Instruction/ maintenance manual of the product 7 Kodak
Go to page of 34
Operator' s Manual A-62032 Part No. 3C4923 KO D AK IMAGELINK TM Printer 7 BUSINESS IMAGING SYSTEMS.
A-62032 November 1996 i The Kodak Imagelink Printer 7, CAT No. 887 9405, with the Kodak Imagelink Printer 7 Paper Supply, CAT No. 859 1943, the Kodak Imagelink Printer 7 Sorter, CAT No. 864 6754, and the Kodak Imagelink Printer 7 Sorter Interface, CAT No.
ii November 1996 A-62032 W arning and safety information Locate the printer in a well-ventilated room. A negligible amount of ozone is generated during normal operation of this printer. An unpleasant odor may, however, be created in poorly ventilated rooms during extensive printer operations.
A-62032 November 1996 1-1 Section 1 Overview Introduction We are pleased that you have purchased the Kodak Imagelink Printer 7. We feel confident that you will find your new laser printer more than adequate to meet your printing needs.
1-2 November 1996 A-62032 9. Paper Supply Cabinet Right Cover 10. Paper Exit Tray 11. Printer Right Cover 12. Printer Cable Interface Socket 13. Printer Rear Cover 14. Image Transfer/Paper Separator Ozone Filter Cover 15. Paper Supply Cabinet Rear Cover 16.
A-62032 November 1996 1-3 20. Vertical Transport Roller Knob (M6) 21. Separator Roller 22. Feed Roller 23. Transport Roller Knob (M5) 24. Transport Section Release Plate (M4) 25. Synchronizing Roller Knob (M3) 26. Toner Bottle Holder 27. Toner Bottle 28.
A-62032 November 1996 2-1 Check that the power cord has been connected to the printer and outlet; turn the power ON/OFF switch to its right side ( side) to turn the power on.
2-2 November 1996 A-62032 Loading paper This laser printer supplies paper to the printer by feeding paper into the unit automatically from one of four universal cassettes.
A-62032 November 1996 2-3 3. While holding the cassette, depress and spread the front paper guide wider than the paper size to be used. 4. Slide the green resin plate of the right paper guide toward the right side wider than the paper size to be used.
2-4 November 1996 A-62032 USA only Swing the lift-up plate release lever back into position to lift up the paper lift plate. To attach the paper exit tray, insert the two hooks of the paper exit tray into the lower holes of the paper exit section. Installing the paper exit tray 7.
A-62032 November 1996 2-5 Clearing paper jams When a paper jam occurs, remove the paper jammed in each section according to the following procedures. Inside the paper supply cabinet (J1 error) 1. Pull the paper cassettes out from the printer and check if the paper in each cassette is stored correctly.
2-6 November 1996 A-62032 Inside the printer (J2 or J3 error) 1. Open the front cover and release lever M2 to unlock the vacuum unit. 2. Open the transport section release plate (M4). Remove the paper by rotating the transport roller knob (M5) or the synchronizing roller knob (M3) in the direction of the arrow.
A-62032 November 1996 2-7 Inside the sorter and sorter interface unit (J4 or J6 error) 1. Press the lock release lever of the 20-bin sorter to open the sorter. 2. Open the transport guide plates (upper and lower) of the sorter to check if the paper is jammed inside the option.
2-8 November 1996 A-62032 3. Open the upper cover of the sorter interface unit and check to be sure there is no jammed paper. If there is paper, remove it and close the upper cover again.
A-62032 November 1996 2-9 Changing a toner bottle A toner bottle will print approximately 6,000 pages of A4 size paper when the black-to-white ratio on the prints is 12%. When the cartridge is out of toner, the toner empty indicator will light on the operation panel.
2-10 November 1996 A-62032 4. Check that the triangle marks on the toner bottle and the toner bottle holder face each other as in the illustration. Holding the toner bottle with your left hand, gently pull the toner seal out of the toner bottle. 5. Swing the toner bottle holder back into position.
A-62032 November 1996 2-11 Changing the toner collection bottle The used toner full indicator will appear on the operation panel approximately every 100,000 prints when the black-to-white ratio on the prints is 12%. When this indicator appears, follow the steps below to replace the toner collection bottle.
A-62032 November 1996 A-1 Appendix A Specifications General specifications Type ..................... Console-type dry electrophotographic printer Resolution ............ 400 DPI Print method ........ Laser diode, polygon mirror system Laser .........
