Instruction/ maintenance manual of the product 7411.732 American Standard
Go to page of 6
US60402 Rev .1.1 Cer tified to comply with ANSI A112.18.1 Installation Instructions Centerset Lavatory Faucet with Ev erClean™ Finish & SpeedC onnect™ Drain Adjustable W rench Screwdriver Chan.
US60402 Rev .1.1 Thread FLANGE (1) counter-clockwise and remove FLANGE (1) and FOAM GASKET (2) from drain body. Fig. A. Thread LOCKNUT (3) clock-wise to bottom of drain body. Push GASKET (4) down against LOCKNUT (3). Fig. B. POP-UP DRAIN Tighten TAILPIECE (4) on DRAIN BODY before installing DRAIN BODY.
COMPRESSION NUT 3/8” COMPRESSION CONNECTION COUPLING NUT FLEXIBLE SUPPLIES 3/8 O.D. BULL-NOSE RISERS Operate LIFT KNOB (1) to verify that STOPPER (2) opens and closes. Note: If STOPPER (2) does not open and close properly then refer to the “troubleshooting section” of these instructions.
2 1 4 1 SERVICE 10 TEST INST ALLED FITTING With HANDLES (1) in OFF position, turn on W A TER SUPPLIES (2) and check all connections for leaks. Remove AERA TOR (3) . Operate both HANDLES (1) to flush water lines thoroughly . Replace AERA TOR (3) . 5 2 CHECK DRAIN CONNECTIONS Operate POP-UP KNOB (4) and fill lavator y with water .
SpeedConnect™ Drain Troubleshooting Guide Disconnect the Cable from the Drain by threading the Cable Connector (1) counter-clockwise. Fig. A. Look at the area on the Drain Body where the Cable was attached and locate the component labeled as “Cam” and “Cam Cap” in the illustration.
STOPPER INSTALLATION PROCEDURE Locked Mode: Look at the Plastic Loop at the bottom of the Stopper and notice that the Loop is on one side of the Stopper.
An important point after buying a device American Standard 7411.732 (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought American Standard 7411.732 yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data American Standard 7411.732 - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, American Standard 7411.732 you will learn all the available features of the product, as well as information on its operation. The information that you get American Standard 7411.732 will certainly help you make a decision on the purchase.
If you already are a holder of American Standard 7411.732, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime American Standard 7411.732.
However, one of the most important roles played by the user manual is to help in solving problems with American Standard 7411.732. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device American Standard 7411.732 along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
