Instruction/ maintenance manual of the product Xelos A 42 Loewe
Go to page of 46
1 - 233–32789.021 Operating Instructions TV ■ Xelos A 42 ■ Xelos A 37 ■ Xelos A 32 ■ Xelos A 26 ■ Modus L 42 ■ Modus L 37 ■ Modus L 32 Neu für 5. Auflage: Seite 3: Abbildung geändert Seite 39: Abbildungen geändert Seite 42: Kontr astverhältnis 1200:1 bei 37“ BA32789_021XelosModusRel_5_GB.
- 2 Contents Remote control - TV functions 3 Control unit 4 Connections to rear panel 5 – 7 Welcome 8 – 9 Integrated features 8 Scope of delivery 8 T ransporting 8 Installation options 8 Notes on .
3 - - 3 Remote contr ol – TV functions Switch on/off - on stand by Select station up (1 Blue button: (3 programme info on/off Y ellow button: (3 previous station Freeze picture on (1 Status display .
- 4 DR+ Station up, in the menu: right Switch TV set on/off to standby Station down, in the menu: left Display: red = standby green = operation orange = operation without scr een display (radi.
5 - Antenna/cable/analogue/digital Audio output left/right (analogue) Audio input left/right (analogue) Center audio input (analogue) Headphone connection S- VHS connection (A VS) (i.
- 6 Connections to r ear panel – Xelos A 32/37 and Modus L 32/37 ✳ Set-specific equipment and retrofitting options for PIP and satellite tuners, see pages 44 and 45.
7 - 89352.001 SERVICE VGA/XGA HDTV IN AUDIO OUT AUDIO DIGI TA L IN LR OUT AUDIO IN L SD/HD-COMPONENT IN C/ P rr Y C/ P bb R C AV 2 RGB / YUV ( ) AV 1 ANT -TV ANT -S AT 13/18 V /350 mA 5 V /80 mA HDMI DVI ( ) Common interface (CI-Slot) Headphone connection S- VHS input (A VS) (i.
- 8 W elcome T ransporting Only transport the unit in an upright position. Hold the set by the top and bottom edges of the housing. The plasma/LCD scr een is made of glass and/or plastic and may break if not handled carefully .
9 - Call up the Index using the INFO button on the remote control, select “DRM (Digital Refresh Mode)“ and start the Refresh mode by pr essing the OK button. Al- ternating full-screen colour images will be displayed now instead of the TV picture. Run the Refresh mode for about as long as a freeze pictur e was displayed earlier .
- 10 F or your safety For your safety and to avoid unnecessary damage to your TV set, please read and observe the following safety instructions: • This TV set is designed exclusively for reception and reproduction of video and audio signals.
11 - First installation Remote control Batteries T o insert or change the batteries, press on the arrow . Slide the battery compart- ment cover downwards and remove it. Insert LR 03 alkaline-manganese batteries (AAA) and ensure that the + and - ends are positioned corr ectly .
- 12 First installation If the reception conditions are good, then a r oom antenna may be used for DVB- T . Passive and active r oom antennas are available on the market.
13 - First installation Automatic progr amming Automatic programming of the TV set is started the first time you switch it on. F ollow the menus. Settings can be selected by pressing one of the directions ... ... and confirm your settings by pressing OK .
- 14 First installation Directing DVB- T antenna Note: not with DVB- T stations in UK. If you use a room antenna to receive one or mor e DVB- T stations that have picture and sound interference, then you should change the location of where the antenna is set up.
15 - Daily oper ation Changing stations ... with the P+/P- buttons on the remote control Stations up/down When changing, the station display is visible for a few seconds. If additional languages are broadcast with DVB stations, then the set displays the language/sound selection under the station display .
- 16 Daily oper ation Set the bass tones by using . If you want to make other sound settings, move up with to “Bass“ and select with , e.g. “more... “. Y ou can also move up further to “Sound“ by using and select other settings in the TV menu (such as picture settings).
17 - Daily oper ation For the info system ... For each menu point, an info text is displayed at the top of the picture to help you with the setting. This saves you from having to refer back to the oper ating instruc- tions. We shall demonstrate this using the station sear ch option as an example: Call the TV menu.
- 18 Daily oper ation For the index ... Using the index, you can access many operational functions directly . Y ou can also find a great deal of information on technical terms about television.
19 - Setting the sound Volume and other fr equently used sound settings Setting the volume by using or OK , you can call other sound settings ... and select using ... use for the related selection/setting... ... and use to make the selection/setting there.
- 20 Oper ating modes – TV TV In initial installation and daily operation, the TV set is in TV mode. This is also the case when none of the other modes of operation, such as EPG, T eletext, PIP or Radio, have been selected. Each of these operating modes has a separate menu with separ ate functions for the coloured keys.
21 - Oper ating modes – TV Calling additional functions Select additional functions such as Image+ ✳ , T eletext subtitles, Personal teletext pages, Headphone volume, Scan stations and to move the picture up and down. Call timer overview If timer recordings have been pr ogrammed, you will see when which station is recorded her e.
- 22 DVB subtitles If the station provides DVB subtitles, then you can have the TV display them permanently or suppress their display . You can also select between subtitles “for translation“ or “for impaired hearing“. 1. Call the “TV menu“ via the MENU button.
23 - Oper ating modes – TV Removing the CA module 1. Switch the TV set off with the mains switch. 2. Remove the cover from the back of the set on the upper left. 3. Press the eject button at the module slot; the module is unlocked. 4. Remove the module from the set.
- 24 Oper ating modes – TV Image+ Image+ is a picture improvement specially developed by L oewe, which delivers a sharper , lifelike and colour-fast picture richer in detail and contr ast. Image+ is not integrated in the Xelos A26/32 sets. Image+ menu Call the menu “ Additional functions“.
