Instruction/ maintenance manual of the product KHPF 7510/I KitchenAid
Go to page of 16
KHPF 7510 KHPS 7510 Instructions for use 5019_719_01132_GB 1-06-2007 14:30 Pagina 1.
5019_719_01132_GB 1-06-2007 14:30 Pagina 2.
Product description and symbols 4 Using the burners 4 Practical advice on using the hob 5 Positioning the pan supports and wok suppor t 5 Hood and cabinetry clearances (mm) 6 Injector table 6 W arning.
1. Removable pan supports 2. 1 kWh auxiliary burner 3. 1.65 kWh semi-fast burner 4. 1.65 kWh semi-fast burner 5. Professional wok burner 6. Auxiliary burner control knob 7.
Read the instructions to get the best out of your hob. • Use pans with a similar diameter to the burner(see the table). • Use flat bottomed pans except with the wok support. • Do not use excessive water when cooking foods and use the lid. • Ensure that pans are fully supported by the pan supports and do not protrude over the edges.
Category II2H3+ Electric P ower: 230 V - 50 Hz If a hood is to be installed above the hob, refer to the hood installation instructions to ensure the correct height above the hob. Note: If the distance “ A ” between the kitchen wall cabinets is between 600 and 730 mm, height “B" shall be at least 530 mm.
T o get the most out of your hob, please read the instructions carefully and keep them for future consultation. • These instructions are only valid in the countries whose destination symbol is shown on the serial number plate on the hob.
P acking The packing material is 100% recyclable and is labelled with the recycling symbol . Please dispose of all packing responsibly and carefully . Product This appliance is marked according to the European Directive 2002/96/EC, W aste Electrical and Electronic Equipment (WEEE).
T echnical information for the installer • W arning: this is a heavy products which requires the installation to be carried out by two people. • When installing the hob it is advisable to wear protective gloves. • This appliance can be installed into a 20mm - 50mm thick worktop.
The electrical connections must comply with current legislation and be carried out by a qualified, competent person. • Information on the voltage and power absorbed are shown on the serial no. plate. • The appliance must be earthed. • When installing the appliance, we recommend that this hob is protected by a 3mm bi-polar switch.
Important: The following procedure shall be carried out by competent technical personnel only . The hob can be installed on different types of materials, such as masonry , metal, bare wood and heat resistant laminate coated wood (90°C). Cut an opening into the worktop to the dimensions shown in the diagram.
Note: Refer to the injector table to ensure the correct type of injector is to be fitted. T raditional burners (T) 1. Remove the pan supports (A). 2. Remove the burners (B). 3. Unscrew the injector (C) with a box spanner 7. 4. Replace the injector with the one for the new gas.
T o fit the double crown wok burner: Insert in the following order: 1. burner ring ( A ); 2 . decorative covering ring ( B ); 3. external burner cap ( C ); 4. internal burner cap ( D ). Note: make sure that: 1. the locating pin for the burner ring ( A ) is inserted correctly in the slot on the burner unit.
Always disconnect the hob from the electrical power supply and wait until it cools before cleaning and/or doing maintenance work. n order to keep your hob in good condition, you must keep it clean, removing any remaining food each time you use it.
If the hob is not working properly , work through this guide before contacting our Customer Care Centre. The burner does not ignite, or the flame is unsteady? Check that: 1. the gas, or electricity supply has not been interrupted and that the control knob is turned fully on.
5019 719 01132 Printed in Italy n 06/07 GB Whirlpool Europe S.r .l. Viale G. Borghi, 27 - 21025 Comerio (V A) Phone 0332.759111 - Fax 0332.759268 www .
An important point after buying a device KitchenAid KHPF 7510/I (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought KitchenAid KHPF 7510/I yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data KitchenAid KHPF 7510/I - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, KitchenAid KHPF 7510/I you will learn all the available features of the product, as well as information on its operation. The information that you get KitchenAid KHPF 7510/I will certainly help you make a decision on the purchase.
If you already are a holder of KitchenAid KHPF 7510/I, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime KitchenAid KHPF 7510/I.
However, one of the most important roles played by the user manual is to help in solving problems with KitchenAid KHPF 7510/I. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device KitchenAid KHPF 7510/I along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
