Instruction/ maintenance manual of the product PLI-3110 LevelOne
Go to page of 10
Ver. 1.0.0 PLI-3110 HomePlug Pro PoE User Manual.
1 Safety FCC This equipment has been tested and found to comply with Part 15 Class B of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference (2) This device must accept any interference received, including interference that may cause undesired operation.
2 Table of Contents 1 HOMEPLUG PO WERLINE ............................................................................................................. ......................3 1.1 I NTRODUCTION .........................................................
3 1 HomePlug Powerline HomePlug Powerline is an excellent solution that can be us ed to extend your network. In the home or small office building, use HomePlug Ethernet Bridge Adapters to link mult iple locations without the need to run Ethernet cable.
4 Front Panel LEDs Pow er On - Normal operation. Off - No power HomePlug On - The Powerline network is active. This means that at least one other HomePlug de- vice was detected. Off - Powerline network is not available - no other HomePlug devices were detected.
5 Rear Panel The rear panel contains an AC Power Cord Plug (100-240V ), a Security Button, a recessed Reset Button, and an Ethernet Port for 48V-802.3af PoE enabled device. 1.4 Setup Plug and Play Installation for Homes: HomePlug is plug and play device; user is able to plug and play without any complex configuration and settings.
6 2 Security Button This section describes how to use Security butt on for configuration in the following situations: Creating a new security network Two unassociated Adapters ( Adapter A and Adapter B ) are forming a new network—Network AB The procedure is as follows: 1.
7 The procedure is as follows: 8. Press and hold the security button on Adapter C for 10 seconds and release it when device LED auto reboots. The password to Adapter C becomes “Random_C” 9. Press and hold the security button on Adapter A for 2 seconds.
8 3 Operation Operation is completely automatic, and no user intervention is required. If your HomePlug devices have difficulty communi cating with each other, check the following: • Try plugging the unit into an adjacent plug. • Use a pin and hold the Reset Button down for two sec onds on each unit you are trying to connect.
9 4 Specification Powerline Standards HomePlug AV PHY Rate Up to 200 Mbps Modulation 1024/256/64/16/8 QAM, QPSK, BPSK, ROBO Carrier Modulation Forward Error Correction Turbo Codes Protocol TDMA, CSMA/CA Security 128-bit AES Encryption LEDs 1 * Power 1 * HomePlug 1 * Ethernet 1* 802.
An important point after buying a device LevelOne PLI-3110 (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought LevelOne PLI-3110 yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data LevelOne PLI-3110 - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, LevelOne PLI-3110 you will learn all the available features of the product, as well as information on its operation. The information that you get LevelOne PLI-3110 will certainly help you make a decision on the purchase.
If you already are a holder of LevelOne PLI-3110, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime LevelOne PLI-3110.
However, one of the most important roles played by the user manual is to help in solving problems with LevelOne PLI-3110. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device LevelOne PLI-3110 along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
