Instruction/ maintenance manual of the product T150C Lennox Hearth
Go to page of 29
EPA CERTIFIED CATALYTIC FREESTANDING WOODSTOVE MODEL T150C P/N 775008M, Rev. Q, 05/02 THIS APPLIANCE MUST BE INSTALLED BY A QUALIFIED TECHNICIAN. READ MANUAL THOROUGHLY BEFORE INSTALLATION.
IMPORTA NT WA RNINGS CA UTION: PLEASE REA D THIS ENT IRE MANUA L BEFORE YOU INST A LL AND USE YOUR NEW ROOM HEA T ER. FOR YOUR SAFETY, FOLLOW T HE INSTALLA TION, OPERA T ION AND MAINTENA NCE INST RUC- TION S EXA CT LY, WITHO UT DEVIATION. FAILURE TO FOL LOW T HESE INSTRUCT IONS M A Y RESULT IN PROPERTY DA M A GE, BODILY INJURY, OR EVEN DEA TH.
PAGE 3 TA BLE OF CONTENTS Important W arnings ................................................ 2 Test ing/Listing, EPA, Using this Manual ................. 3 Planning Your Installation ...................................... 4-7 Installation ..........
PLA NNING YOUR INSTA LLATION PAGE 4 QUESTIONS T O A SK LOCAL BUILDING OFFICIA L A corr ect installation is critical and im perative f or r educ- ing fire hazards and perilous conditions that can arise when w ood burning appliances are im properly installed.
PLA NNING YOUR INSTA LLATION PAGE 5 FLOOR PROTECTION This appliance requires ½" (13 m m) m inimum non- com bustible floor protection designed f or solid fuel burn- ing appliances having a therm al c onductivity of k = .84 BTU in/f t or equivalent.
PLA NNING YOUR INSTA LLATION PAGE 6 SELECTING A L OCA TION The design of your home and where you place y our stove will determine its value as a source of heat. A woodstove depends prim arily on air circulation (convec- tion) to dispers e its heat, and therefor e, a central loca- tion is often bes t.
PLA NNING YOUR INSTALLA TION INSTA LLATION PAGE 7 REDUCED MASONRY STRUCT URE CLEA RANCE (ALCOVE) Your stove can be installed in a m asonr y structur e with reduced clearances if the structur e was built to National Building Code for f ireplaces and c himneys (UBC 37).
INSTA LLATION PAGE 8 TY PES OF CHIM NEYS The c himney is a vital part of your st ove installation. A properly built m asonry chimney or a properly installed factor y built chimney will assure a consis tent draft under a variety of w eather conditions (a sm oking s tove is usu- ally caused by a chim ney problem ).
INSTA LLATION PAGE 9 CHIMNEY HEIGHT REQUIREM ENTS The c himney must ex tend 3 feet (914 m m ) above the level of roof penetration and a m inimum of 2 feet (610 mm ) higher than any r oof surf ace within 10 feet (305 c m) (see below). Check with y our local building off icials for any additional requirem ents f or y our area.
INSTA LLATION PAGE 10 RESIDENTIAL INSTA LLATION DIA G RA M.
INSTA LLATION Combustible Wall Chimney Connector Pass-Throughs NOT ES: 1. Connectors to a masonry chimney, excepting method B, shall extend in one conti nuous section through the wall pass-through sy stem and the chimney w all, to but not past the inner f lue liner face.
PRODUCT FEA TURES A ND CONTROLS PAGE 12 PRIMARY A IR CONT ROL The prim ary combus tion air delivery is controlled by the Prim ary Air Control Assem bly (The contr ol knob is lo- cated above the fuel door ).
CA RE A ND OPERATION PAGE 13 FUEL DOOR CA UT ION: WHEN OPENING THE DOOR, DO NOT EX- TEND IT BEYOND IT S NORMAL TRA VEL. OVEREX- TENDING T HE DOOR TO A FURTHER OPEN POSITION CA N PUT EXCESSIVE STRESS ON HING E A R EA O F DOOR A ND HINGE PINS AND MA Y RESULT IN BREAK- AG E .
CA RE A ND OPERATION PAGE 14 BREA K -IN PERIOD Your stove finish is a high temperature paint that r equires time and tem peratur e to com pletely cure. W e rec om- mend that you ventilate the house during the initial bur ns. The paint em its non-tox ic odors dur ing this process .
