Instruction/ maintenance manual of the product Symphony 4504 American Standard
Go to page of 7
Cer tified to comply with ANSI A112.18.1 Installation Instructions Centerset Lavatory Faucet with Speed Connect™ Drain *Your new American Standard faucet is designed to work only with the Speed Connect drain. Helpful tips for removing your current drain can be found in the Troubleshooting section of these instructions.
INST ALL POP-UP DRAIN INSTALL BLACK GASKET 3 2 Install BLACK CONE GASKET (1) onto DRAIN BODY (2) from below. Note: The flat side of the BLACK CONE GASKET (1) must face down. 4 Drop DRAIN BODY (4) through sink drain hole. Make sure WHITE FOAM GASKET (5) is under flange of DRAIN BODY (4) .
COMPRESSION NUT COUPLING NUT FLEXIBLE SUPPLIES 3/8 O.D. BULL-NOSE RISERS Thread CABLE CONNECTOR (1) clockwise onto DRAIN BODY CONNECTION (2) and hand tighten. Fig. A. Your new POP-UP DRAIN installation is now complete. Fig. B. Note: Tailpeice on pop-up drain is 1-1/4” O.
2 2 1 1 9 TEST INST ALLED FITTING With HANDLES (1) in OFF position, turn on W A TER SUPPLIES (2) and check all connections for leaks. Remove AERA TOR (3) . Operate both HANDLES (1) to flush water lines thoroughly . Replace AERA TOR (3) . 5 2 3 4 3 CHECK DRAIN CONNECTIONS Operate POP-UP KNOB (4) and fill lavatory with water .
Speed Connect™ Drain Troubleshooting Guide 1 2 Disconnect the Cable from the Drain by threading the Cable Connector (1) counter-clockwise. Fig. A. Look at the area on the Drain Body where the Cable was attached and locate the component labeled as “Cam” and “Cam Cap” in the illustration.
STOPPER INSTALLATION PROCEDURE Locked Mode: Look at the Plastic Loop at the bottom of the Stopper and notice that the Loop is on one side of the Stopper.
TIPS FOR REMOVING YOUR OLD DRAIN: Loosen nuts on P-Trap using channel locks. Suggest spraying nuts with spray lubricant to loosen any corrosion or debris that may have built up. Remove P-Trap half from Tailpiece. Use bucket to catch any residual water in P-trap.
An important point after buying a device American Standard Symphony 4504 (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought American Standard Symphony 4504 yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data American Standard Symphony 4504 - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, American Standard Symphony 4504 you will learn all the available features of the product, as well as information on its operation. The information that you get American Standard Symphony 4504 will certainly help you make a decision on the purchase.
If you already are a holder of American Standard Symphony 4504, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime American Standard Symphony 4504.
However, one of the most important roles played by the user manual is to help in solving problems with American Standard Symphony 4504. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device American Standard Symphony 4504 along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
