Instruction/ maintenance manual of the product PRM200 Knoll Systems
Go to page of 6
PRM150, PRM200 Advanced Power Conditioners Installation Instructions v1.1 Warning : To be installed and/or used in accordance with appropriate electrical codes and regulations Introduction: Thank you for your purchase of a Knöll PRM150 or PRM200 Advanced Power Conditioner and congratulations on your choice.
Coaxial surge suppression is often over looked. A convenient “F” connector is provided both for cable TV and the satellite dish. This allows full surge protection through a low loss pass through connection. Telephone line surge protection is provided to bring an added measure of safety to your home.
Installation: The PRM200 power source connection must be adequate for use at 20 amps. We recommend a properly grounded 30-amp circuit, wired with 10-gauge wiring, if continuous operation near 20 amps is anticipated. A dedicated (nothing else connected) 20-amp circuit is the minimum acceptable to comply with NEC requirements.
Delayed Turn On’s . When the power conditioner is turned on, th e two outlets labelled “Delay Min” turn on immediately (along with the unswitch ed outlets already turned on). About two seconds later the next tw o outlets labelled “Delay Med” turn on.
Fuses There is a single slow blow 15-amp fuse in the PRM150 and there is a single 20 amp slow blow fuse in the PRM200. As per safety regulations, only authorized and experienced service people, including Knoll factory personnel are authorized to change these fuses.
PRM150 and PRM200 SPECIFICATIONS Current rating: PRM150 15 amps (1800 watts at 60/120 VAC, 60 HZ) fuse protected. PRM200 20 amps (2400 watts at 60/120 VAC, 60 HZ) fuse protected.
An important point after buying a device Knoll Systems PRM200 (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Knoll Systems PRM200 yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Knoll Systems PRM200 - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Knoll Systems PRM200 you will learn all the available features of the product, as well as information on its operation. The information that you get Knoll Systems PRM200 will certainly help you make a decision on the purchase.
If you already are a holder of Knoll Systems PRM200, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Knoll Systems PRM200.
However, one of the most important roles played by the user manual is to help in solving problems with Knoll Systems PRM200. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Knoll Systems PRM200 along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
