Instruction/ maintenance manual of the product 2145731 Huffy
Go to page of 34
03/04 P/N 214573 1 Toll-Free Customer Service Number for U.S: 1-800-558-5234, For Canada: 1-800-284-8339 , For Europe: 00 800 555 85234 (Sweden: 009 555 85234 ), For Australia: 1-800-632-792 Internet Address: www.
2 P/N 214573 03/04 W ARNING F AILURE TO FOLLOW THESE W ARNINGS MA Y RESUL T IN SERIOUS INJUR Y AND/OR PROPERTY DAMAGE. Owner must ensure that all players know and follow these rules for safe operation of the system. • DO NO T HANG on the rim or any part of the system including bac kboard, suppor t braces or net.
03/04 P/N 214573 3 IMPORT ANT! Remove all content s from boxes. Be sure to check inside pole sections; hardware and additional p arts are p acked inside. NOTICE T O ASSEMBLERS AL L Huffy Sport s basketball systems, including those used for DISPLA YS, MUST be assembled and ballasted with sand or water according to instructions.
4 P/N 214573 03/04 WARRANTY CARD: Please remember to complete your product registration form either on-line at: www.huffysports.com/warrantycard or mail-in the enclosed postcard .
03/04 P/N 214573 5 HARDWARE IDENTIFIER (CONTINUED) HARDW ARE IDENTIFIER (BOL TS & SCREWS) Item #5 (1) Item #21 (1) Item #26 (6) Item #19 (1) Item #53 (1) Item #50 (1) Item #65 (1) Item #46 (2) Ite.
6 P/N 214573 03/04 * You may have extra parts with this model. HARDW ARE IDENTIFIER (NUTS & W ASHERS) HARDW ARE IDENTIFIER (STEEL SP ACERS, RODS & CLIPS) HARDW ARE IDENTIFIER (PLASTIC SP ACERS.
03/04 P/N 214573 7 BEFORE YOU ST ART! T o ensure optimal playability of backboard system, a close tolerance fit between the elevator component s and hardware is required. T est-fit large bolt s into large holes of elevator tubes, backboard bracket s, and triangle plates.
8 P/N 214573 03/04 2 3 1 3. 2. 1. Wood Scrap 2 1 5" (13 cm) MIDDLE TO P 5" (13 cm) BO TT OM 2 3 1 Mark pole sections with tape as shown. TAPE (not supplied) TAPE (not supplied) IMPORT ANT! Bounce pole top (1) and middle section (2) together as shown until they no longer move toward t aped reference mark.
03/04 P/N 214573 9 4. 5. Install wheels (17) onto axle (28) and wheel bracket (25) with push cap s (29) as shown. Position base as shown. Secure wheel bracket assembly with bolt (16) and nut (15) as shown.
10 P/N 214573 03/04 6. Install rod (4) through holes in bottom pole section (3) and eyebolt (5). Insert pole assembly into tank (6) and through center hole on wheel assembly as shown. Secure pole assembly with strap (44), washer (1 1) and lock nut (8).
03/04 P/N 214573 11 7. 9 9 Secure base struts (9) to pole using bolt (10) washers (1 1) and nut (12) as shown. Rotate the non-secured ends of base strut s (9) as shown. TWO PEOPLE REQUIRED FOR THIS PROCEDURE. FAILURE TO FOLLOW THIS WARNING COULD RESULT IN SERIOUS INJURY AND/OR PROPERTY DAMAGE.
12 P/N 214573 03/04 8. 9. Secure base struts (9) to base using bolt (14) washers (1 1) and nut (15). Install upper pivot bracket (18) to front of base using bolt (19), washer (20) and nut (8) as shown. 14 11 15 11 9 8 20 18 19 TWO PEOPLE REQUIRED FOR THIS PROCEDURE.