25 - Picture in pictur e (PIP) Note: The coloured keys do not work as described below with DVB- T stations in UK, but they operate as described on page 30 (Digital T eletext). Picture in picture displays ar e possible if the set has an analogue PIP tuner or a di- gital satellite tuner in addition to the analogue TV cable tuner .
- 26 Oper ating modes – PIP Functions in the PIP menu In the PIP menu, you can set the PIP type (small picture or split screen) and the position of the small picture. Call the PIP menu (PIP must be active, green bar/frame) Setting the PIP type Y ou can have the PIP picture displayed as a small PIP or split screen.
27 - Oper ating modes – EPG When receiving digital terrestrial and digital satellite stations, you may find that two identical EPG data are displayed in the “EPG (DVB)“ menu for one station.
- 28 Oper ating modes – EPG In front of the progr amme’s title, the system places an . This station is switched later to this programme when the set is switched on. If the TV is off , it switches on again automatically at the beginning of the marked programme if this has been set in the EPG menu.
29 - Oper ating modes – T eletext In Multiple pages , scroll using . Y ou can see which multip- les pages can be called in the bottom menu line. Call contents page 100 Call the TOP table The TOP table is a gener al list of teletext. Y ou can only call the table for stations that use the TOP oper ating system.
- 30 Oper ating modes – T eletext Programme timer r ecordings A video and/or DVD recorder must be connected and logged in in the connection wizard. Call the programme pages of the curr ent station in teletext mode using the Direct recording button .
31 - Oper ating modes – Radio Radio Y ou can only receive radio stations via DVB. If you do not have any DVB radio reception, you can play a sound signal from an external device using the TV set via the sound/A V inputs. Use the RADIO button on the remote control or the R on the control ring of the TV set to switch the radio on or off .
- 32 Oper ating additional equipment Search for and store the station of the video r ecorder (if no Euro- A V cable is available) Switch on the test station on the VCR or insert a recor ded tape and start playback. In some video recorders the station must be switched on by activating the modu- lator .
33 - Oper ating additional equipment Timer r ecording with video or DVD recor der Y ou can programme timer recor dings on the TV set. Programming can be done with the EPG programme guide (not with DVB- T in UK), teletext or manually . Call the “Timer list“ menu with the button and press the red colour ed key for the “Recording wizard“.
- 34 Oper ating additional equipment Audio output “ AUDIO DIGITAL OUT“ The digital audio signal is applied at the “ AUDIO DIGIT AL OUT“ socket of the TV . For example, you can connect an external digital audio amplifier or the Loewe Auro system here.
35 - Oper ating additional equipment Connecting Loewe DVD Pr eceiver Auro 2216 PS and Individual Sound loudspeaker system Y ou can play audio signals from the TV or DVD player in cinema quality with these components.
- 36 Oper ating additional equipment Connecting other audio amplifiers or active speakers In the connection wizard, select “ HiFi/A V amplifier “ under “Equipment selection: audio component“.
37 - Oper ating additional equipment HDMI (DVI) connection The HDMI connection (High Definition Multimedia Interface) allows digital picture and sound transmission via a connecting cable, e.
- 38 Oper ating additional equipment Sound from PC or Set T op Box Feed the analogue audio signal from the PC or the S TB to the sockets AUDIO IN L/R on the TV via a cinch cable.
39 - Oper ating additional equipment Set remote control The specified key combination must be pressed (approx. 5 s) until one of the LEDs flashes twice.
- 40 What to do, if ... Problem The “Recording“ menu point is not displayed in the TV menu. “Connections“ cannot be called in the TV menu (deactivated) The control of the Loewe video r ecorder and the timer do not work or do not work properly .
41 - Problem Digital Link Plus does not function. V arious characters are displayed incorr ectly in the teletext. No sound via external digital audio amplifier Possible cause a) Euro- A V cable is not fully wired (pin 10 not wired). b) Some recorders can only adopt stations during the initial installation of the TV set.
- 42 T echnical data General data T ype Xelos A 26 Xelos A 32 Xelos A 37 Xelos A 42 Order no., versions DVB-T/C CI 66416x87 66418x87 66419x87 66421x87 Versions DR+ DVB-T/C CI – 66418x47 66419x47 664.
43 - ✄ The code number 3001 cancels out a secret code and with it the child lock. Please keep in a safe place. T echnical data Electrical data Chassis name L 2650 Power supply 220 V -240V/50- 60 Hz .
- 44 Accessories Wall holders and stands Refer to the notes on the installation options on page 8. PIP tuner The PIP tuner enables picture in picture displays (PIP) for analogue terr estrial and cable reception. Y ou can retrofit either this PIP tuner or a digital satellite tuner .
45 - Accessories Retrofitting options The following table shows the equipment and retrofitting options for the individual device versions. Device version Equipment Item no.
- 46 Service addr esses Printed in Germany 5/02.07/10,0/Ps Subject to modi fi cations Kjaerulff 1 A/S C.F . Tietgens Boulevard 19 5220 Odense SØ, Denmark T el. +45 - 66 13 54 80 Fax +45 - 66 13 54 10 Email mail@kjaerulff1.com Gaplasa S.A. Conde de T orroja, 25 28022 Madrid, España T el.
An important point after buying a device Loewe Xelos A 42 (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Loewe Xelos A 42 yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Loewe Xelos A 42 - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Loewe Xelos A 42 you will learn all the available features of the product, as well as information on its operation. The information that you get Loewe Xelos A 42 will certainly help you make a decision on the purchase.
If you already are a holder of Loewe Xelos A 42, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Loewe Xelos A 42.
However, one of the most important roles played by the user manual is to help in solving problems with Loewe Xelos A 42. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Loewe Xelos A 42 along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
