Instruction/ maintenance manual of the product MPDR-3328CPE Lennox
Go to page of 24
1 NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE. HOMEOWNER'S CARE AND OPERA TION INSTRUCTIONS VENTED GAS FIREPLACE HEATERS - DIRECT VENT MODELS P/N 875,014M REV.
2 NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE. These appliances are designed to operate on natural or propane gas only. Input of millivolt models is variable.
3 NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE. Maximum manifold pressure is 3.5 in. w.c. (0.87 kPa) for natural gas and 10 in. w.c. (2.49 kPa) for LP/Propane gas.
4 NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE. Electronic Appliances - To light electronic appliances refer to the de- tailed lighting instructions found in both En- glish and French on pages 14 and 15 of these instructions respectively.
5 NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE. Periodically (After the Burning Season) Maintenance Task Accomplishing Person Procedure Cleaning Firebox Interior Check Flame Patterns and Flame Heig.
6 NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE. Front Glass Enclosure Panel, Removal and Installation. To install the front glass enclosure panel, proceed as follows: 1. Retrieve the glass door frame. Visually inspect the gasket on the backside of the panel.
7 NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE. Log Placement ENSURE THAT THE FRONT GLASS PANEL IS IN PLACE AND SEALED DURING ADJUSTMENT. Adjustment CAUTION: THE ADJUSTMENT ROD AND NEARBY APPLIANCE SURFACES ARE HOT. EXERCISE CAUTION TO AVOID INJURY WHILE ADJUSTING FLAME APPEARANCE.
8 NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE. Electronic Appliance Checkout To light the burner, refer to the lighting instruc- tions on page 14 and 15 . Ensure the ignitor lights the pilot. The pilot flame should engulf the flame sensor as shown in Figure 12.
9 NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE. WIRING DIAGRAMS Wiring diagrams are provided here for reference purposes only. This information is also provided on schematics attached directly to the appliance on a pullout panel located within the control compartment.
10 NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE. NOTES:.
11 NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE. Rocker Switch Kit 80L41 FRS Unit-Mountable Rocker Switch This rocker switch kit can be installed directly in the gas valve mounting bracket (millivolt gas valve equipped fireplaces) to provide On/Off operation in lieu of a wall switch.
12 NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE. ACCESSORY COMPONENTS CONTINUED These screen panels can be installed on the glass enclosure panel to prevent direct contact with the hot glass surface. The screen panel kits cannot be used in conjunction with either of the arch door kits or door frame kits.
13 NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE. Clean faced panel kits are available to convert the standard louvered fireplaces to radiant mod- els which are more suited for finishing around the firebox opening with non-combustible ma- terials, such as tile.
14 NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE. ACCESSORY COMPONENTS CONTINUED Style View Doors - Style View Doors come in 4 beautiful styles. They are easy to install and will not require hardware to attach them to the standard glass door frame. The door includes heavy duty magnet door latches and functional twin-pane doors.
15 NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE. ACCESSORY COMPONENTS CONTINUED T all Arch Pane Door Style View Doors Continued - Style View Doors also come in a T all Arch Pane Design. T wo distinctive grille kits, the “Crescents” and “Sunrise” design, are also offered seperately .
16 NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE. LIGHTING INSTRUCTIONS – HONEYWELL AND SIT MILLIVOLT GAS VALVE FOR YOUR SAFETY READ BEFORE LIGHTING A. This appliance has a pilot which must be lighted with a piezo ignitor. When lighting the pilot, follow these instructions exactly.
17 NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE. INSTRUCTIONS D ’ ALLUMAGE – VANNE GAZ MILLIVOLT HONEYWELL ET SIT INSTRUCTIONS D'ALLUMAGE 8.
18 NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE. A. When lighting the appliance, follow these instructions exactly. B. BEFORE OPERATING smell all around the appliance area for gas. Be sure to smell next to the floor because some gas is heavier than air and will settle on the floor.
19 NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE. INSTRUCTIONS D ’ ALLUMAGE — ELECTRONIC INSTRUCTIONS D ’ ALLUMAGE POUR VOTRE S É CURIT É , LISEZ CES INSTRUCTIONS AVANT L ’ ALLUMAGE A. Lorsque vous allumez l’appareil, suivez exactement ces instruc- tions.
20 NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE. TROUBLESHOOTING THE MILLIVOL T GAS CONTROL SYSTEM 1. Spark ignitor will not light pilot after repeated triggering of ignitor button. 2. Pilot will not stay lit after carefully following the lighting instructions.
21 NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE. TROUBLESHOOTING THE ELECTRONIC IGNITION SYSTEM SYMPTOM POSSIBLE CAUSES CORRECTIVE ACTION See Below. Disconnect the two black wires from the wire nuts. Test switch(s) for continuity with a multimeter.
22 NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE. REPLACEMENT PARTS LIST GAS CONTROLS — HONEYWELL ELECTRONIC GAS CONTROLS — HONEYWELL MILLIVOLT . o NN O I T P I R C S E D l a r u t a Ne n a p o r P . o N t r a P. y t Q. o N t r a P. y t Q . 0 3e v l a V s a G2 1 M 4 217 8 L 2 81 .
23 NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE. REPLACEMENT PARTS 4 7 1 11 5 40 13 12 6 42 3 8 9 30 31 32 33 34 35 40/45 40/45 14 36 37 15 9 33/35 33/35 8 20 21 10 40/45 33/35 10 23 22 24 26 25 27.
24 NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE. Printed in U.S.A. © 2002 by Lennox Hearth Products P/N 875,014M REV. K 03/2007 Lennox Hearth Products reserves the right to make changes at any time, without notice, in design, materials, specifications, prices and also to discontinue colors, styles and products.
An important point after buying a device Lennox MPDR-3328CPE (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Lennox MPDR-3328CPE yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Lennox MPDR-3328CPE - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Lennox MPDR-3328CPE you will learn all the available features of the product, as well as information on its operation. The information that you get Lennox MPDR-3328CPE will certainly help you make a decision on the purchase.
If you already are a holder of Lennox MPDR-3328CPE, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Lennox MPDR-3328CPE.
However, one of the most important roles played by the user manual is to help in solving problems with Lennox MPDR-3328CPE. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Lennox MPDR-3328CPE along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
