Instruction/ maintenance manual of the product IMSB63910 Image
Go to page of 20
USER’S MANUAL QUESTIONS? If you have questions, or if there are missing parts, we will guar- antee complete satisfaction through direct assistance from our factory . TO A VOID DELA YS, PLEASE CALL DIRECT TO OUR T OLL- FREE CUSTOMER HOT LINE. The technicians on our customer hot line will provide immediate assistance, free of charge.
2 IMAGE is a registered trademark of ICON Health & Fitness, Inc. Posting the W arning Sign . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 Important Safety Instructions .
3 W ARNING: T o reduce the risk of drowning, electric shock, or serious injury , read the fol- lowing important precautions before using the hydrotherapy spa. READ AND FOLLOW ALL INSTRUCTIONS 1. It is the responsibility of the owner to ensure that all users of the hydrotherapy spa are adequately informed of all precautions.
4 20. DANGER—Risk of electric shock. Keep all electrical appliances such as radios, tele- phones, televisions, and lights at least five feet away from the water . 21. A wire connector is provided on the electron- ics pack of the hydrotherapy spa to connect a minimum No.
5 W ARNING: Read all instructions before using the hydrotherapy spa. ICON assumes no responsibility for personal injury or property damage sustained by or through the use of this product. SA VE THESE INSTRUCTIONS 35. W ARNING: The spa jets produce a stream of water with relatively high pressure.
6 Congratulations for selecting the new IMAGE ® RENEW 639 hydrotherapy spa. The innovative RENEW 639 allows you to enjoy all the benefits of hydrotherapy in the comfort and privacy of your home. Hydrotherapy is a proven method for soothing tired muscles after exercise or for relieving the stress of a busy life.
7 There are many factors to consider when choosing a location to set up the hydrotherapy spa. These factors vary depending on whether you plan to use the spa inside or outside. We have listed several factors you may wish to consider as you decide where to set up the spa.
8 2. Close the valve knob on the drain hose. Thread the cap onto the drain hose. Locate the four gate valves inside the access open- ing (there are two gate valves per pump). Make sure that the gate valves are open and that the locking clips are snapped onto the stems of the gate valves, as shown in the inset drawing.
9 5. Make sure that a qualified electrician has wired the spa to a 240-volt power source. Remove the two warning decals (see page 5) from the spa shell. Using a damp cloth, wipe the spa shell clean. Before filling the spa, make sure that it is in the desired position and that there is room to easily service it.
10 The hydrotherapy spa is designed to seat seven adults. The spa holds approximately 375 gallons of water and offers a heating system (80°F to 104°F), a filtration system, and adjustable hydrotherapy jets. Follow the guidelines below to use and maintain the spa for your long-term enjoyment.
A. The filters can be removed for cleaning or replace- ment (see CHECKING AND CLEANING THE FIL- TERS on page 13). B. The underwater light can be used for night opera- tion (see USING THE CONTROLS on page 12). The spa includes both red and blue covers for the light.
12 Using the Controls Air Control 1: Determines the amount of air flowing through the hydrotherapy jets labeled 1 (above). If the control is turned counterclockwise, the amount of air will increase; if the control is turned clockwise, the amount of air will decrease.
13 The hydrotherapy spa is designed to provide years of enjoyment. Please follow the guidelines below to properly maintain your spa. MAINTENANCE SCHEDULE Daily • Check the water level and refill the spa to the level shown in step 5 on page 9. • Check the pH balance and sanitizer level.
14 MAINT AINING THE PROPER PH BALANCE The pH factor is a measure of the relative acidity or alkalinity in the water , and is measured on a scale of 1 to 14. Pure water has a value of 7, which is neutral. Any value above 7 is alkaline, and any value below 7 is acidic.
15 T o drain the hydrotherapy spa, follow the steps below: 1. Using the console, adjust the temperature to the lowest setting. 2. Shut off the power to the spa, at the circuit breaker or GFCI. 3. Remove the access panel from the spa (see A TT ACHING AND REMOVING THE ACCESS P ANEL on page 14).
16 1. SYMPTOM: THE SP A WILL NOT OPERA TE a. Check to see if the GFCI breaker is tripped or was not turned on. Reset the GFCI breaker . 2. SYMPTOM: THE CIRCUIT BREAKER OR THE GFCI TRIPS WHILE THE SP A IS OPERA TING a. Reset the circuit breaker or the GFCI.
17 9. SYMPTOM: THE W A TER LEVEL DROPS a. A clamp or seal inside the pump compartment may be loose. Check inside the pump compart- ment for excess water and watch the pump unit while it is operating to see if water drips from any of the plumbing.
18 Part List —Model No. IMSB63910/IMSG63910 R1 101A 1 1 Thermometer Fitting 2 1 3-wire Power Cord 3 2 Filter Cover with O-Ring 4 2 Filter O-Ring 5 2 Filter 6 2 Rubber Isolator 7 1 Blue Light Cover 8.
19 26 27 25 18 29 18 11 13 10 9 31 13 13 19 9 31 13 20 1 12 2 15 37 43 44 36 40 39 41 42 41 38 35 46 46 16 17 16 17 16 17 16 17 46 46 25 6 6 9 5 3 4 5 3 4 47 45 48 45 48 49 14 9 9 54 52 53 53 55 23 Exploded Drawing —Model No.
Part No. 180722 R1 101A Printed in USA © 2001 ICON Health & Fitness, Inc. T o order replacement parts, simply call our Customer Service Department toll-free at 1-877-897-7493, Monday through Friday , 6 a.m. until 6 p.m. Mountain T ime (excluding holidays).
An important point after buying a device Image IMSB63910 (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Image IMSB63910 yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Image IMSB63910 - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Image IMSB63910 you will learn all the available features of the product, as well as information on its operation. The information that you get Image IMSB63910 will certainly help you make a decision on the purchase.
If you already are a holder of Image IMSB63910, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Image IMSB63910.
However, one of the most important roles played by the user manual is to help in solving problems with Image IMSB63910. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Image IMSB63910 along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
