Instruction/ maintenance manual of the product SSB-i & s--01 Lochinvar
Go to page of 12
Electric booster water heaters are available for operation on standard power systems. Check the nameplate for the proper power supply . All internal electrical connections have been made at the factory . See Circuit Breaker and Fuse Sizing Chart for supply wire size, fuse, breaker and conduit recommendations.
PRESSURE REDUCING V AL VE Proper operation of the dishwater rinse nozzles requires available water pressure at the nozzle be between 15 and 25 psi when nozzle is operated.
OUTLET Using a 3/4 in. union and piping connect the booster heater water outlet to the dishwasher sanitizing rinse pipe connection. Install a temperature/pressure gauge in outlet line. W ater temperature at outlet should be 180°F (82°C). The temperature sensing element must be in water stream.
CAUSE C Thermostats may not be functioning correctly or may be improperly set. SOLUTION - Inspect thermostats for proper operation and correct settings. If setting is below the maximum, reset to 190ºF(88ºC) If defective and not functioning, replace.
CAUSE B Control thermostat may be set too high or be defective. SOLUTION - Reset thermostat(s). If condition is not corrected, replace thermostat(s). CHA TTERING CONT ACTOR(S) OR NOISY RELA Y . CAUSE A Contactors chatter or hum excessively when pulled in.
6 HIGH TEMPERA TURE LIMIT SWITCH RECALIBRA TION If the temperature in the heater exceeds 210ºF (99ºC), the high temperature limit will shut off the power . The switches must be manually reset by pushing the red buttons. The limit switch has been calibrated at the factory and should not require adjusting.
7 CIRCUIT BREAKER AND FUSED DISCONNECT SWITCH SIZES kW VOL TS PH L1 L2 L3 Breaker or Fuse Size Copper Wire Size Conduit Size 6 208 1 29 29 — 40 8 1/2” 208 3 14 25 14 40 8 3/4” 240 1 25 25 — 40.
8 DIMENSIONS HANGING SUPPORT.
9 PLUMBING CONNECTIONS.
10.
11.
CP-2M-4/03-Printed in U.S.A..
An important point after buying a device Lochinvar SSB-i & s--01 (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Lochinvar SSB-i & s--01 yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Lochinvar SSB-i & s--01 - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Lochinvar SSB-i & s--01 you will learn all the available features of the product, as well as information on its operation. The information that you get Lochinvar SSB-i & s--01 will certainly help you make a decision on the purchase.
If you already are a holder of Lochinvar SSB-i & s--01, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Lochinvar SSB-i & s--01.
However, one of the most important roles played by the user manual is to help in solving problems with Lochinvar SSB-i & s--01. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Lochinvar SSB-i & s--01 along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