03/04 P/N 214573 13 Insert bolt (21) through lower pivot bracket (22) as shown, bolt (21) will be secured during step 13. Carefully place base assembly on its side. Inst all lower pivot bracket (22) with bolt (23), washers (20) and lock nut (8) as shown.
14 P/N 214573 03/04 Position base as shown. Secure wheel bracket assembly with disc (30), washer (20) and nut (8) as shown. 29 27 28 25 27 29 21 30 20 8 Carefully reposition entire assembly as shown: 12. 13. SIDE OF WHEEL WITH LONGER PLASTIC AXLE NEEDS TO FACE THE WHEEL BRACKET.
03/04 P/N 214573 15 15 . Inst all pole mount bracket (45) and reinforcement bracket (47) with carriage bolts (46) as shown. T ighten flange nuts (15) completely . 1 45 15 15 47 46 46 16. Attach sp acers (32, 33) to pole mount bracket (45) with bolts (54), washers (20), and lock nuts (37) as shown.
16 P/N 214573 03/04 17 . 45 15 35 48 48 34 50 Apply logo and height indicator labels (41) to adjustment rod (31) as shown. Attach handle part s (38, 39) to adjustment rod with screw (36), carriage bolts (26), and flange nut s (15) as shown. 18 . 26 15 15 39 38 36 26 31 41 41 Assemble lanyard (34) to locking pin (35) as shown (FIG A).
03/04 P/N 214573 17 Insert handle assembly through pole mount assembly as shown. Lock pole assembly in place at the 10’ (3.05 m) mark with pin (35). 35 19 . 20. 53 51 37 54 52 55 Install sp acers (51) onto backboard brackets (52), with bolts (53, 54) and lock nuts (55, 37) as shown.
18 P/N 214573 03/04 21. Attach lower elevator tubes (56) and counter balance spring (68) to backboard support brackets (52) using sp acers (59), bolt (57), and nut (58) as shown. 63 Upper Elevator tube T oward Pole T oward Board 56 Lower Elevator tube T oward Pole T oward Board Identify elevator tubes (63 & 56).
03/04 P/N 214573 19 22. Place board spacers (49) into board as shown.S tarting with nuts (15) flush against bracket (52) secure rim (70) and bracket to backboard. IMPORT ANT! For spring loaded rim assembly , refer to instructions included with rim hardware.
20 P/N 214573 03/04 58 58 65 64 56 1 66 66 57 67 56 67 24. Support pole on sawhorse. Attach backboard assembly to top pole section (1) as shown. Install pole cap (64). NOTE: T wo people are recommended for this step. Use caution; elevator assembly is heavy .
03/04 P/N 214573 21 26. Insert bolt (57) through left side upper elevator tube (63), then stretch spring (68) onto bolt (57). Insert bolt (57) through right side upper elevator tube (63) and secure with nut (58). 68 58 57 63 63 USE EYE PROTECTION WHEN INST ALLING SPRINGS.
22 P/N 214573 03/04 SECTION D: INST ALL FRONT COVER & HANDLE 27. Attach front cover (50) to hinge tubes (18) using carriage bolt s (51) and flange nuts (22) as shown. 40 61 15 24 Upright system and fill base (8) with water (approx. 40 gallons) and snap fill cap (54) in place.
03/04 P/N 214573 23 29. Roll assembly to desired playing area. Secure assembly to ground using strap (44) and tie down stake (7). 44 7 8 30. ELEVATOR HEIGHT ADJUSTMENT 35 A. B. C. 31 DO NOT ALLOW CHILDREN TO ADJUST HEIGHT. W ARNING! 31. A. While holding handle, remove pin (35).
24 P/N 214573 03/04 W ARNING: Use of this product without proper installation of net clips, or when all net clips are not present could result in bodily harm. Be sure to follow directions carefully. AVERTISSEMENT : L'utilisation de ce produit sans installer correctement ou toutes les pinces du filet risque de causer des blessures.
