Instruction/ maintenance manual of the product 100V model Hughes & Kettner
Go to page of 32
ENGLISH DEUTSCH FRANÇAIS IT ALIANO ESP AÑOL BEDIENUNGSANLEITUNG MA N U A L www .hughes-and-kettner .com 1.1 Edition Tube Anni Manu 1.1 11.01.2005 12:26 Uhr Seite 1.
IMPORT ANT SAFETY INSTRUCTIONS BEFORE CONNECTING, READ INSTRUCTIONS • Read all of these instructions! • Save these instructions for later use! • Follow all warnings and instructions marked on the product! •D o not use this product near water , i.
CONSEILS DE SECURITE IMPORT ANTS! PRIERE DE LIRE A V ANT L’EMPLOI ET A CONSERVER POUR UTILISA TION ULTERIEURE! • L’appareil a été conçu par Hughes & Kettner selon la norme IEC 60065 et a quitté l’entreprise dans un état irréprochable.
IMPORT ANTI A VVERTIMENTI DI SICUREZZA! Leggere attentamente prima dell’uso e conservare per un utilizzo successivo: • L’apparecchio è stato costruito dalla Hughes & Kettner secondo la normativa euro- pea IEC 60065 ed ha lasciato il nostro stabilimento in stato ineccepibile.
5 ENGLISH 5 EDITION TUBE-MANUAL BEFORE POWERING UP • Check that your local wall socket voltage and the amp's AC power rating are identical before you plug the amp in.
6 EDITION TUBE-MANUAL 1.0 JACKS AND CONTROLS INPUT: Plug your guitar into this jack. FOOTSWITCH: Plug a footswitch (e.g. the Hughes & Kettner TTY-1) into this jack when you want to change channels remotely. If you choose to use a footswitch, make sure that the CHANNEL SELECT switch is set to the CLEAN channel (yellow LED lights up).
7 ENGLISH 7 EDITION TUBE-MANUAL 2.0 ST ANDARD SETUP/CABLE CONNECTIONS 3.0 OPERA TION 3.1 SELECTING SOUNDS When you’re ready to tweak the settings for both of the fundamental sounds that the EDITION .
EDITION TUBE-MANUAL 8 - Refrain from DIY repairs! T o be on the safe side, you should also have a qualified technician replace internal fuses. 5.0 TROUBLESHOOTING 1) The EDITION TUBE is not getting any power: • Check the mains cable to see if it is connected properly.
9 DEUTSCH 9 EDITION TUBE-MANUAL VOR DER INBETRIEBNAHME • V ergewisser n Sie sich vor dem Anschluß des EDITION TUBE, dass der nahe der Netzbuchse angegebene Spannungs- wert mit der vorhandenen Netzspannung übereinstimmt. • Stellen Sie eine ausreichende Luftzufuhr an die Kühlschlitze des Gerätes sicher .
10 EDITION TUBE-MANUAL 1.0 ANSCHLÜSSE UND BEDIENELEMENTE INPUT: Eingang zum Anschluss der Gitarre. FOOTSWITCH: Anschlussbuchse für einen Fußschalter (z.B. Hughes & Kettner ® FS-1) zum Umschalten zwischen den Kanälen. Der CHANNEL SELECT Schalter muss dabei auf den CLEAN-Kanal geschaltet sein (gelbe LED leuchtet).
11 DEUTSCH 11 EDITION TUBE-MANUAL 2.0 ST ANDARD SET UP / VERKABELUNG 3.0 BEDIENUNG DES EDITION TUBE 3.1 DIE ABSTIMMUNG DER GRUNDSOUNDS Möchten Sie beide Grundsounds des EDITION TUBE nutzen, so empfehlen wir die folgende V orgehensweise: • Nehmen Sie sämtliche Soundeinstellungen bei maxima- lem Ausgangspegel an der Gitarre vor .
EDITION TUBE-MANUAL 12 5.0 MÖGLICHE FEHLERQUELLEN / TROUBLESHOOTING F1) Der EDITION TUBE lässt sich nicht einschalten: • Es liegt keine Netzspannung an. Überprüfen Sie den kor- rekten Anschluss des Netzkabels! • Die Netzsicherung ist defekt. Bitte ersetzen Sie die interne Netzsicherung durch eine neue Sicherung mit entspre- chendem W ert.
13 TRIPLEX-MANUAL FRANÇAIS 13 EDITION TUBE-MANUAL AV ANT LA MISE EN FONCTION • A vant de brancher L’EDITION TUBE, assurez-vous que la tension de celui-ci correspond à la tension du réseau. • La ventilation de l'appareil par les fentes d'aération doit être assurée.
14 EDITION TUBE-MANUAL 1.0 RACCORDEMENTS ET ÉLÉMENTS DE COMMANDE INPUT : Entrée pour la connexion de la guitare. PÉDALIER : Prise pour un pédalier (p. ex. Hughes & Kettner FS-1), facilitant la commutation entre les canaux. Le commutateur CHANNEL SELECT doit être réglé sur le canal CLEAN (DEL jaune allumée).
15 FRANÇAIS 15 EDITION TUBE-MANUAL 2.0 CÂBLAGE ET SET UP ST ANDARD 3.0 MANIEMENT DE L ’EDITION TUBE 3.1 RÉGLAGE DES SONS DE BASE Si vous désirez exploiter les deux sons fondamentaux de l’EDITION TUBE, nous vous recommandons de procéder comme suit : • Réalisez tous les réglages de sonorité au niveau de sortie maximal de la guitare.