CA RE A ND OPERATION PAGE 15 Refueling * 1. O pen the dam per by pas s control by pulling it toward y ou. 2. Set the pr imar y air control s et to high. 3. O pen the door approxim ately 1/2 inch (13 m m) , then wait for about thirty seconds. Open the door and add wood, then close the door.
FUEL PAGE 16 BURN RECOMM ENDED FUEL This appliance is approved for use with untreated natural dry w ood only (s ee Important W arnings , page 2, #8). Burning m aterials other than natural wood will s horten the life of the catalytic com bustor.
MA INTE NA NCE PAGE 17 SMALL A REA PA INT T OUCH-UP The s tove body is painted with a quality high- temper ature stove paint. Use only m odel T SPK-B Stove Paint, Catalog # 70K99.
MA INTE NA NCE PAGE 18 CREOSOTE FORMATION A ND NEED FOR RE- MOV A L What is Creo sote - W hen wood is burned slowly , it produces tar and other organic vapors, which com bine with expelled mois ture to form cr eosote. The creosote vapors condense in the relatively cool chimney flue of a slow-burning fire.
MA INTE NA NCE PAGE 19 CA T A LYTIC COM BUSTOR Your stove has been designed with a c ataly tic c ombus - tor, which will improve the overall ef ficienc y of your stove. Rem oving the com bustors for cleaning, ins pec- tion and reinstallation s hould be done at least onc e a y ear.
TROUBLESHOOTING PAGE 20 SMO KES OUT FUEL DOO R WHEN OPEN ( see ✸ ✸ ✸ ✸ ) 1. The pr imar y air control is closed. 2. The c himney is too cool. Set the prim ary air c ontrol on "HIGH" with the by pass dam per contr ol "OPEN" for a f ew minutes bef ore opening the fuel door .
TROUBLESHOOTING PAGE 21 CA TALYST SUBSTRATE CRA CKING 1. Normal operation, as long as com bustor re- mains intact. If crack ing causes large pieces to fall out, replac e com bustor. 2. Mis handling or abuse. Handle with care. 3. W arped housing (s ee Overfiring Damage on this page).
SPECIFICA TIONS: Model T150C PAGE 22 A pproximate Up to ~1800 sq. f t. Heat Capacity Up to ~550 sq. M Maximu m Burn Rate 49,027 BTU EPA BTU Range 6500 / 35,300 BTU Emissions Rate (grams/hr.) 4.1 Efficiency Rating 72% Outside A ir Provision No Maximum Log Length 22" (559 mm) Firebox Size ( cubic feet) 2.
REPLA CEMENT PA RTS FOR MODEL: T150C PAGE 23 Part No. Model Descriptio n Door Parts C15220 Door Assem bly, Cast (Handle Included) 27M83 Gask et Kit, 1/2" Medium Rope 26M23 Gask et Kit, Side W ind.
COMPONEN T DIA GRA MS: T150C PAGE 24 FIREBRICK (1 ¼” thick) Part Qty Dimen sions FB-1 9 9 x 4 ¼” Reg ular Top View Showing Brick Installed CA T A LYTIC COM BUSTOR Sys tem Components.
OPTIONA L A CCESSORIES: T150C Note: Inst all and use accessories per in structions p rovided w ith th e accessory kit. PAGE 25 Catalog # M odel Description Notes 14M36 BK- T15 Blower Kit Includes Dial.
SA FETY/LISTING LA BEL PAGE 26.
EPA LAB EL Page 27.
Page 28 OWNERSHIP RECORDS Dealer’s Nam e: Dealer’s Addres s: City : State: Zip Code: Serial Num ber: Date of Purc hase: Date Installed: Notes: SERVICE A ND M AINTENA NCE LOG Service Servic e Servi.
1110 West Taft A venue Orange, CA 92865.
An important point after buying a device Lennox Hearth T150C (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Lennox Hearth T150C yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Lennox Hearth T150C - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Lennox Hearth T150C you will learn all the available features of the product, as well as information on its operation. The information that you get Lennox Hearth T150C will certainly help you make a decision on the purchase.
If you already are a holder of Lennox Hearth T150C, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Lennox Hearth T150C.
However, one of the most important roles played by the user manual is to help in solving problems with Lennox Hearth T150C. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Lennox Hearth T150C along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
