Instruction/ maintenance manual of the product DeskJet 1050A HP
Go to page of 54
HP Deskjet 1050 All-in-One series.
.
Contents 1 How Do I? ............................ ...................................... ................................. ............................ ...3 2 Get to k now the H P All-in-One Printer parts.................................. ............
2 Contents.
1H o w D o I ? Learn how to use your HP Al l-in-One • Printer parts • Copy documents or photos • Load medi a • Replace the cart ridges • Clear a paper jam How Do I? 3 How Do I?.
Chapter 1 4 How D o I? How Do I?.
2 Get to know the HP All-in-One • Printer parts • Control pane l features • Status Lights Printer parts 1 Input tray 2 Paper-width guide for the input tray 3 Control panel 4 Cartridge door 5 Out.
Control panel features ! 1 Power : Turns the product on or off. When the product is off, a minimal amount of power is still used. To completely remove power, turn off the product, then unplug the power cord. 2 Cancel : Stops the cu rrent operation. 3 Start Copy Black : Starts a black-and- white copy job.
Status Lights When the produ ct is turned on, the on bu tton light will be lit. When the prod uct is processing a job, the on light wi ll be blinki ng. Additiona l blinking light s signal errors that you can resolve. Se e below to learn about blinking li ghts and what t o do.
Behavi or Solution Identify a defective cartridge to identify if only one cartridge is a defective. Both cartridge lights and attention light ar e blinking The cartridge carriage inside the printer has stalled.
3P r i n t Choose a print jo b to continue. Print documents Print photos Print envelopes Print documents To print from a software ap plication 1. Make sure the output tray is open. 2. Make sure you have pa per loaded in the inp ut tray. 3. From your software appli cation, click the Print button.
NOTE: You can p rint your document on both sides of t he paper, instea d of just one side. Click on the Adv anced bu tton on t he Paper/Q uality or Layout tab.
NOTE: D o not leave unused phot o paper in the inpu t tray. The paper migh t start to curl, which could reduce the quality of your printout. Ph oto paper should b e flat before printing. Print envelopes You can load one or more envelopes int o the input t ray of the HP Al l-in-One.
Cartridge tips • Use genuine H P ink cartridges. • Install both the black and tri- color cartridges correctly. For more information, see Replace the cartri dges . • Check the estimated ink levels in the cartridges to make sure t here is sufficient ink.
• You can print yo ur document on both sides of the pape r, instead of just one side. NOTE: Click the Advanced button on the Pa per/Qualit y or Layout tab.
Chapter 3 14 Print Print.
4 Paper basics You can load many differen t types and sizes of paper in the HP All-in-One, includin g letter or A4 paper, p hoto paper, transpa rencies, and envel opes.
HP Brochure Paper or HP Sup erior Inkjet Paper These papers are glossy-coated or matte-coat ed on both sides fo r two-sided use. They are the perfect choice for near-photograp hic reproductio ns and business graphi cs for report covers, spe cial presentations, brochures, mailers, and calendars.
Load media ▲ Select a paper si ze to continue. Load full-size pa per a . Raise the input t ray ❑ Raise the inpu t tray. b . Lower the output t ray ❑ Lower the output t ray and pull out the tray extender.
c . Slide paper-width gui de to the left ❑ Slide paper-width guide to the left . d . Load paper. ❑ Insert stack of p aper into input tr ay with short edge forward an d print side up. ❑ Slide stack of paper down un til it stops. ❑ Slide paper-wi dth guide to the ri ght until it stops at edge of paper.
Load small-size paper a . Raise the input t ray ❑ Raise the inpu t tray. b . Lower the output t ray ❑ Lower the output t ray and pull out the tray extender.
c . Slide paper-width gui de to the left . ❑ Slide paper-width guide to the left . d . Load paper. ❑ Insert stack of photo paper wit h short edge down and p rint side up. ❑ Slide stack of paper f orward until it st ops. NOTE: If the photo paper you are using ha s perforated ta bs, load photo paper so that tabs are on top.