A-2 November 1996 A-62032 Option ................. 20-Bin Sorter with Sorter Interface Unit Top Bin of sorter: 100-sheet capacity Bins 2–20: 50-sheet capacity each Paper feeding ....... Four Universal Cassettes each holding 350 sheets Paper types ..
A-62032 November 1996 B-1 Appendix B Installation considerations Space requirements The figures and illustrations below show the minimum space required for the installation of your printer.
B-2 November 1996 A-62032 Installed with sorter option 100 (4) 540 (21 1/4) 100 (4) 1006 (39 5/8) 553 (21 3/4) 1093 (43) Unit: mm (inch) 684 (27) 500 (19 3/4).
A-62032 November 1996 B-3 Installation environment Select the proper environment for using the printer to obtain the optimum service from your printer. It should NOT be placed in a location: — which is exposed to direct sunlight. — which is in the direct air stream of a cooler, heater, or ventilator.
B-4 November 1996 A-62032 Ordering information for the Printer 7 and accessories CAT No. Kodak Imagelink Printer 7 / 100 V, 50/60 Hz 104 8131 Kodak Imagelink Printer 7 / 120 V, 60 Hz 159 9646 Kodak Im.
A-62032 November 1996 C-1 Appendix C Printer 7 error , maintenance, and caution codes Error Codes Code Explanation Action Needed A0 No used toner collecting bottle. Seat the toner bottle properly; install one if necessary. A1 No EP unit. Seat the EP unit properly; install a new one if necessary*; or call service.
C-2 November 1996 A-62032 Error Codes (continued) Code Explanation Action Needed 21 The drum-charge corona has malfunctioned. Turn the printer off and then on again. If the problem persists, call for service. 22 The thermistor has malfunctioned. Turn the printer off and then on again.
A-62032 November 1996 C-3 Error Codes (continued) Code Explanation Action Needed 55 Elevator tray 2 malfunctioned. Open paper cassette #2. Check paper position, and close paper cassette. If the problem persists, call for service. 56 Elevator tray 3 malfunctioned.
A-62032 November 1996 D-1 Appendix D Maintenance Before conducting any maintenance procedures, follow these precautions: — Before beginning the maintenance procedures, be sure to turn OFF the power ON/OFF switch and unplug the printer’s power cord.
D-2 November 1996 A-62032 2. Remove the (4) paper guides by lifting them straight up. Clean the outside of housing with a soft cloth. 4. Reinstall the four paper guides. Insert the image transfer/paper separator charger onto the guides of the suction unit until the charger is locked by the front edge of the guides.
A-62032 November 1996 D-3 Cleaning the printer The printer should be cleaned on a regular basis to prevent potential malfunctions. Before cleaning the printer, be sure to turn off the power ON/OFF switch and unplug the power cord from the outlet. External cleaning Internal cleaning 1.
A-62032 November 1996 Kodak warrants this equipment to function properly for three months from date of shipment. However, certain requirements may dictate a different warranty period. This warranty covers the purchaser of this equipment as well as anyone else who owns it during the warranty period.
A-62032 November 1996 This limitation of liability will not apply to claims for injury to persons or damage to property caused by the sole negligence or fault of Kodak or by persons under its direction or control. The Kodak Imagelink Printer 7 has a rated machine life of 4.
A-62032 November 1996 Index-1 Index A Acoustic noise, A-1 Adjustable feet, 1-2 B C Cassettes (see also paper or universal cassettes) Caution codes, C-3 Circuit breaker, 1-2 Consumables handling, B-4 o.
Index-2 November 1996 A-62032 status, 2-1 test print function, 2-1 turning on and off, 2-1 Printer cable interface socket, 1-2 Printer front cover, 1-1 Printer left cover, 1-1 Printer rear cover, 1-2 .
A-62032 Part No. 3C4923 11/96 © Eastman Kodak Company, 1 996 Printed in U.S.A. Business Imaging Systems EASTMAN KODAK COMPANY Rochester, New York 14650 Kodak and Imagelink are trademarks of Eastman Kodak Company.
An important point after buying a device Kodak 7 (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Kodak 7 yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Kodak 7 - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Kodak 7 you will learn all the available features of the product, as well as information on its operation. The information that you get Kodak 7 will certainly help you make a decision on the purchase.
If you already are a holder of Kodak 7, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Kodak 7.
However, one of the most important roles played by the user manual is to help in solving problems with Kodak 7. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Kodak 7 along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
