Instruction/ maintenance manual of the product ML115 G5 HP (Hewlett-Packard)
Go to page of 26
Front View: Rear View: 1. DVD-ROM Drive 1. Power Supply Outlet 2. Power LED 2. Rear System Fan 3. Drive Activity LED 3. PCI Slot Cover Lock 4. Front Bezel 4. PCI Slot Covers 5. Full Length Card Retainer 5. HP ProLiant100 G5 Lights-Out 100c Remote Management Card port(Optional) 6.
At A Glance Processor : Quad-Core AMD Opteron™ processors Model 1300 series Dual-Core AMD Opteron™ processors Model 1200 series Dual-Core AMD Athlon™ processors Model 4450B series Single-Core AM.
NOTE: For a brief, printer friendly data sheet that describes this product and informs you of the essential capabilities and specifications, please visit: http://h71028.www7.hp.com/ERC/downloads/4AA1-4557ENW.pdf Processor One of the following depending on Model Quad-Core Processors Quad-Core AMD Opteron™ Processor Model1354 (2.
Expansion Slots # Technology Bus Width Connector Width Bus Number * Device Number Form Factor NOTES 1 PCI 32-bit N/A 1 8 Full height slot 133MHz/3.3V 2 PCI-e X1 X1 4 0 Full height slot 3 PCI-e X8 X8 2 0 Full length, full height slot 4 PCI-e X16 X16 12 0 Full length, full height slot *Default bus assignment (in decimal).
Graphics 32MB shared supporting 1600x1200x16M resolution Form Factor Micro ATX Tower (4U) Remote Management Lights-Out 100c Lights Out LO100c is a family of Remote Management Card (RMC) for ProLiant 100 series servers that do not have embedded LO100i.
Subscriber's Choice Subscriber's Choice Driver and Support Alerts/Notifications is a web- based email subscription service that provides software and driver change notifications for ProLiant products.
Factory Express Portfolio for Servers and Storage HP Factory Express offers configuration, customization, integration and deployment services for HP servers and/or storage products. Customers can choose how their factory solutions are built, tested, integrated, shipped and deployed.
NOTE: For the Standard Features shipped in the "Factory Integrated Models", please see the "Configuration Information - Factory Integrated Models" section.
NOTE: This section lists some of the steps required to configure a Factory Integrated Model. To ensure only valid configurations are ordered, HP recommends the use of an HP approved configurator. Contact your local sales representative for information on CTO product offerings and requirements.
Memory 2 GB Unbuffered PC2-6400 ECC DIMM (1 x 2 GB) 450260-B21 1 GB Unbuffered PC2-6400 ECC DIMM (1 x 1 GB) 450259-B21 512 MB Unbuffered PC2-6400 ECC DIMM (1 x 512 MB) 450258-B21 Hard Drives NOTE: Transfer rates of drives are dependent on the maximum transfer rate supported by the HBA or Controller.
Country Code Key xx=01 Australia xx=03 UK xx=04 Germany xx=05 France xx=06 Italy xx=07 Spanish xx=20 Brazil xx=21 Hungarian xx=22 Czech xx=24 Polish xx=33 Dutch xx=37 AP xx=42 Euro xx=AA PRC xx=29 Jap.
Memory 2 GB Unbuffered PC2-6400 ECC DIMM (1 x 2 GB) 450260-B21 1 GB Unbuffered PC2-6400 ECC DIMM (1 x 1 GB) 450259-B21 512 MB Unbuffered PC2-6400 ECC DIMM (1 x 512 MB) 450258-B21 Optical Drives HP Hal.
Storage Controllers SAS HBA HP SC44Ge Host Bus Adapter NOTE: When using the SC44Ge with SATA Hard Drives, 1.5G SATA Hard Drives are required. Transfer rate: 1.5 Gb/s SATA, 3 Gb/s SAS. NOTE: Supports RAID 0,1. NOTE: Please see the QuickSpecs for Technical Specifications and additional information: http://h18004.
Tape Backup Drives NOTE: Installation of SCSI internal tape drives in a ML115 G5 model requires SCSI controller kit (PN: 412911-B21). NOTE: For complete listing of t ape drive offerings see: http://www.hp.com/products1/storage/compatibility/tapebackup/ISS/index.