Load envelope s a . Raise the input t ray ❑ Raise the inpu t tray. b . Lower the output t ray ❑ Lower the output t ray and pull out the tray extender.
❑ Remove all paper from the main input tra y. d . Load envelopes. ❑ Insert one or mo re envelopes int o far-right side of the input tray. The side to be printed on sho uld face up. The flap should be on t he left side an d facing down. ❑ Slide stack of envel opes down un til it stops.
5 Copy and scan • Copy documents or photos • Scan to a computer • Tips for copy and scan success Copy documents or photos NOTE: All documents are copied in normal quality print mode. You cannot change the print mode quali ty when copying . ▲ Do one of the fo llowing: 1-sided original to 1-sided copy a .
❑ Load original prin t side down on righ t front corner of glass. ❑ Close lid. c . Start cop y. ❑ Press either Start Copy Blac k or Start Copy Color . Increase the number of copies by pressing the butt on multiple t imes. Scan to a computer NOTE: To scan to a computer, the HP All -in-One and computer must be connecte d and turned on.
▲ To scan to a computer: Single pa ge scan a . Load paper. ❑ Load either sm all photo paper or f ull-size paper in the input tray. b . Load orig inal.
❑ Close lid. c . Start sca n. ❑ Start the Scan job using the Printer Software. Click the HP All -in-One desktop icon to open the Pri nter Software. NOTE: Y ou can also access the Prin ter Software by clicking Start > Programs > HP > HP Deskje t 1050 J410 > HP De skjet 1050 J410 ❑ Select Scanner Action s .
6 Work with cartridges • Check the es timated in k levels • Order ink supplies • Replace the cart ridges • Use single-cartrid ge mode • Cartridge warranty information Check the estimated ink levels You can easily check the ink su pply level to determi ne how soon you might ne ed to replace a cartridge.
Order ink supplies Before ordering cartridges , locate the correct cartridge num ber. Locate the cartridge number on the printer ▲ The cartridge n umber is located insid e the cartridge door. Model No. xxxxx HP Ink Cartridge Product No. xxxxxx xx Locate the ca rtridge nu mber in the Pr inter Software 1.
Replace the cartridges To replace the cartri dges 1. Check power. 2. Load paper. 3. Remove cartridge. a . Open cartridge door. Wait for print carriage to move to center of the product .
4. Insert new cartridge. a . Remove cartridge from packaging. b . Remove plastic t ape using pink pull t ab. c . Slide cartridge into slot until it clicks into place.
d . Close cartridge do or. 5. Align cartridges. Related topics • Choose the right cartridges • Order ink supplies Use single-cartri dge mode Use the sing le-cartridge mod e to operate the HP All-in-One with only one prin t cartridge. The single-cartridge mode i s initiated when a pri nt cartridge is remo ved from the print cartridge carriage .
During the warrant y period the produ ct is covered as lon g as the HP ink is not depleted and the end of wa rranty date has not be en reached. The end of warra nty date, in YYYY/ MM/DD format, ma y be found on the produ ct as indicate d: For a copy of the HP Limited Warranty Statement, see th e printe d documenta tion that came with the prod uct.
7 Solve a problem This section contai ns the following topics: • Improve print qu ality • Clear a paper jam • Unable to pr int • HP support Click here to go onli ne for more in formation . Improve print quality 1. Make sure you are using genu ine HP cartridges.
streaks in the color and bl ack boxes, or no ink in porti ons of the boxes, the n automatica lly clean the cartrid ges 6. Clean the print cartridges au tomatically, if t he diagnostic page shows steaks or missing portions of the color and black bo xes.
Clear a paper jam Clear a paper jam. To clear a paper jam 1. Press the cancel button to try to clear the jam automatically . If this does not wo rk, the paper jam will need to be cleare d manually. 2. Locate the paper jam Input tray If the paper jam is loca ted near the back input tra y, pull the paper ge ntly out of the input tray.
Inside of prin ter • If the pape r jam is located insid e the printer, open the cleanout doo r located on the bottom of th e printer. Press tabs on both sid es of the cleanout door. • Remove j ammed paper. • Close the clean out door. Gently pu sh the door towards the printer until b oth latches sn ap into place.