03/04 P/N 214573 25 Install net. Installez le filet. Das Netz anbringen Instale la red. Insert net into bottom of clip as shown. Insérez le filet dans la base de la pince, comme illustré. Das Netz wie gezeigt unten in den Clip stecken. Introduzca la red en la parte inferior del sujetador como se muestra.
26 P/N 214573 03/04 FRANÇAIS Numéro d’appel gratuit du service après-vente. Etats-Unis et Canada uniquement: 1-800-284-8339 Numéro vert international (France, Suisse) : 00 800 555 85234 CONSIGNES DE SÉCURITÉ La plupart des blessures sont provoquées par une mauvaise utilisation et/ou le non respect des instructions.
INSTRUCTIONS IMPORTANT ! NOTEZ À LA PAGE 1 DE CE MANUEL LE NUMÉRO DE MODÈLE MENTIONNÉ SUR LE CARTON. AVANT DE COMMENCER ! Pour garantir l'utilisation optimale du panneau, les composants du système élévateur et la visserie doivent être bien ajustés (serrés).
28 P/N 214573 03/04 LISTE DES PIÈCES (Voir le numéro de légende sur les schémas) Légende Quantité No de réf. Description 1 1 900149 Section de poteau supérieure, noire 2 1 904811 Section de poteau centrale, noire 3 1 903407 Section de poteau inférieure, noire 4 1 200188 Tige, zinc, 3/8 x 5-1/4 (long.
03/04 P/N 214573 29 00 800 555 85234 ESPAÑOL INSTRUCCIONES DE SEGURIDAD La mayoría de las lesiones son ocasionadas por el mal uso y/o por no seguir las instrucciones. Tenga cuidado cuando use esta unidad. • Tenga mucho cuidado si utiliza una escalera durante el montaje.
INSTRUCCIONES ¡IMPORTANTE! ANOTE EN LA PÁGINA 1 DE ESTE MANUAL DEL PROPIETARIO EL NÚMERO DE MODELO QUE APARECE EN LA CAJA. ¡ANTES DE COMENZAR! Para asegurar el óptimo rendimiento del sistema del respaldo en el juego, se requiere un ajuste de tolerancia estrecha entre los componentes del elevador y el herraje.
03/04 P/N 214573 31 LISTA DE PIEZAS (Vea el identificador de herraje) Artículo Cant. Pieza N.º Descripción 1 1 900149 Sección superior del poste, negra 2 1 904811 Sección media del poste, negra 3.
32 P/N 214573 03/04 Universelle gebührenfreie Telefonnummer (Deutschland, Schweiz): 00 800 555 85234 DEUTSCH SICHERHEITSHINWEISE Die meisten Verletzungen werden durch einen unvorschriftsmäßigen Gebrauch und/oder ein Mißachten der Sicherheitshinweise verursacht.
GEBRAUCHSANLEITUNG WICHTIG! NOTIEREN SIE SICH DIE MODELLNUMMER AUS DEM KÄSTCHEN AUF SEITE 1 DIESES BENUTZERHANDBUCHS VORBEREITENDE MASSNAHMEN Um sicherzustellen, dass das Korbwandsystem optimal für .
34 P/N 214573 03/04 TEILELISTE (Siehe Teileschlüssel) Artikel Menge Teilenummer Beschreibung 1 1 900149 Oberes Stangenteil, schwarz 2 1 904811 Mittleres Stangenteil, schwarz 3 1 903407 Unteres Stange.
An important point after buying a device Huffy 2145731 (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Huffy 2145731 yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Huffy 2145731 - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Huffy 2145731 you will learn all the available features of the product, as well as information on its operation. The information that you get Huffy 2145731 will certainly help you make a decision on the purchase.
If you already are a holder of Huffy 2145731, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Huffy 2145731.
However, one of the most important roles played by the user manual is to help in solving problems with Huffy 2145731. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Huffy 2145731 along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
