Instruction/ maintenance manual of the product KUIS185S KitchenAid
Go to page of 8
I(it,h -mlqpam Automatic Ice Maker@ lMode’ KU’s’85S.
I’ CHANGING THE BIN DOOR AND LOWER PANEL The storage bin door and lower panel are designed to accept an optional decorative wood panel of your choice. The wood panel should be no more than V4 inch (6 mm) thick. Cut it to the same size as the production metal panel.
GENERAL INFORMATION l UNPACK REMOVE INTERIOR PACKING OPEN BOTTOM FLAPS FIGURE 3 FIGURE 4 1 Lay carton on rear face and break open bottom flaps 2 Set carton upright with all four flaps outward. See Figure 3. 3 Lift carton u p and off of machine. 4 Remove all tape and packaging material from the outside and inside of the cabinet.
FOR THE PLUMBER CONNECT TO WATER (observe local codes) 1 Use l/o” OD soft copper tubing for the cold water SUPPlY. 2P ‘d rove e a convenient manual shut-off valve tn the water lrne 3 Position the tubing so It can enter the access hole located in the right-hand rear of the cabrnet.
. SCREWS FIG. 58 . REMOVE SHUNT PLUG IN -CONDENSATE PUMP FIG. 5C FOR THE ELECTRICIAN ELECTRICAL REQUIREMENTS A 115 Volt, 60 Hz, AC only, 15 Amp fused electrical supply is required (time delay fuse or circuit breaker is recommended). It is recommended that a separate circuit, serving only this appliance, be provided.
(consult your electrical inspector), a temporary adapter may be plugged into the existing 2-prong wall receptacle to mate wrth the Z&prong power supply cord.
THINGS TO REMEMBER 0 Water enters only during the defrost cycle. There- fore the first cycle will be completed without water in the system. 0 As the room and water temperatures vary, so will the amount of ice produced. This means that higher operating temperatures will result in re- duced ice production.
CUBELET CUTTER GRIDS i- 9.l/2”-1 h CUBE CUTTER GRID 1%” x 1X” Cube Grid CHECK OPERATION v Start the unit by turning the service switch to “ON” and opening the line water valve. If NOTE: Left is “OFF” - Middle is “ON” - Right is “CLEAN.
An important point after buying a device KitchenAid KUIS185S (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought KitchenAid KUIS185S yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data KitchenAid KUIS185S - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, KitchenAid KUIS185S you will learn all the available features of the product, as well as information on its operation. The information that you get KitchenAid KUIS185S will certainly help you make a decision on the purchase.
If you already are a holder of KitchenAid KUIS185S, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime KitchenAid KUIS185S.
However, one of the most important roles played by the user manual is to help in solving problems with KitchenAid KUIS185S. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device KitchenAid KUIS185S along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
