Instruction/ maintenance manual of the product 526 Kenwood
Go to page of 9
KAC-726 KAC-526X POWER AMPLIFIER INSTRUCTION MANUAL © B64-1213-00 (EM).
2 Safety precautions T ake the following precautions to prevent fire and avoid personal injury : • When extending the battery cable, or ground cable, use 5mm 2 (A WG10) or larger automotive grade cable to avoid cable deterioration or damage to the covering.
3 Installation procedure 1. Remove the ignition key and disconnect the negative - terminal of the battery to prevent short circuits. 2. Set the unit according to the intended usage. 3. Connect the input and output cables of the units. 4. Connect the speaker cables.
4 Controls Operations of the following control and switches are required in accordance with the center unit and speakers connected with this unit. 24 6 1 5 3 LPF FILTER OFF MONO(Lch) STEREO OPERATION GND INPUT SENSITIVITY(V) MAX MIN 0.3 0.5 1.0 L R LINE IN LEFT RIGHT SPEAKER LEVEL INPUT 79 ! 0 8 FUSE(20A x 2) POWER IN BATT P.
5 For the pre-output level or the maximum power output, refer to the “Specifications” in the instruction manual of the center unit. 5 LINE IN terminal 6 Speaker level input terminals 7 Fuse (20 A .
6 Connection • The genuine-accessory car stereo shall have a maximum power output of no more than 25 W. • Do not connect the speaker output leads from a power amplifier (Optional) to the speaker input terminals of this unit, for this may cause malfunction or damage.
7 POWER IN BATT P.CON(REMOTE) GND LEFT BRIDGED RIGHT SPEAKER OUTPUT - + ■ Power and Speakers cable connection Power control (REMOTE) lead terminal Left speaker Right speaker Connect the ground cable to a metal part of the car chassis that acts as an electrical ground passing electricity to the battery‘s negative - terminal.
8 System examples ● Principle of T ri-mode Method of frequency band division using a coil and capacitor•••in case of 6dB/oct. slope L C 0 dB -3 dB Coil (L): Passes low frequencies and blocks high frequencies. (Low pass) Capacitor (C): Passes high frequencies and blocks low frequencies.
9 Specifications Specifications subject to change without notice. Audio Section KAC-726 KAC-526X Max Power Output (4 Ω ) Normal ..........................................................................200 W × 2 70 W × 2 Bridge....................
An important point after buying a device Kenwood 526 (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Kenwood 526 yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Kenwood 526 - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Kenwood 526 you will learn all the available features of the product, as well as information on its operation. The information that you get Kenwood 526 will certainly help you make a decision on the purchase.
If you already are a holder of Kenwood 526, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Kenwood 526.
However, one of the most important roles played by the user manual is to help in solving problems with Kenwood 526. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Kenwood 526 along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center