Instruction/ maintenance manual of the product 10/100 IMC Networks
Go to page of 4
1 2 McBasic 10/100 Installation Guide McBasic 10/100 is a low- cost, preconfigured, IEEE 802.3 single- conversion MediaConverter that is designed to convert between 10Base - T twisted pair and 10Base-FL multi-mode or single -mode fiber or between 100Base- TX twisted pair and 100Base -SX multi-mode fiber or 100Base -FX single-mode fiber .
3 4 n n In F orce-100 mode , the McBasic 10/100 configures specifically as a 100BASE- TX/100BASE-SX or FX media converter . Note that F orce-100 implies the rejection of 10 Mbps signals. T o enable Force-100 mode, set Dip switch 6 to the ON position (Dip switch 4 must be in the OFF position).
When both the McBasic 10/100 units in a media conversion are set for PNP/T ransparent (Auto -Negotiation) mode, the following results occur: Fiber Optic Cleaning Guidelines F iber Optic transmitters a.
7 8 5) If you suspect that the optics have been contaminated, alternate between blasting with clean dry compressed air and flushing with methanol to remove particles of dirt. Electrostatic Discharge P recautions Electrostatic discharge (ESD) can cause damage to your add-in modules.
An important point after buying a device IMC Networks 10/100 (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought IMC Networks 10/100 yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data IMC Networks 10/100 - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, IMC Networks 10/100 you will learn all the available features of the product, as well as information on its operation. The information that you get IMC Networks 10/100 will certainly help you make a decision on the purchase.
If you already are a holder of IMC Networks 10/100, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime IMC Networks 10/100.
However, one of the most important roles played by the user manual is to help in solving problems with IMC Networks 10/100. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device IMC Networks 10/100 along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
