Instruction/ maintenance manual of the product B-ENC0353VDE Lennox Hearth Products
Go to page of 24
1 NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE. HOMEOWNER'S CARE AND OPERA TION INSTRUCTIONS VENTED GAS FIREPLACE HEATERS - DIRECT VENT MODELS P/N 875,021M REV. G 03/2007 MODELS FOR YOUR SAFETY: Do not store or use gasoline or other flammable vapors or liquids in the vicin- ity of this or any other appliance.
2 NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE. CONGRATULATIONS! In selecting this LENNOX Direct-Vent Gas Appliance you have chosen the finest and most dependable fireplace to be found anywhere. A beautiful, prestigious, alternative to a wood burning fireplace.
3 NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE. Carbon Monoxide Poisoning: Early signs of carbon monoxide poisoning are similar to the flu with headaches, dizziness and/or nau- sea.
4 NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE. Figure 3 Honeywell Electronic Gas Valve Figure 2 Note: The piezo ignitor is located on the modesty panel - refer to Figure 1. Variable Flame Height Adjustment ( Millivolt Appliances only) 1. All Millivolt appliances are equipped with a variable gas control valve.
5 NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE. Maintenance The appliance and venting system should be thoroughly inspected before initial use and at least annually by a qualified service techni- cian. However, more frequent periodic inspec- tions and cleanings should be performed by the homeowner.
6 NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE. Periodically (After the Burning Season) Maintenance Task Accomplishing Person Procedure Cleaning Firebox Interior Check Flame Patterns and Flame Heig.
7 NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE. ENSURE THAT THE FRONT GLASS PANEL IS IN PLACE AND SEALED DURING ADJUSTMENT. Figure 4 Burner Adjustments The following paragraphs address burner ad- justment concerns and procedures. Flame Appearance and Sooting Proper flame appearance is a matter of taste.
8 NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE. Log Placement Carefully position the ceramic fiber logs and twigs over the burner as shown in Figures 6 (EDV3530), 7 (EDV4035) or 8 (EDV4540) on this page. Refer to the detailed log placement instructions provided in the LOG PLACEMENT GUIDE accompanying this document.
9 NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE. Figure 9 Electronic Appliance Checkout To light the burner, refer to the lighting instruc- tions on page 13 and 14 . Ensure the ignitor lights the pilot. The pilot flame should engulf the flame sensor as shown in Figure 10 .
10 NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE. These louvers are designed to replace the standard charcoal louvers that are provided with the appliance.
11 NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE. Touch-Up Paint (Charcoal) Kit 90L74 TPK-C Touch-Up Paint (Tan) Kit 98K67 TPK-T Touch-Up Paint Kit Repair of minor scratches and discoloration of the appliance charcoal painted surfaces may be accomplished with the touch-up paint kit.
12 NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE. Style View Doors - Style View Doors come in 4 beautiful styles. They are easy to install and will not require hardware to attach them to the standard glass door frame. The door includes heavy duty magnet door latches and functional twin-pane doors.
13 NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE. ACCESSORY COMPONENTS CONTINUED T all Arch Pane Door Style View Doors Continued - Style View Doors also come in a T all Ar ch Pane Design. T wo distinctive grille kits, the “ Crescents ” and “ Sunrise ” design, are also offered seperately .
14 NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE. WARRANTY Your gas appliance is covered by a limited twenty year warranty. You will find a copy of the warranty accompanying this manual. Please read the warranty to be familiar with its coverage. Retain this manual.
15 NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE. NOTES:.
16 NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE. LIGHTING INSTRUCTIONS – MILLIVOLT GAS VALVE FOR YOUR SAFETY READ BEFORE LIGHTING A. This appliance has a pilot which must be lighted with a piezo ignitor. When lighting the pilot, follow these instructions exactly.
17 NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE. INSTRUCTIONS D’ALLUMAGE – VANNE GAZ MILLIVOLT INSTRUCTIONS D'ALLUMAGE POUR VOTRE SÉCURITÉ, LISEZ CES INSTRUCTIONS AVANT L’ALLUMAGE A. Cet appareil est muni d ’ une veilleuse qui doit ê tre allum é e avec un allumeur pi é zo- é lectrique.
18 NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE. A. When lighting the appliance, follow these instructions exactly. B. BEFORE OPERATING smell all around the appliance area for gas. Be sure to smell next to the floor because some gas is heavier than air and will settle on the floor.
19 NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE. INSTRUCTIONS D’ALLUMAGE — ELECTRONIC INSTRUCTIONS D’ALLUMAGE POUR VOTRE SÉCURITÉ, LISEZ CES INSTRUCTIONS AVANT L’ALLUMAGE A. Lorsque vous allumez l ’ appareil, suivez exactement ces instruc- tions.
20 NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE. TROUBLESHOOTING THE MILLIVOL T GAS CONTROL SYSTEM 1. Spark ignitor will not light pilot after repeated triggering of ignitor button. 2. Pilot will not stay lit after carefully following the lighting instructions.
21 NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE. TROUBLESHOOTING THE ELECTRONIC IGNITION SYSTEM SYMPTOM POSSIBLE CAUSES CORRECTIVE ACTION See Below. Disconnect the two black wires from the wire nuts. Test switch(s) for continuity with a multimeter.
22 NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE. REPLACEMENT PARTS LIST GAS CONTROLS — HONEYWELL ELECTRONIC GAS CONTROLS — SIT MILLIVOLT . o NN O I T P I R C S E D l a r u t a Ne n a p o r P . o N t r a P. y t Q. o N t r a P. y t Q . 0 3T I S - e v l a V s a G7 0 K 3 41 3 5 J 8 81 .
23 NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE. REPLACEMENT PARTS 4 8 14 7 41 40 31 30 43 33 32 34 42 36 35 16 13 2 5 6 2 3 17 18 19 11 9 1 12 21 10 15 20 EDV4035 & EDV4540 EDV3530.
24 NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE. Printed in U.S.A. © 2003 by Lennox Hearth Products P/N 875,021M REV. G 03/2007 Lennox Hearth Products reserves the right to make changes at any time, without notice, in design, materials, specifications, prices and also to discontinue colors, styles and products.
An important point after buying a device Lennox Hearth Products B-ENC0353VDE (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Lennox Hearth Products B-ENC0353VDE yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Lennox Hearth Products B-ENC0353VDE - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Lennox Hearth Products B-ENC0353VDE you will learn all the available features of the product, as well as information on its operation. The information that you get Lennox Hearth Products B-ENC0353VDE will certainly help you make a decision on the purchase.
If you already are a holder of Lennox Hearth Products B-ENC0353VDE, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Lennox Hearth Products B-ENC0353VDE.
However, one of the most important roles played by the user manual is to help in solving problems with Lennox Hearth Products B-ENC0353VDE. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Lennox Hearth Products B-ENC0353VDE along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
