Instruction/ maintenance manual of the product ACAC40001 APC
Go to page of 9
Installation NetShelter ® AV Rack Cooling ACF600 ACF601 ACAC40000 ACAC40001.
NetShelter AV Rack Cooling Ins tallation 1 American Power Conversion Legal Disclaimer The information presented in this manua l is not warranted by the American Power Conversion Corporation to be autho ritative, erro r free, or complete.
Installing the Rack Fan Panel (ACF600) The NetShelter AV 2U rack fan panel can be used to cool individual devices or to draw air into or out of a rack. Before installing the fan panel, determine its application. 1. Determine the desired airflow direction and reverse the fans if necessary.
4. Connect the provided power cord to the fan panel. To ensure polarity protection, align TIP to +. Note: Reversing polarity will not damage the fan panel, but the fan panel will not operate until the power cord is connected correctly.
Installing the Rack Fan Temperature Controller (ACF601) The Rack Fan Temperature Controller is designed to provide on/off and variable speed fan control based on the ambient temperature of the unit. The unit features two jumper selectable on/off set points, ident ified by an ’L’ (low) and ‘H’ (high) on the unit’s circuit board.
3. Turn on the temperature controller by connecting it between the Rack Fan Panel and the supplied power cord as shown below. Note: For proper functionality, the power supply must be set to 12 Volts. Note: Observe proper polarity by connecting TIP to +.
Installing the Vent Panel (ACAC40000) and Vent Panel with Temperature Display (ACAC40001) 1. Install the Vent Panel in an open 2U space using the 10-32 t hreaded screws provided.
2. Route the sensor cable and the power cable through the hole in the center of the Fan Panel and secure the cables to the back of the Fan Panel using the provided wire ties. 3. To secure cable when routing it in either direction from the center, use the wire tie slots positioned along the edge of the Fan Panel.
NetShelter AV Rack Cooling Ins tallation 8 Customer support and warranty informati on is available at the APC Web site, www.apc.com . © 7/22/10 APC by Schneider Electr ic. APC, the APC l ogo, and NetShelter are o wne d by Schneider Electric Industries S.
An important point after buying a device APC ACAC40001 (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought APC ACAC40001 yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data APC ACAC40001 - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, APC ACAC40001 you will learn all the available features of the product, as well as information on its operation. The information that you get APC ACAC40001 will certainly help you make a decision on the purchase.
If you already are a holder of APC ACAC40001, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime APC ACAC40001.
However, one of the most important roles played by the user manual is to help in solving problems with APC ACAC40001. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device APC ACAC40001 along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