Uninterruptible Power Systems - Tower HP T1000 G3 UPS HP T1000 G3 UPS, INTL AF449A HP T1000 G3 UPS, NA/JPN AF448A NOTE: Please see QuickSpecs for Technical Specifications and additional information: http://h18000.www1.hp.com/products/quickspecs/12506_div/12506_div.
Service and Support Offerings (HP Care Pack Services) Extended Care - Minimum recommended service support level Next Business Day On-Site Service, 9-Hour x 5-Day Coverage, 3 Years, Electronic U4433E C.
HP ProLiant ML115 G5 Models NOTE: Memory configurations listed do not apply to "Factory Integrated Models". Standard Memory 512 MB of PC2-6400 DDR2 SDRAM running at 800MHz with ECC capabilities memory installed (1 x 512 MB SDRAM DIMM).
1 Removable Media Bays (1.6" each) 2 DVD-ROM 3, 4, 5, 6 Four (4) Non-Hot Plug Drive Bays Drive Support Quantity Supported Position Supported Controller Removable Media DVD Drive 2 1 or 2 Integrated SATA DVD-RW Drive 2 1 or 2 Integrated SATA Hard Drives (SATA Models only) 3.
400GB 3G SAS 10K 450GB 3G SAS 15K 300GB 3G SAS 15K 146GB 3G SAS 15K Up to 4 3-6 HP 8 Internal Port SAS HBA with RAID (0,1) Maximum Storage Capacity Internal SATA 3.0TB (4 x 750GB) SAS 1.8TB (4x 450GB) Tape Drives and Disk-Based Backup NOTE: Installation of SCSI tape drives in a ML115 G5 model requires SCSI controller kit (PN: 412911-B21).
HP StorageWorks D2D Backup System D2D120 D2D130 External Embedded Network Controller N/A QuickSpecs HP ProLiant ML115 Generation 5 Storage DA - 13013 Worldwide QuickSpecs — Version 10 — 12.
Part Number 416121-001 Spare Kit 419029-001 Operational Input Voltage Range (Vrms) 100 to 127 and 200 to 240 V auto ranging Frequency Range (Nominal) (Hz) 50 to 60 Hz Nominal Input Voltage (Vrms) 100 .
Power ** HP ProLiant ML115 G5 Fully Configured (see ** ) Fully Loaded System output Wattage (W) 365W Fully Loaded System Input Current (A rms) 6A @ 115V, 3A @ 230V Fully Loaded System Thermal (BTU- Hr.
System Unit Dimensions (HxWxD) (with feet) 14.5 x 6.9 x 16.8 in (36.7x 17.5 x 42.6 cm) Weight (approximate) Maximum (all hard drives, power supplies, and processors installed) 31.35 lb (14.22 kg) Minimum (one hard drive, power supply, and processor installed) 25.
L pAm 32.5 dBA Emissions Classification (EMC) FCC Rating Class B Normative Standards CISPR 22; EN55022; EN55024; FCC CFR 47, Pt 15; ICES-003; CNS13438; GB9254; K22;K24; EN 61000-3-2; EN 61000-3-3; EN 60950-1; IEC 60950-1 NOTE: Product conformance to cited product specifications is based on sample (type) testing, evaluation, or assessment.
Interface SATA Access Times (typical) Random <100 ms Full-Stroke <150 ms Data Transfer Rate Sustained 3000 to 7200 KB/s (20X to 48X) Burst 150 KBps to 7,200 KBps Bus Rate 1.
Environment-friendly Products and Approach End-of-life Management and Recycling Hewlett-Packard offers end-of-life HP product return, trade-in, and recycling programs in many geographic areas. For trade-in information, please go to http://www.hp.com/go/green .
An important point after buying a device HP (Hewlett-Packard) ML115 G5 (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought HP (Hewlett-Packard) ML115 G5 yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data HP (Hewlett-Packard) ML115 G5 - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, HP (Hewlett-Packard) ML115 G5 you will learn all the available features of the product, as well as information on its operation. The information that you get HP (Hewlett-Packard) ML115 G5 will certainly help you make a decision on the purchase.
If you already are a holder of HP (Hewlett-Packard) ML115 G5, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime HP (Hewlett-Packard) ML115 G5.
However, one of the most important roles played by the user manual is to help in solving problems with HP (Hewlett-Packard) ML115 G5. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device HP (Hewlett-Packard) ML115 G5 along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
