Instruction/ maintenance manual of the product GMS 955.1 Kuppersbusch USA
Go to page of 10
Gas Cooktop Installation, User and Service Instructions GMS 955.1.
1 IMPORTANT: SAVE FOR LOCAL ELECTRICAL INSPECTOR ’ S USE. READ AND SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE. OBSERVE ALL FEDERAL, STATE AND LOCAL C ODES AND ORDINANCES WARNING: If the information in this manual is not followed exactly, a fire or explosion may result causing Property damage, personal injury or death.
2 Gas Installation Requirements This appliance shall be installed by an authorized person and installed in accordance to The manufactures installation instructio ns.
3 Dimensions and D istances requirements C abinet overhead and side clearances The minimum overh ead clearances shall be in accordance with the minimum values indicated in Fig .
4 Overall and Cutout Dimensions Below are the required cutout di mensions and the overall dimensions of the cooktop as indicated in Fig. 4 Overall Cutout Inches Millimeters Inches Millimeters W 33 7/8.
5 Install the Cooktop into the cabinet. Install the supplied hold down brackets (A) to the underside of t he Cooktop using the supplied Phillips head screws (B) as shown in Fig. 6. Slide the hooks into position and secure the cooktop to the countertop.
6 Electrical Connection WARNING! This appliance is equipped wi th a three - prong grounding plug for your protection against shock hazard and should be plugged directly into a properly grounded receptacle. Do not cut or remove the grounding prong from the plug.
7 By - pass jet adjustment for low flame setting 1) Turn the right front burner on to ignite. Once lit, turn to the lowest setting (small flame). 2) Remove the knob from the cookt op and place in a secured location . Locate t he adjustment screw shown in Fig.
8 User instructions WARNING! Keep the appliance area clear and free from combustible materials, gasoline and other flammable vapors and liquids . Do not store dangerous or flammable material in the cabinet areas above the appliance. Store all flammable materials In a safe lace to avoid potential hazards.
9 Maintenance - Never use an abrasive cleaner - Before cleaning the ap pliance it is available that t he unit should be disconnected from the power supply . - Cleaning the work surface periodically . Clean the burner heads, the enameled steel pan supports and the burner caps using warn water and a mild detergent.
An important point after buying a device Kuppersbusch USA GMS 955.1 (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Kuppersbusch USA GMS 955.1 yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Kuppersbusch USA GMS 955.1 - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Kuppersbusch USA GMS 955.1 you will learn all the available features of the product, as well as information on its operation. The information that you get Kuppersbusch USA GMS 955.1 will certainly help you make a decision on the purchase.
If you already are a holder of Kuppersbusch USA GMS 955.1, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Kuppersbusch USA GMS 955.1.
However, one of the most important roles played by the user manual is to help in solving problems with Kuppersbusch USA GMS 955.1. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Kuppersbusch USA GMS 955.1 along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
