Instruction/ maintenance manual of the product LEGACY/ELITE C260 Lennox
Go to page of 22
INST ALLA TION AND OPERA TION MANUAL W ARNINGS • Hot! Do not touch! The glass and surfaces of this appliance will be hot during operation and will retain heat for a while after shutting off the appliance. Severe burns may result. • Carefully supervise children in the same room as appliance.
2 T esTing i nforma Tion This manual describes the installation and operation of the Legacy™/Elite™ C/E260 non-catalytic wood heaters. These heaters meet the U.S. Environmental Protection Agency’ s emissions limits for wood heaters sold on or after July 1, 199 0.
3 c onTenTs T esTing i nforma Tion .........................................................................2 g eneral s afeTy P recauTions ................................................................2 D rafTing ...................................
4 D rafTing Y our wood stove is dependent upon a properly functioning chimney for optimum per formance. It is a high efficiency appliance that loses much less heat up the chimney than older appliances and fireplaces. For this reason it is important to match the stove to the chimney .
5 Please be patient with the heat output of your stove for the first few wee ks. The steel will go thro ugh a curing proce ss that eliminates moisture, which is deep in the steel and firebrick. This moisture will reduce initial heat output of your stove and may make it difficult to start.
6 NOTE: DIAGRAMS & ILLUSTRA TIONS ARE NOT TO SCALE. B rick i nsT alla Tion Legacy™/Elite™ C/E260 Brick Installation CAUTION: Wear gloves during brick installation in case of sharp edges inside the stove.
7 NOTE: DIAGRAMS & ILLUSTRA TIONS ARE NOT TO SCALE. Model F (1) G H J M C260 22” 55 9m m 14” 35 6m m 2 2 - 1 / 2 ” 57 2m m 5-1/4” 13 3m m 5 0 - 1 / 2 ” 12 83 m m E260 22” 55 9m m 14”.
8 NOTE: DIAGRAMS & ILLUSTRA TIONS ARE NOT TO SCALE. c himney r equiremenTs The L egacy ™/e Lite ™ c/e260 inserts are approved for use in masonry fireplaces built to UBC Chapter 37 or equivalent with a minimum 30” opening at the front of the fireplace.
9 NOTE: DIAGRAMS & ILLUSTRA TIONS ARE NOT TO SCALE. Clearance to Combusibles See “Required Clearances” on Page 7 . Fireplace Pre-Installation Preparation NOTE: LENNOX HEARTH PRODUCTS RECOMMENDS PRO- FESSIONAL INST ALLA TION BY A LICENSED AND BONDED IN ST ALL ER .
10 NOTE: DIAGRAMS & ILLUSTRA TIONS ARE NOT TO SCALE. c himney l iner i nsT alla Tion Remove the existing chimney cap and install a stainless steel liner into the chimney (if a special section has been used or drilled to attach to the insert, it must be the bottom piece).
11 NOTE: DIAGRAMS & ILLUSTRA TIONS ARE NOT TO SCALE. o Pera Ting h inTs 1. Burn only dr y , well-seasoned wood for maxi- mum heat output. In some states it is illegal to burn wet wood or anything other than clean, dry wood products.
12 NOTE: DIAGRAMS & ILLUSTRA TIONS ARE NOT TO SCALE. s T arTing anD m ainT aining a f ire Be sure to clean the Nickel or Gold Plated door with Windex brand cleaner and a very soft cloth to remove any fingerprints and residues prior to the first fire.
13 Keeping freshly loaded wood away from the window will also help. Load fresh logs in the rear of the firebox. Build up tends to occur first on the right side of the window. This is caused by the swirling motion of the exhaust gases similar to water running down a drain.
14 m aximizing y our s Tove ’ s o verall e fficiency It is important to know that for high, combustion efficient, clean burns, you will need to have sufficient temperatures insi de the fireb ox for thoro ugh combust ion . The best method for determining if you have sufficient temperatures is to watch the brick lining in your firebox.
15 Expe rime nt with differ ent load ing config urat ions to achi eve longer burns . T r y loading the wood from side to side and nesting it in the ashes to prevent airflow under and around the wood. Fresh wood should be loaded to the back of the firebox or to the sides.
16 T rouBleshooTing P roBlem s oluTion POOR DRAFT : Extend chimney in length or have the chimney realigned to the proper size flue. Oversized chimneys normally have poor drafts. Remember , the stoves’ draft depend solely on the natural draft of the chimney (See Drafting section on Page 4 ) .
17 D o ’ s anD D on ’ T DO NOT : Install or operate this stove before reading this manual. DO NOT : Close the draft beyond the point at which the flames are completely extinguished. DO NOT : Open the stove door without fully opening the draft first.
18 BL O W ER P AR T S Ca t . N u mb er De s c ri p ti on H5 6 5 5 Sp e ed Co n tr o l - W o o d I n se r t U H P B l ow er 32 0 1 4 Bl o we r P o we r Co r d H5 5 5 9 UH P 1 C a ge Bl a ck H5 6 1 8 UH.
19 Replacement Parts Model C260 BL O W ER P AR T S Ca t . N o . De s c ri p ti on H5 6 5 5 Sp e ed Co n tr o l - W o o d I n se r t U H P B l ow er H6 1 5 1 Bl o we r P o we r Co r d H5 5 5 9 UH P 1 C.
20 TO P S URR OUN D P AN E L (R EQU IRE D ) Ca t . N o . De s c ri p ti on 71 0 1 5 7- 1/ 2 ” H x 48 ” W B l a ck (T ot a l d i me nsi o n w h en i ns t a ll e d e q ua ls 2 9” x 4 8” ) 71 0 1.
21 Notes.
Printed in U.S.A. © 2007 by Lennox Hearth Products P/N 775,210M REV . B 12/2007 The manufacturer reser ves the right to make changes at any time, without notice, in design, materials, specifications, prices and also to discontinue colors, styles and products.
An important point after buying a device Lennox LEGACY/ELITE C260 (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Lennox LEGACY/ELITE C260 yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Lennox LEGACY/ELITE C260 - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Lennox LEGACY/ELITE C260 you will learn all the available features of the product, as well as information on its operation. The information that you get Lennox LEGACY/ELITE C260 will certainly help you make a decision on the purchase.
If you already are a holder of Lennox LEGACY/ELITE C260, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Lennox LEGACY/ELITE C260.
However, one of the most important roles played by the user manual is to help in solving problems with Lennox LEGACY/ELITE C260. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Lennox LEGACY/ELITE C260 along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
