Instruction/ maintenance manual of the product Parabody 807 Life Fitness
Go to page of 18
1 807 BODYSYSTEM WORKOUT CENTER CLASS H PAR T # 7052601 REV . B Revision: 07/09/01 USER’S GUIDE W ARNING: Read and follow all directions for each step to insure proper assembly of this product.
THERE IS A RISK ASSU MED BY IND IVIDUALS W H O USE THIS TY PE OF EQUIPMENT. TO MINIMIZE RISK F OLLOW THE SE RULES ! 1. Before u sing, read al l the w arnings and in structions on the use of this mach ine. Use only for in tended exercise. DO NOT mo dify the m achine.
IMPOR T ANT NOTES Please note: T ools Required for Assembly * Thank you for purchasing the ParaBody 807 Gym System. Please read these instructions thoroughly and keep them for future reference. This product must be assembled on a flat, level surface to assure its proper function.
1 Square = 1’ X 1’ 4 1’ 2’ 3’ 4’ 5’ 6’ 7’ 1’ 5’ 4’ 3’ 2’.
P AR TS LIST KEY 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 5 PA R T # 7058908 6407508 61 1 1002 6406602 6407802 6407302 6407202 6024702 6406401 6406501 .
0 1 2 34 5 6 1/2 1/2 1/2 1/2 1/2 1/2 FIGURE 1 STEP 1: 28 4 25 10 31 • Attach eight PARAGLIDE STRIPS (31) to the WOLFF SLEEVE (4) (FOUR ON EACH END) as shown in FIGURE 1 using the following steps: • Thoroughly clean all surfaces where the PARAGLIDE STRIPS are to be attached.
7 FIGURE 2 STEP 2: 4 10 5 2 • Pull back the SPRING PIN on the WOLFF SLEEVE (4) and slide it over the end of the BENCH FRAME (2) as shown in FIGURE 2. Engage the SPRING PIN into one of the adjustment holes. • Insert two 2” SQ. END CAPS (33) into both ends of the BASE LEG (5) as shown in FIGURE 2.
8 FIGURE 3 33 33 1 STEP 3: • Secure the WOLFF SLEEVE (4) in place with one THUMBSCREW (29). • Insert four 2” SQ. END CAPS (33) into the BASE TUBES of the UPRIGHT FRAME (1) as shown in FIGURE 3.
9 FIGURE 4 1 31 STEP 4: 30 6 29 • Attach eight PARAGLIDE STRIPS (31) to both UPRIGHT TUBES on the UPRIGHT FRAME (1) (FOUR ON EACH END) as shown in FIGURE 4 using the following steps: • Thoroughly clean all surfaces where the PARAGLIDE STRIPS are to be attached.
10 FIGURE 5 13 STEP 5: 9 3/8 X 1” 15 20 4 0 1 2 34 5 6 1/2 1/2 1/2 1/2 1/2 1/2 • To assemble the SEAT PAD (13) to the WOLFF SLEEVE (4), start by sliding two HINGE TABS (9) over the PIN of the WOLF.
11 FIGURE 6 9 STEP 6: 14 3/8 X 1” 15 20 4 • To assemble the BACK PAD (14) to the WOLFF SLEEVE (4), slide the two remaining HINGE TABS (9) over the PIN of the WOLFF SLEEVE (ONE ON EACH SIDE) as sho.
12 FIGURE 7 7 23 STEP 7: 12 0 1 2 34 5 6 1/2 1/2 1/2 1/2 1/2 1/2 • Insert one 1-3/4” SQ. END CAP (23) into the top of the LEG EXTENSION NECK (7) as shown in FIGURE 7. • Slide two ROLLER PADS (12) over each end of the SHAFT of the LEG EXTENSION NECK (7), as shown in FIGURE 7, and secure in place using two 3/4” STARLOCK COLLARS (27).
FIGURE 8 STEP 8: 23 32 13 • Insert three 1-3/4” SQ. END CAPS (23) into the ends of the LEG EXTENSION (8) as shown in FIGURE 8. • Insert two 1/2” FLANGE BEARINGS (26) into the BUSHING on the LEG EXTENSION (8) as shown in FIGURE 8.
14 FIGURE 9 STEP 9: 2 • When ready to perform LEG CURLS or LEG EXTENSION, pull up slowly on the front of the BENCH FRAME (2) and allow the U-PIN (10) to rest on top of the TAB of the BASE LEG (5).
15 FIGURE 10 1 STEP 10: 3 • Set the HEIGHT ADJUSTMENT BAR (3) across the UPRIGHT FRAME (1) as shown in FIGURE 10, for performing INCLINE, or MILITARY PRESSES. When performing DIPS, use the HEIGHT ADJUSTMENT BAR (3) to hold the BACK PAD forward as shown in the WORKOUT MANUAL.
MAINTENANCE MODEL #________________________ SERIAL #_________________________ DA TE OF PURCHASE: _____________ DEALERS NAME: _________________ DEALERS PHONE #_______________ 16 * W e recommend cleaning your product (pads and frame) on a regular basis, using warm soapy water .
17 NOTES: LIMITED W ARRANTY ParaBody extends the following LIMITED WARRANTY to the original owner of the ParaBody products. The W arranty terms apply to IN HOME USE ONL Y . 1. LIMITED W ARRANTY ON FRAME AND WELDS. If the frame of the ParaBody product or a weld should crack or break, it will be repair ed or replaced by ParaBody .
INTERNA TIONAL OFFICES Life FitnessAtlantic BV Atlantic Headquarters Bijdorpplein 25-31 2992 LB Barendrecht The Netherlands Phone: (180) 646 666 Fax: (180) 646 703 Life Fitness Japan 8/F , Nippon Brunswick Building 5-27-7 Sendagaya Shibuya-Ku, T okyo 151-0051 Japan Phone: 81 (3) 3359-4309 Fax: 81 (3) 3359-4307 Life Fitness (UK) Ltd.
An important point after buying a device Life Fitness Parabody 807 (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Life Fitness Parabody 807 yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Life Fitness Parabody 807 - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Life Fitness Parabody 807 you will learn all the available features of the product, as well as information on its operation. The information that you get Life Fitness Parabody 807 will certainly help you make a decision on the purchase.
If you already are a holder of Life Fitness Parabody 807, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Life Fitness Parabody 807.
However, one of the most important roles played by the user manual is to help in solving problems with Life Fitness Parabody 807. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Life Fitness Parabody 807 along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