EDITION TUBE-MANUAL 16 • Soyez particulièrement vigilant en ce qui concerne les spécifications des appareils supplémentaires. Ne connectez jamais à l’EDITION TUBE de haut-parleurs présentant une impédance insuffisante (valeur ohmique). Ne branchez jamais d'appareils à niveau trop élevé (p.
17 IT ALIANO 17 EDITION TUBE-MANUAL PRIMA DI UTILIZZARE LO STRUMENTO • Controllate che la tensione di alimentazione dell‘amplificatore corrisponda a quella della corrente della vostra nazione, prima di collegare l‘ampli a una presa di corrente.
18 EDITION TUBE-MANUAL 1.0 PRESE E CONTROLLI INPUT: Ingresso per collegare la chitarra FOOTSWITCH: Jack per un selettore a pedale standard (p.es. Hughes & Kettner FS-1) che vi permette di cambiare fra i canali. Usandolo, il selettore CHANNEL SELECT deve essere girato sul canale CLEAN (LED gialla si accende).
19 IT ALIANO 19 EDITION TUBE-MANUAL 2.0 SETUP ST ANDARD/ COLLEGAMENTO DEI CA VI 3.0 FUNZIONAMENTO 3.1 SELEZIONE DEI SUONI Se volete usare entrambi i due suoni principali dell‘EDITION TUBE vi consigliamo di procedere come descritto qui sotto.
EDITION TUBE-MANUAL 20 livelli di uscita del segnale troppo elevati (come altri amplificatori) all'ingresso del amplificatore. - Assicuraratevi che la tensione di rete alla quale state per collegarvi sia compatibile con quella dell‘amplificatore.
21 ESP AÑOL 21 EDITION TUBE-MANUAL ANTES DE LA PUEST A EN MARCHA • Antes de conectar el EDITION TUBE compruebe que el valor de tensión indicado cerca del jack de la red coincide con la tensión de la red existente. • Asegúrese de que entra suficiente aire por las ranuras de ventilación.
22 EDITION TUBE-MANUAL 1.0 P ANORAMA DE LAS ACOMETIDAS Y LOS ELEMENTOS DE MANEJO INPUT: Entrada para la conexión de la guitarra. FOOTSWITCH: Jack para la conexión de un conmutador de pedal (p. ej. Hughes & Kettner FS-1) para la conmutación entre los canales.
23 ESP AÑOL 23 EDITION TUBE-MANUAL 2.0 CONFIGURACIÓN / CABLEADO ESTÁNDAR 3.0 MANEJO DEL EDITION TUBE 3.1 LA SINTONÍA DEL SONIDO DE FONDO Si desea utilizar los dos sonidos de fondo del EDITION TUBE, recomendamos el procedimiento siguiente: • Lleve a cabo todos los ajustes de sonido con el nivel de salida máximo en la guitarra.
EDITION TUBE-MANUAL 24 - Preste su mayor atención a las especificaciones de los aparatos adicionales. No utilice nunca bafles con una impedancia muy baja (ohmios) en el EDITION TUBE. No conecte nunca a su amplificador aparatos con un nivel demasiado alto (por ejemplo, las etapas de potencia).
EDITION TUBE-MANUAL Für das folgend bezeichnete Erzeugnis HUGHES & KETTNER EDITION TUBE wird hiermit bestätigt, daß es den wesentlichen Schutz- anforderungen entspricht, die in der Richtlinie d.
EDITION TUBE-MANUAL 26 6.0 TECHNICAL SPECIFICA TIONS PREAMP SECTION: INPUT: -20 dBV/ 1 MOhm FX-RETURN: 0 dBV/ 47 kOhms FX-SEND: 6 dBV/ 100 Ohms POWER AMP SECTION: EL84 tube amp OUTPUT POWER: 20 W RMS .
27 EDITION TUBE-MANUAL 6.0 SPECIFICHE TECNICHE SEZIONE DI PREAMPLIFCAZIONE: INGRESSO: -20 dBV/ 1 MOhm RITORNO EFFETTI: 0 dBV/ 47 kOhms MANDA T A EFFETTI: 6 dBV/ 100 Ohms SEZIONE DELL‘AMPLIFCA TORE D.
28 EDITION TUBE-MANUAL Edition Tube Anni Manu 1.1 11.01.2005 12:26 Uhr Seite 28.
29 EDITION TUBE-MANUAL Edition Tube Anni Manu 1.1 11.01.2005 12:26 Uhr Seite 29.
30 EDITION TUBE-MANUAL Edition Tube Anni Manu 1.1 11.01.2005 12:26 Uhr Seite 30.
31 EDITION TUBE-MANUAL Edition Tube Anni Manu 1.1 11.01.2005 12:26 Uhr Seite 31.
EDITION TUBE-MANUAL W ORLD WIDE HUGHES & KETTNER • Leipziger Str . 3 • 66606 St. W endel • TEL. 0 68 51 - 90 50 • FAX 0 68 51 - 905 100 INTERNA TIONAL INQUIRIES: F AX +49 - 68 51 - 905 200 • E-Mail: inter national@musicandsales.com © 2005 by Music & Sales GmbH Printed in Germany, January 2005 www .
An important point after buying a device Hughes & Kettner 100V model (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Hughes & Kettner 100V model yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Hughes & Kettner 100V model - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Hughes & Kettner 100V model you will learn all the available features of the product, as well as information on its operation. The information that you get Hughes & Kettner 100V model will certainly help you make a decision on the purchase.
If you already are a holder of Hughes & Kettner 100V model, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Hughes & Kettner 100V model.
However, one of the most important roles played by the user manual is to help in solving problems with Hughes & Kettner 100V model. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Hughes & Kettner 100V model along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
