Instruction/ maintenance manual of the product LF2020 Lumex
Go to page of 20
SIT -T O-ST AND P A TIENT LIFT Models LF2020 & LF2090 O WNER’S MANU AL LF2020-INS-LABRevB06 ©GF Health Products, Inc. 2006 IMPOR T ANT: READ THIS MANU AL BEFORE OPERA TING Y OUR P A TIENT LIFT.
.
LF2020/LF2090 Sit-To-Stand Patient Lift Owner’s Manual 3 CONTENTS INTRODUCTION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .4 SPECIAL NOTES . . . . . . .
LF2020/LF2090 Sit-To-Stand Patient Lift Owner’s Manual 4 Congratulations on your purchase of a Lumex patient lift. The following pages will provide you with important safety and operating instructions on the use of patient lifts, slings, and accessories, as well as maintenance and warranty information.
LF2020/LF2090 Sit-To-Stand Patient Lift Owner’s Manual 5 W ar ning: W ar ning notices as used in this manual apply to hazar ds or unsafe practices which could r esult in personal injur y . Caution: Caution notices as used in this manual apply to hazards or unsafe practices that could result in property damage.
LF2020/LF2090 Sit-To-Stand Patient Lift Owner’s Manual 6 W ar ning: The LF2020/LF2090 Sit-T o-Stand Patient Lift should be used solely for transfer ring a patient from one object (beds, bathtubs, toilets, etc.) to another . The lift should not be used for transpor ting or moving any patient fr om one location to another location.
LF2020/LF2090 Sit-To-Stand Patient Lift Owner’s Manual 7 If the patient lift is to be reshipped by common carrier, it should be packed in the same carton/s in which it was received. Unpacking 1. Check for any obvious damage to the carton or its contents.
LF2020/LF2090 Sit-To-Stand Patient Lift Owner’s Manual 8 ASSEMBL Y INSTRUCTIONS 1. Open the box and take lift out. 2. Unscrew nuts and bolts at top and bottom of the mast. 3. With one hand on the mast and another on the boom, stand the mast up. 4. Put bolts through the bottom two holes at the base of the mast and hand tighten them.
LF2020/LF2090 Sit-To-Stand Patient Lift Owner’s Manual 9 1. Position the patient in a sitting position. 2 . Slide the sling down patient’s back to lumbar position. 3. Draw the shoulder straps to the front of the patient close to the chest. 4. Draw the waist belt around patient’s waist and press together to fasten.
LF2020/LF2090 Sit-To-Stand Patient Lift Owner’s Manual 10 Lift and Transfer Fr om Bed 1 . Fit sling as described in “Fitting Lumex Sit-To-Stand Sling”. 2. Push lift towards patient. Open the base of the lift. Apply the brakes on both rear casters.
LF2020/LF2090 Sit-To-Stand Patient Lift Owner’s Manual 11 Lift and Transfer Fr om Chair 1 . Fit sling as described in “Fitting Lumex Sit-To-Stand Sling”. 2. Push lift towards patient. Open the base of the lift to go around the chair. Apply the brakes on both rear casters.
LF2020/LF2090 Sit-To-Stand Patient Lift Owner’s Manual 12 CHECKING THE BA TTERIES 1 . Check batteries by pressing the Battery Testing Button (blue circle with a battery sign) on the control box. 2. Batteries are fully charged when all lights on the Battery Indicator are "ON".
LF2020/LF2090 Sit-To-Stand Patient Lift Owner’s Manual 13 Proper care and maintenance is essential to keeping your Lumex patient lift in safe operating condition. In addition to inspecting the unit before each use, periodic maintenance checks should be done as needed.
LF2020/LF2090 Sit-To-Stand Patient Lift Owner’s Manual 14 MAINTENANCE SCHEDULE Item Inspect initially Inspect/ adjust daily Inspect/ adjust monthly Inspect/adjust every 6 months Base, Casters, and F.
LF2020/LF2090 Sit-To-Stand Patient Lift Owner’s Manual 15 TROUBLESHOOTING Symptom Possible Cause Action Control box is not responding and relay is not clicking Batteries discharged Battery charger d.
LF2020/LF2090 Sit-To-Stand Patient Lift Owner’s Manual 16 LF2020/LF2090 SIT TO ST AND P A TIENT LIFT SPECIFICA TIONS Note: All dimensions giv en in inc hes unless otherwise specif ied. Base width Open: 43" Closed: 26" Base height (Clearance): 6" Overall base length 50" Lifting height range Note: As measured from sling hooks.
LF2020/LF2090 Sit-To-Stand Patient Lift Owner’s Manual 17 GF Health Products, Inc. warrants the LF2020/LF2090 Sit-To-Stand Patient Lift against defects in materials and workmanship as listed below: .
LF2020/LF2090 Sit-To-Stand Patient Lift Owner’s Manual 18 THE FOREGOING WARRANTY IS EXCLUSIVE AND IN LIEU OF ALL OTHER EXPRESSED WARRANTIES AND IMPLIED WARRANTIES, INCLUDING BUT NOT LIMITED TO THE I.
LF2020/LF2090 Sit-To-Stand Patient Lift Owner’s Manual 19 NOTES.
U.S.A., Corporate Headquar ters: Graham-Field Health Products 2935 Northeast Parkway Atlanta, Georgia 30360 telephone: 800-347-5678, 770-447-1609 fax: 800-726-0601, 678-291-3232.
An important point after buying a device Lumex LF2020 (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Lumex LF2020 yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Lumex LF2020 - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Lumex LF2020 you will learn all the available features of the product, as well as information on its operation. The information that you get Lumex LF2020 will certainly help you make a decision on the purchase.
If you already are a holder of Lumex LF2020, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Lumex LF2020.
However, one of the most important roles played by the user manual is to help in solving problems with Lumex LF2020. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Lumex LF2020 along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
