Instruction/ maintenance manual of the product CS680 (230V) JBL
Go to page of 10
English CS680 (230V) CINEMA SOUND SPEAKERS OWNER’S GUIDE ® 31079_CS680_OM_Eng 13/11/06 9:53 Side 1.
2 READ FIRST! Important Safety Precautions! 1. Read these instructions. 2. Keep these instructions. 3. Heed all warnings. 4. Follow all instructions. 5. Do not use this apparatus near water . 6. Clean only with a dry cloth. 7. Do not block any ventilation openings.
3 English Before deciding where to best place your speakers, survey your room and study Figures 1 and 2. Figure 1. In this overhead view of a typical installation, satellite speakers are used to reproduce sound for the front and surround channels. The center channel reproduces sound and dialogue.
4 PLACEMENT Left and Right Fr ont Channels For left and right front channels, place one satellite to the left and another to the right of the television, as shown in Figure 1. Since the speakers are magnetically shielded, you can place them very close to the TV without worrying about the magnetic field distorting the picture.
5 English The CS680 satellites and center channel are designed to be mounted on the wall. There is a fixed-mount wall bracket and an adjustable wall bracket provided for each satellite and the center channel. Each speaker bracket will require up to four 1-1/2" #10 wood screws; each screw should be fastened to a wall stud.
6 T urn Off All Po wer After placing the speakers, you are ready to connect your system. First, turn off all audio-system power . Use high-quality speaker wire to make your connections. #18-gauge speaker wire with polarity coding is included. For longer distances, #16-gauge or heavier wire is recommended.
7 English SUBWOOFER CONTROLS Rear Panel AC 220V-230V 50Hz-60Hz 220 Watts PHASE CS80SUB/230 ¡ ™ £ ¢ ∞ § Subwoofer -Level Control Phase Switch LFE Input Line-Level Inputs Pow.
8 OPERA TION Surround Modes When using the CS680 in a Dolby Digital or DTS home theater system, make sure all speakers are set to “Small”. In a Dolby Pro Logic ® home theater system, make sure the receiver’ s center channel mode is set to “Normal.
9 English † The Peak Dynamic Power is measured by recording the highest center -to-peak voltage measured across the output of a resistive load equal to minimum impedance of the transducer , using a 50Hz sine wave burst, 3 cycles on, 17 cycles off.
All features and specifications are subject to change without notice. JBL is a trademark of Harman International Industries, Incorporated, registered in the United States and/or other countries. Pro Sound Comes Home is a trademark of Harman International Industries, Incorporated.
An important point after buying a device JBL CS680 (230V) (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought JBL CS680 (230V) yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data JBL CS680 (230V) - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, JBL CS680 (230V) you will learn all the available features of the product, as well as information on its operation. The information that you get JBL CS680 (230V) will certainly help you make a decision on the purchase.
If you already are a holder of JBL CS680 (230V), but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime JBL CS680 (230V).
However, one of the most important roles played by the user manual is to help in solving problems with JBL CS680 (230V). Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device JBL CS680 (230V) along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