If the above solut ions do not resolve the prob lem, click here for more on line trouble shooting . Unable to print Make sure that the printer is turned on and that there is paper in the tray. If you are stil l unable to print, try the following in order: 1.
c . If the wrong product is set as the default print er, right-click the corre ct product and select Set as Default Printer . d . Try using your produ ct again. 5. Restart the print spooler. To restart the prin t spooler NOTE: HP provides a Printer Diagnostic Utility that can automatical ly fix this issue.
6. Restart the computer. 7. Clear the print queue To clear the print qu eue NOTE: HP provides a Printer Diagnostic Uti lity that can automatically fix this issue. Click here to go onli ne for more informatio n . Othe rwise, follow the ste ps below. a .
lights are still blinki ng, then one or both cartridge s may be defective. To de termine if one cartridge is defecti ve do the f ollowing: 1. Remove black cartridge. 2. Close cartridge door. 3. If th e On light blinks, the tri-co lor cartridge should be repl aced.
• HP support b y phone • Additional w arranty options Register the produ ct By taking just a few quick minute s to register, you can enjoy qu icker service, more efficient support, and product supp ort alerts. If you did not register your printer w hile installing the software, you can register now at http://www.
Placing a call Call HP support while yo u are in front of the co mputer and the pr oduct. Be prepared to provide the following informat ion: • Product name (HP Deskjet 1050 All-in-One series) • Model num ber (located inside t he cartridge doo r) Model No.
8 Technical information The technical specifications and international r egulatory information for the HP All-in-One are provided in this section. For additional specifications, see the printed do cumentation that came with the HP All-in-One.
Envelopes: Up to 5 Index cards: Up to 10 Photo paper sheets: Up to 10 Paper size For a complete list of supported media sizes, see the pr inter software.
Power specifications 0957-2286 • Input voltage: 100-240Vac (+/- 1 0%) • Input frequency: 50/60 Hz (+/- 3Hz) 0957-2290 • Input voltage: 200-240Vac (+/- 1 0%) • Input frequency: 50/60 Hz (+/- 3Hz) NOTE: Use only with the power adapter supplied by HP.
Paper use This product is suited for the use of recycled paper according to DIN 19309 and EN 12281:200 2. Plastics Plastic parts over 25 grams are marked according to international standards that enhance the ability to identify plastics for recycling purposes at the end of product life .
Disposal of waste equipment by users in private households in the European Union Disposal of Waste Equipment by Users in Private Households in the European Union This symbol on the pr oduct or on its packaging indicates that this product m ust not be disposed of w ith your other household w a ste.
1907/2006 of the European Parliament and the Cou ncil) . A chemical information report for this product can be found at: www.hp.com/go/reach . Toxic and hazardous subst ance table Regulatory no tices The HP All-in-One meets product requirements from regulatory agencies in your country/region.
FCC statement FCC sta tement The Unit ed State s F ederal Communi cations Commissi on (in 4 7 CFR 1 5 . 1 05) has s pecifi ed that the follo wing notice be br ought to the attention o f users of this pr oduct.
Notice to users in Japan ab out the power cord HP Deskjet 1050 All-in-One series declaration of confo rmity DECLARATION OF CONFORMITY according to ISO/IEC 17050-1 and EN 17050-1 R V C V : # C o D A -1.
Index A after the support period 42 C copy specifications 44 customer support warranty 42 E environment Environmental product stewardship program 45 environmental specifications 43 P paper recommended.
52 Index.
An important point after buying a device HP DeskJet 1050A (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought HP DeskJet 1050A yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data HP DeskJet 1050A - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, HP DeskJet 1050A you will learn all the available features of the product, as well as information on its operation. The information that you get HP DeskJet 1050A will certainly help you make a decision on the purchase.
If you already are a holder of HP DeskJet 1050A, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime HP DeskJet 1050A.
However, one of the most important roles played by the user manual is to help in solving problems with HP DeskJet 1050A. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device HP DeskJet 1050A along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
