Instruction/ maintenance manual of the product InteriArt LT-15B60SE JVC
Go to page of 28
ENGLISH DEUTSCH FRANÇAIS IT ALIANO 1004TKH-VT -VT ©2005 VICTOR COMP ANY OF JAP AN, LIMITED INSTRUCTIONS LCD-TV -GERÄT BEDIENUNGSANLEITUNG P ANNEAU LCD TELEVISEUR MANUEL D'INSTRUCTIONS TV A SCH.
ENGLISH - 1 - For your safety This equipment has been designed and manufactured to meet international safety stan- dards but, like any electrical equipment, care must be taken if you are to obtain the best results and safety is to be assured. So, please read the point s below for your own safety .
ENGLISH - 2 - IF IN DOUBT PLEASE CONSUL T A COMPE- TENT ELECTRICIAN. DO DO read the operating instructions before you attempt to use the equipment. DO ensure that all electrical connections (in- cl.
ENGLISH - 3 - W ARNING Do not allow children to hang from the TV , place their elbows on the TV or lean against the TV . Doing so may cause the TV to fall over and lead to injuries.
ENGLISH - 4 - Import ant Information Please take note EXCLUSION CLAUSE JVC shall under no circumstances be liable for loss and/or damage to the product caused by: fire; earthquake; acciden.
ENGLISH - 5 - Remote Control Buttons / I = (S tand By) button TV / VCR / DVD Switch Number buttons A V button ( E XT -1, EXT -1S, EXT -1RGB, E X T -2, EXT -2S or PC ) BLUE / PICTURE Mode button YELLOW.
ENGLISH - 6 - Control Panel Buttons 01-ENG-1525-17MB18-1861UK_15B60SE.p65 30.06.2005, 15:09 6.
ENGLISH - 7 - Using the stand This TV comes with a T able T op St and already attached. This stand can be used to adjust the direction of the TV screen.
ENGLISH - 8 - Installing TV on the wall W ARNING When you install the TV on the wall, only use a JVC wall mounting unit (optional) which is designed for this TV .
ENGLISH - 9 - Preparation Install Display on solid horizontal surface such as a table or desk. For ventilation, leave a space of at least 10 cm free all around the set. T o prevent any fault and unsafe situations, please do not place any objects on top of the set.
ENGLISH - 1 0 - How to connect other devices IMPORT ANT : Switch off the TV before connect- ing any external device. Sockets for external connections are at the back of the T V . For connection of other devices via Euroconnector refer to the manuals of the related devices.
ENGLISH - 1 1 - Initial Settings First A.P.S. (Automatic Programming System) The following menu will be displayed on the screen when you turn the TV on for the first time. A.P .S. searches and sorts all channels and stores them automatically on your TV , ac- cording to the transmission of programme systems in your area.
ENGLISH - 1 2 - Programme Selection (Previous or next programme) Press button to select the previous programme. Press button to select the next programme. Programme Selection (direct access) Press digit buttons on the remote control to select programmes between 0 and 9.
ENGLISH - 1 3 - Setting Contrast Using or button select Contrast . Press button to increase contrast level. Press button to decrease contrast level. Setting Bright-1 Using or button select Bright-1 .
ENGLISH - 1 4 - Setting V olume Press button to increase volume. Press button to decrease volume. Or you can directly change the volume set- tings using + (to increase) or - (to decrease) button. Setting Bass Level Using or button select Bass Level.
ENGLISH - 1 5 - The Blue Background feature can be turned on or off by pressing or button. T o Store Settings In Feature menu all settings are stored auto- matically . Installation Menu By pressing or button, select the fourth icon.
ENGLISH - 1 6 - If you want to watch a VCR source , then it will be better to set VCR mode on. For this, while the cursor is on this item press the or button to set it On.
ENGLISH - 1 7 - Source Menu By pressing or button, select the fifth icon. Source menu appears on the screen. Use or button to select a mode and then press or OK button to switch to that mode. Y ou can also switch your TV t o EXT modes by pressing directly to AV button.
ENGLISH - 1 8 - Sleep Timer Sleep Timer mode OSD is displayed when YELLOW button is pressed. See page 14 for detailed information. Mute Indicator It is placed in the upper right side of the screen when enabled, and it stays there until it is dis- abled.
ENGLISH - 1 9 - The items in this menu are described at Pic- ture menu starting page 12 . Press BLUE button to reset the Manual mode to factory default settings. PC Picture Position Menu By pressing or button, select the sec- ond icon.
ENGLISH - 2 0 - Use or button to select a mode and then press or OK button to switch to that mode. Sound in PC mode Connect the PCs Audio output to the TVs PC Audio In socket with an audio cable. To select a page of Teletext Press the appropriate digit buttons for the required T eletext page number .
ENGLISH - 2 1 - To Stop Automatic Page Change The teletext page you have selected may con- tain more information than what is on the screen; the rest of the information will be dis- played after a period of time. Press button to stop the automatic page change.
ENGLISH - 2 2 - Via the ANT (aerial) socket If your equipment does not have an Eurocon- nector or RCA jacks, connect it to the TV with an aerial cable. For details, see the manual provided with the equipment. T o store the test signal that comes from the equipment, see Installation Menu on page 15 and store it to the program number 0.
ENGLISH - 2 3 - 3&$8',2, 1 $ 17(11$ (; 7 $ % & ' ( ) * + , '& ,1$'$372 5 3& ,1387 (; 7 69 , '( 2 ,1 $ 8',2/ 5 9,'(2 ,1 +($ '3+21( Peripheral Equipment Connections 01-ENG-1525-17MB18-1861UK_15B60SE.
ENGLISH - 2 4 - Peripheral Equipment Connections &$0&25'(5 DECODER FOR SA TELLITE RECEIVER VIDEO HEADPHONE AUDIO 2XWGRRU$ QWHQQD &RQQHFWL RQV Antenna Connections 01-ENG-1525-17MB18-1861UK_15B60SE.
ENGLISH - 2 5 - PC Input T ypical Display Modes The display has a maximum resolution of 1024 x 768, vertical sync. frequency range of 50-72 H z and a horizontal sync. frequency range of 30-57 KHz. The following table is an illustration of some of the typical video display modes.
ENGLISH - 2 6 - Tips Can not turn the TV on? Check that TV/VCR/DVD switch is set to TV position. TV may go to stand-by mode when you turn the TV on soon after you turn the TV off. If you can turn the TV on again, it is not a problem. Can not turn the TV off? Check that TV/VCR/DVD switch is set to TV position.
ENGLISH - 2 7 - Specifications Broadcasting Systems P AL SECAM BG , DK, I, L, Lp Channels and VHF (VL) : 46,25 MHz - 168,25 MHz Frequencies VH F (VH) : 175,25 MHz - 463,25 MHz UHF : 471,25 MHz - 863,25 MHz Cable TV : (S1-S20/ S21-S41) Input Signal Video: Analog 0,7 Vp-p 75 ohm positive Sync: TTL Level positive or negative, Seperate sync.
An important point after buying a device JVC InteriArt LT-15B60SE (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought JVC InteriArt LT-15B60SE yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data JVC InteriArt LT-15B60SE - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, JVC InteriArt LT-15B60SE you will learn all the available features of the product, as well as information on its operation. The information that you get JVC InteriArt LT-15B60SE will certainly help you make a decision on the purchase.
If you already are a holder of JVC InteriArt LT-15B60SE, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime JVC InteriArt LT-15B60SE.
However, one of the most important roles played by the user manual is to help in solving problems with JVC InteriArt LT-15B60SE. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device JVC InteriArt LT-15B60SE along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
