Instruction/ maintenance manual of the product None M.E.Y. Equipment
Go to page of 8
M. E. Y. EQU IPMENT MOWER MANUA L 200 COLLIER ROAD, BAYSWATER. WESTE RN AUSTRALIA 6053 TELEPHONE (08) 9370 1110, FACSIMILE (0 8) 9370 2566 Web Site: www.mey.com.a u Email: info@mey.com.au INTRODUCTION The technical data and service recommendations referred to in this maintenance manual relates to M.
• Exercise extreme caution w hen changing direction on slopes; • Do not mow excessively steep slopes; • Use extreme caution when reversing or pulling t he lawnmower towards you; • Stop the cut.
GENERAL RECOMMENDATIONS • The mower / motor shoul d not be reclined more than 45 ° when adjusting the bl ade setting, servicing the machine or loading it onto trailers or other transport. This is to pre vent sump oil entering the combustion chambers.
OPERATING INSTRUCTIONS Before you start the mow er: 1. Check the engine oil. Ensure that the mower is st ationary and on level ground. R emove the grey filler cap at the front of the engine and check the oil level using the dipstick . Low levels will result in serious engine damage and overfilling can result in loss of power or sm oking.
• Turn the fuel tap, situated on the side of the carburettor, to the ON positio n. • Move the grey choke lever, situated on the side of the carburetto r, to the choke position. • • • • Check that the cylinder and drive clutch levers are in the disengaged positi on.
FRONT ROLLER CAM HEIGHT ADJUSTE RS The two cams fitted to the front roller of M.E.Y mowers enable the operator t o quickly change the cutting height to suit varied conditions and requir ements. See Fig 4 Loosen one front roll er end bolt at a time, with the special spanner provided.
CUTTING CYLINDER Frequent fine a djustment of the cylinder to the bott om blade will give the best cutting performance and extend th e period between sharpening. The design of the cylinder enables the trailling edge to be sharpened while the machine i s in operation.
TO REMOVE THE FRONT ROLLER Turn off the petrol and tur n the engine to Top Dead Centre Lay back mower on 20 litre drum or catcher. Remove the bolts at each end of the front roller shaft. Repair as found necessary and refit. Note, the two bearings are secured with circlips behind the end seals.
An important point after buying a device M.E.Y. Equipment None (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought M.E.Y. Equipment None yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data M.E.Y. Equipment None - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, M.E.Y. Equipment None you will learn all the available features of the product, as well as information on its operation. The information that you get M.E.Y. Equipment None will certainly help you make a decision on the purchase.
If you already are a holder of M.E.Y. Equipment None, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime M.E.Y. Equipment None.
However, one of the most important roles played by the user manual is to help in solving problems with M.E.Y. Equipment None. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device M.E.Y. Equipment None along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
