Instruction/ maintenance manual of the product 4171206 KitchenAid
Go to page of 8
Undercounter Dishwasher IMPORTANT: Installer: Leave Installation Instructions with the homeowner. Homeowner: Keep Installation Instructions for future reference. Save Installation Instructions for local electrical inspector’s use. Part No. 4171206 Before you start.
Electrical ground is required. See Electrical requirements. DO NOT install dishwasher over carpeted flooring. Proper electrical, drain and water supply lines must be available or must be installed as specified within shaded area to prevent interference with dishwasher frame or other components.
Electrical requirements Electrical Shock Hazard . Electrical ground is required on this appliance. l Improper connection of the equipment-grounding conductor can result in electrical shock. l Check with a qualified electrician if you are in doubt as to whether the appliance is properly grounded.
copper, the copper should be 12” plus a 12” length of flexible hose attached to the end. Figure 5 If drain hose connection is less than 20” above the floor, the hose must form a loop using 38” OD copper tubing 20 inches above the floor. Make sure there are no kinks in the hose or copper tubing.
Now start... with dishwasher in kitchen. Disconnect electric supply before installing dishwasher. Cut 1” holes for water,drain’ and electrical lines within shaded area.
Floor Damage Slide dishwasher onto cardboard or hardboard before moving across floor. Failure to do so may cause damage to floor coverimzf. Place drain hose on the left side of the cabinet opening between the motor and the frame. - Latch dishwasher door.
(17 - I Place level against . interior flange as shown. Level dishwasher front to back and side to side by adjusting leveling close easily without slamming and should not open with its own weight. If necessary, close door and adjust door spring bracket.
Custom-made panels -23 9116" I---- -I *For Models: KUDA220T and KUDA22ST-17-7/16” Custom wood or other materials should be l/4” thick. Thinner materials will need to have a spacer panel installed behind custom panel. If custom panel is more than i/4” thick, the outer edge will need to be routed as shown.
An important point after buying a device KitchenAid 4171206 (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought KitchenAid 4171206 yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data KitchenAid 4171206 - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, KitchenAid 4171206 you will learn all the available features of the product, as well as information on its operation. The information that you get KitchenAid 4171206 will certainly help you make a decision on the purchase.
If you already are a holder of KitchenAid 4171206, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime KitchenAid 4171206.
However, one of the most important roles played by the user manual is to help in solving problems with KitchenAid 4171206. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device KitchenAid 4171206 along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
