Instruction/ maintenance manual of the product SA230WP KWorld
Go to page of 17
TVBOX 1 ONE TV BOX Instruction ............................................................02 1.1 Functions and features ...........................................02 1.2 Packaged contents ......................... .......................... .03 1.3 T echnical specifications .
© 2009 KWorld 2 Instruction The T VBox u ses the pro fessi onal pr ogres sive sca nning TV (DP TV) chi p, which a dopts en h a nc e d f ea t u r es s u c h as b l a ck l e v e l st r e tc h , v id e .
TVBOX 3 1.2 Packaged contents 1.3 T echnical specications • Power input: DC 5V , 800mA • TV System Input: 75Ω IEC or type-F • TV System Support: NTSC, P AL, Secam (Depend on the model) • V.
© 2009 KWorld 4 2.1 Diagram of remote control and buttons description TWO Remote control instructions.
TVBOX 5 1.Power/Standby button: Used for power up /standb y . At stand by mode, it is PC d irect connection state. 2.Timing button: Click this button continuously , the timing of 15-180 m inutes for shu tdown and “OFF” will be displayed on the screen in turn.
© 2009 KWorld 6 3.1 Product picture and Front Panel Description • Power/Standby , OSD menu button, i.e. Press to open OSD menu. Press 3~5 seconds to switch the Power/Standby . • Program + and program - button. THREE Hardware &installation instructions • V olume + and volume - button.
TVBOX 7 VGA: T h e 1 5 - p i n c o n n e c t o r e n d o n t h e at ta ch ed V GA c ab l e i s c on n ec te d t o t h e outp ut of vi deo card i n PC and the oth er end on the cable to the VGA port. 3.2 Rear panel description MONITOR: Connected with monitor .
© 2009 KWorld 8 3.3 Connection illustration.
TVBOX 9 1.Press the menu button on the remote control to enter the OSD menu. 2 . S e l e c t T V Tu n i n g o n t h e left of the menu and enter the submenu of T uning.
© 2009 KWorld 10 Menu I: Picture FOUR Menu Description 4.1 Menu Description Menu II: System Menu III: Display setup • C o n t r a s t , b r i g h t n e s s , C h r o m a , a n d Sh a r p n e s s ca n b e a d j u s t ed fr o m 0 t o 1 0 0 ( N o t e : S h a r p n e s s o p t i o n c a n b e displayed only if the video input is NTSC system signal.
TVBOX 11 Menu IV : Auxiliary Menu V : TV T uning Menu VI: T uning •Calendar: display year/month/d ay/week. Y ou can use “P+” /“P-” an d “VOL+” /”VOL-” to adjust year and month. • C a l c u l a t o r : o f f e r s s i m p l e c a l c u l a t i n g function.
© 2009 KWorld 12 Menu VII: T iming Menu VIII: OSD • Ti m e r O F F : u s e d t o s e t t h e t i m e f o r shutdown. It shall be changed to “on”. • T i m e r O N : u s e d t o s e t t h e t i m e f o r startup. It shall be changed to “on”.
TVBOX 13 4.3 Operations for PIP function at PC mode • At TV or PC mode, click PIP button on remote control and wait for 1-2 seconds, there will be a small window in the upper left corner of the screen and a change of sound. Y ou can click PIP button again to switch the window to the larger one.
© 2009 KWorld 14 FIVE Operations for game function A. T o enter into game: Enter into the menu and select Game under the Auxiliary menu. B. Gaming method: Box, Destination, W all. Pull every box through up, down , left and right movement. If all boxes are pulled to the destination, you can then access to this function.
TVBOX 15 SIX T roubleshooting Failure Cause and action No picture, no sound No power connection, or defective connection of plug. Receiver is at standby mode. P i c t u r e d i s p l a y e d without sound Speaker for multimedia is not connected properly .
© 2009 KWorld 16 6.3 PIP can function normally at the following PC display modes Resolution Refresh Rate 800X600 60Hz 75Hz 1024X768 60Hz 75Hz 1280X1024 60Hz 75Hz 1440X900 60Hz 6.2 PIP part Failure Cause and action After PIP turned on, sound i s n o r m a l b u t n o p i c t u r e display .
TVBOX 17 W ARRING This User ’s Manual is for specic product, and all its contents are processed with due care but are not ensured fully correct. We assume no responsibility for any loss arising from use of this manual.
An important point after buying a device KWorld SA230WP (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought KWorld SA230WP yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data KWorld SA230WP - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, KWorld SA230WP you will learn all the available features of the product, as well as information on its operation. The information that you get KWorld SA230WP will certainly help you make a decision on the purchase.
If you already are a holder of KWorld SA230WP, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime KWorld SA230WP.
However, one of the most important roles played by the user manual is to help in solving problems with KWorld SA230WP. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device KWorld SA230WP along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
