Instruction/ maintenance manual of the product Processor Apple
Go to page of 7
073-0670 Re v . A ð Xserve Processor Replacement Instructions F ollow the instructions in this sheet carefully . F ailure to f ollo w these instructions could damage your equipment and v oid its w arranty . Note: Online instructions covering customer-installab le par ts are av ailab le at http://www .
Xserve Processor - 2 4. If the ser v er is in the loc k ed position (the y ellow security LED on the front panel is on), use the Allen ke y that came with the server to unloc k it. 5. If the cable management arm is not in use, unplug all e xternal cables e xcept the power cord.
Xserve Processor - 3 9. Grasp the thumbscre ws and slide the bottom housing f orward part wa y to e xpose the two chassis le v ers . (Figure 2) 10. While depressing both le v ers , pull the bottom housing all the w a y forw ard and remo v e it from the rac k.
Xserve Processor - 4 Removing the Installed Pr ocessor 1. Release the latch on the heatsink duct (Figure 3) , and remov e the duct from the ser v er . Figure 3 2. Release the three captiv e screws that secure the heatsink. (Figure 4) 3. Lift the heatsink straight up and remo ve it from the server .
Xserve Processor - 5 4. Lift the processor straight up to disconnect it from the logic board and remo ve the processor from the ser v er . (Figure 5) Figure 5 Installing the Replacement Pr ocessor 1. P osition the replacement processor over its logic board connector and press do wn, being careful not to touch any chips on the board or processor .
Xserve Processor - 6 3. Using the thermal grease included with the replacement processor , apply one dot of fresh grease to the middle of the MPU (or both MPUs if the server is a dual processor). W ARNING: Before reinstalling the heatsink, you must be sure to apply thermal grease to the MPU.
Xserve Processor - 7 Closing the Serv er 1. Carefully slide the bottom housing back into the r ack. 2. Tighten the front thumb screws to secure it. W arning: Never turn on the server unless all of its internal and external parts are in place and it is closed.
An important point after buying a device Apple Processor (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Apple Processor yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Apple Processor - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Apple Processor you will learn all the available features of the product, as well as information on its operation. The information that you get Apple Processor will certainly help you make a decision on the purchase.
If you already are a holder of Apple Processor, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Apple Processor.
However, one of the most important roles played by the user manual is to help in solving problems with Apple Processor. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Apple Processor along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
