyne 4900 Series. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Magnadyne 4900 Series along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
